Page 2 - WARNING
P/N 205932 5/99 2 WARNING FAILURE TO FOLLOW THESE WARNINGS MAY RESULT IN SERIOUS INJURY AND/OR PROPERTY DAMAGE. Owner must ensure that all players know and follow these rules for safe operation of the system. • DO NOT HANG on the rim or any part of the system including backboard, support braces or n...
Page 5 - NOTE: Two people recommended for this step.
5/99 P/N 5 P/N 205932 5/99 5. Install rod (8) thru holes in bottom pole section (3)and eyebolt (7) as shown. 7 7. 9 Pole 12 Bring pole foward and secure pole to front panel (4) at 34” (86.4 cm) mark on pole. Tighten nuts evenly untilsnug. NOTE: Equal rotations on each side of u-bolt are necessary. (...
Page 7 - mounting nuts and bolts supplied with rim hardware.
5/99 P/N 205932 7 P/N 205932 5/99 14 36 33 33 34 34 32 Assemble rim bracket (30). Tighten completely. 14. 30 KEYHOLE SLOT 31 37 30 35 34 Start with nuts (34) flush against bracket (14), secure rimassembly and bracket (14) to backboard. NOTE: Rim mounting nuts and bolts supplied with rim hardware. Be...
Page 8 - Then
8 P/N 205932 5/99 Assemble elevator tubes (23) to backboard bracket. 28 25 23 23 14 24 25 Support pole on sawhorse. Attach backboardassembly to top pole section (1). NOTE: Two people are recommended for this step, usecaution, elevator assembly is heavy. Then install pole cap (40). 40 39 1 18. 28 39 ...
Page 9 - NON-TOXIC ANTIFREEZE
5/99 P/N 9 P/N 205932 5/99 20. Install rim to backboard. 12 44 36 46 36 45 Slide Spacer and Bolt Through Bracket 42 43 Roll completed assembly to desired position, fill base with 25 gallons (95 liters)of water or approx. 300-325 lbs. of sand andsnap cap (41) in place. Secure assembly toground using ...
Page 10 - Outside View; MAKE SURE NET IS HELD; Inside View
10 P/N 205932 5/99 48 36 Install bolt (48) and adjust to levelrim. 22. Use Caution Not To Cross-Thread Bolt Push Down to Start Bolt Adjust bolt (48) to level rim. 23. 24. a. The two outer hooks on the clip must face towards inside of goal rim. Insert thelarger hole in clip onto rim stud, then slide ...
Page 11 - pivot toward pole; Adjusting the Height to any of the Seven Positions
5/99 P/N 11 HUFFY HUFFYS PORTS 10 feet (3.05m) REGULATION RIM HEIGHT IS 10 FEET (3.05M). (10 fot) i NBA. P/N 205932 5/99 Apply logo label (51). Then snap cover(37) closed. 37 51 25. Insert the end of a broom handle orwooden dowel 3/4”-7/8” (19-22 mm)diameter into the release lever. 26. IMPORTANT! Pu...
Page 12 - NOTE: Equal rotations on each side of u-bolt
12 P/N 205932 5/99 Make final adjustments to level the rim. If the backboard andrim are tipped back, raise front panel (4) until level and tightencompletely. NOTE: Equal rotations on each side of u-bolt are necessary. If backboard and rim are tipped forward, lower front panel (4)until level and tigh...
Page 13 - PARTS LIST; YOU MAY HAVE EXTRA PARTS WITH THIS MODEL.
5/99 P/N 13 P/N 205932 5/99 PARTS LIST Item Qty. Part No. Description 1 1 982416 Top Pole Section, (Black) 2 1 902415 Middle Pole Section, (Black) 3 1 952415 Bottom Pole Section, (Black) 4 1 202422 Front Panel 5 1 202420 Base 6 1 202475 Tank 7 1 202446 Eyebolt 3/8-16 x 4-3/4 Long 8 1 202428 Rod, 1/2...
Page 14 - YOU MAY
P/N 205932 5/99 14 5/99 P/N 205932 Item #13 (1) Item #21 (1) Item #22 (1) Item #20 (1) Item #24 (5) Item #38 (1) Item #26 (1) HARDWARE IDENTIFIER (CONTINUED) Item #28 (6) Item #33 (2) Item #25 (4) Item #34 (6) Item #17 (2) Item #35 (4) Item #36 (5)* Item #46 (1) Item #48 (1) * YOU MAY HAVE EXTRA PAR...