Page 2 - WARNING
2 P/N 214477 03 03/04 WARNING FAILURE TO FOLLOW THESE WARNINGS MAY RESULT IN SERIOUS INJURY AND/OR PROPERTY DAMAGE. Owner must ensure that all players know and follow these rules for safe operation of the system. • DO NOT HANG on the rim or any part of the system including backboard, support braces ...
Page 3 - SAFETY INSTRUCTIONS
03/04 P/N 214477 03 3 IMPORTANT! Remove all contents from boxes. Be sure to check inside pole sections; hardware and additional parts are packed inside. NOTICE TO ASSEMBLERS ALL Huffy Sports basketball Systems, including those used for DISPLAYS, MUST be assembled and ballasted with sand or water acc...
Page 5 - Item Qty
03/04 P/N 214477 03 5 Item Qty Part No. Description 1 1 908026 Top Pole Section 2 1 908107 Middle Pole Section (with Label) 3 1 908015 Bottom Pole Section 4 1 900223 Wheel Bracket 5 1 206940 Axle 6 2 226403 Wheel 7 2 206938 Pushnut 8 1 206660 Base 9 6 203156 Hex Bolt, 5/16-18 x 1 10 18 203218 Flat W...
Page 8 - any excess paint from holes if necessary.
8 P/N 214477 03 03/04 BEFORE YOU START! To ensure optimal playability of backboard system, a close tolerance fit between the elevator components and hardware is required. Test fit large bolts into large holes of elevator tubes, backboard brackets and triangle plates. Carefully rock them in a circula...
Page 9 - ASSEMBLE THE POLES; Pole Identification Sticker; reference point in the next step.; Pole
03/04 P/N 214477 03 9 SECTION A: ASSEMBLE THE POLES 2. WARNING LABEL 2 1 3 Pole Identification Sticker Pole Identification Sticker 1. Correctly identify each pole section. Poles have an identification sticker that will be used as a reference point in the next step. WOOD SCRAP (NOT SUPPLIED) 2 1 Pole...
Page 11 - ASSEMBLE THE BASE; a Hammer or
03/04 P/N 214477 03 11 TOOLS REQUIRED FOR THIS SECTION HARDWARE USED IN THIS SECTION (not actual size) SECTION B: ASSEMBLE THE BASE This is what your system will look likewhen you’ve finished this section: a Hammer or Mallet (2) 1/2” AND (2) 9/16" Wrenches 9/16” 1/2” AND/OR (2) Socket Wrenches a...
Page 15 - ASSEMBLE THE ELEVATOR & BACKBOARD; Wrenches
03/04 P/N 214477 03 15 TOOLS REQUIRED FOR THIS SECTION HARDWARE USED IN THIS SECTION (not actual size) SECTION C: ASSEMBLE THE ELEVATOR & BACKBOARD This is what your system will look likewhen you’ve finished this section: 9/16” 1/2” 3/4” (2) 1/2”, (2) 9/16"” AND (2) 3/4” Wrenches AND/OR (2) ...
Page 18 - Face of Backboard
18 P/N 214477 03 03/04 Insert handle assembly through pole mount assembly asshown. Lock pole assembly in place at the 10’ (3.05 m)mark with pin (27). 27 5 . 6. 30 30 29 29 31 45 Assemble backboard brackets (45)using spacers (30), bolts (29), andnuts (31) as shown. 31 45 30 31 29 Face of Backboard IM...
Page 19 - Rim mounting nuts and bolts supplied with rim hardware.
03/04 P/N 214477 03 19 7. 50 48 49 45 21 Refer To Instructions Included With Rim Hardware For Rim Assembly. Attach lower elevator tubes (34) and counter balance spring (48) to backboardsupport brackets (45) using spacers (46 & 49), bolt (50), and nut (21) as shown. NOTE: Rim mounting nuts and bo...
Page 21 - Two people are recommended for this
03/04 P/N 214477 03 21 21 21 47 25 34 1 32 32 50 20 34 20 9. Support pole on sawhorse. Attach backboard assembly to top pole section (1)as shown. Install pole cap (25). NOTE: Two people are recommended for this step. Use caution; elevator assembly is heavy. 50 33 20 21 1 21 33 20 32 51 10. Install u...
Page 23 - SECURING THE SYSTEM
03/04 P/N 214477 03 23 1. SECTION D: SECURING THE SYSTEM Roll assembly to desired playing area. Secureassembly to ground using rope (56) and tie down stake(36). Fill base (8) with water (approx. 40 gallons) andsnap fill caps (37) in place. 56 36 37 8 37 DO NOT LEAVEASSEMBLY UNATTENDEDWHEN EMPTY; IT ...
Page 24 - INSTALL FRONT COVER; STANDOFFS
24 P/N 214477 03 03/04 SECTION E: INSTALL FRONT COVER 1. Install front cover (38) by lining up stand-offs along the tank struts. Insert a tie strap(39) through the top two and bottom two stand offs. Wrap tie straps around tankstruts as shown and secure tightly. Trim excess of tie strap as shown in F...
Page 25 - NET INSTALLATION; CLIP “ARM”; Push second “arm” back and into ram as shown.
03/04 P/N 214477 03 25 SECTION F: NET INSTALLATION 1. Install clips. CLIP “ARM” CLIP “BODY” Insert one “arm” of clip into ram as shown. Twist “body” ofclip slightly so that second “arm” slides over the top of thefirst “arm” as shown.Push in direction indicated by arrows. Push second “arm” back and i...
Page 26 - Insert net into bottom of clip as shown.
26 P/N 214477 03 03/04 Insert net into bottom of clip as shown. SIDE VIEW Twist net until it snaps into position.Net must be centered through clip. NET NETCLIP SIDE VIEW NET NETCLIP 2. 40 57 58
Page 27 - APPLY HEIGHT AND MOVING LABEL
03/04 P/N 214477 03 27 2 2 1 3 TO ADJUST BACKBOARD: 1. While holding handle, remove pin. 2. Move elevator up or down to desired height. 3. Replace pin full length to lock system at desired height. 201252 2/99 1 2 4 3 MOVING SYSTEM 1. Adjust basketball backboard height to lowest position. 2. While ho...
Page 28 - HEIGHT ADJUSTMENT; Move elevator up or down to desired height.; DO NOT ALLOW
28 P/N 214477 03 03/04 SECTION H: HEIGHT ADJUSTMENT 1. A. While holding handle, remove pin (27). B. Move elevator up or down to desired height. C. Replace pin (27) full length to lock system at desired height. 27 A. B. C. 51 DO NOT ALLOW CHILDREN TOADJUST HEIGHT. WARNING!
Page 29 - Système portable; Tragbares System; Sistema portátil; FRANÇAIS
29 03/04 P/N 214477 03 Numéro sans frais du service clientèle (États-Unis) : 1-800-558-5234 ; Canada : 1-800-284-8339 ; Europe : 00 800 555 85234 (Suède : 009 555 85234), Pour l'Australie : 1-800-333 061 - Site Internet : http://www.huffysports.com Gebührenfreie Kundendienstnummer für Anrufer in den...
Page 30 - VORBEREITENDE MASSNAHMEN
30 P/N 214477 03 03/04 AVANT DE COMMENCER! VORBEREITENDE MASSNAHMEN ¡ANTES DE COMENZAR! Pour garantir l'utilisation optimale du panneau, les composants du système élévateur et la visserie doivent être bien ajustés (serrés). À titre d'essai, insérez les gros boulons dans les gros trous des tubes du s...
Page 31 - VERTISSEMENT; ADVERTENCIA; ARNUNG
03/04 P/N 214477 03 31 SUIVEZ CES AVERTISSEMENTS SOUS PEINE DE PROVOQUER DES BLESSURES GRAVES ET/OU DES DEGATS MATERIELS. Le propriétaire du système doit s’assurer que tous les joueurs connaissent et suivent ces consignes d’utilisation sûre du système. • NE VOUS SUSPENDEZ PAS sur le cerceau ou sur t...
Page 32 - SICHERHEITSHINWEISE; ¡INSTRUCCIONES DE SEGURIDAD!; CONSIGNES DE SÉCURITÉ !
32 P/N 214477 03 03/04 SICHERHEITSHINWEISE EIN MISSACHTEN DIESER SICHERHEITSHINWEISE KANN ZU SCHWEREN VERLETZUNGEN UND/ODER SACHSCHÄDEN FÜHREN UND MACHT DIE GARANTIE UNWIRKSAM.. Der Eigentümer muss sicherstellen, dass alle Spieler diese Regeln für einen sicheren Betrieb des Systems kennen und befolg...
Page 34 - LISTE DES PIÈCES
34 P/N 214477 03 03/04 FRANÇAIS LISTE DES PIÈCES TEILELISTE Légende Quantité No de réf. Description 1 1 908026 Section de poteau supérieure 2 1 908107 Section de poteau centrale (avec étiquette) 3 1 908015 Section de poteau inférieure 4 1 900223 Support des roues 5 1 206940 Axe 6 2 226403 Roue 7 2 2...
Page 35 - LISTA DE PIEZAS
03/04 P/N 214477 03 35 LISTA DE PIEZAS Artículo Cant. Pieza N.º Descripción 1 1 908026 Sección superior del poste 2 1 908107 Sección media del poste (con etiqueta) 3 1 908015 Sección inferior del poste 4 1 900223 Soporte de la rueda 5 1 206940 Eje 6 2 226403 Rueda 7 2 206938 Tuerca dentada 8 1 20666...
Page 37 - IDENTIFICADORES DEL HERRAJE (ESPACIADORES DE PLÁSTICO Y TAPAS); MOVING SYSTEM
03/04 P/N 214477 03 37 IDENTIFICATION DES PIÈCES (ENTRETOISES ET CAPUCHONS EN PLASTIQUE) BEFESTIGUNGSTEILESCHLÜSSEL (PLASTIK-ABSTANDSSTÜCKE UND KAPPEN) IDENTIFICADORES DEL HERRAJE (ESPACIADORES DE PLÁSTICO Y TAPAS) #42 (1) 2 2 1 3 TO ADJUST BACKBOARD: 1. While holding handle, remove pin. 2. Move ele...
Page 40 - SECTION B : MONTAGE DU SOCLE
40 P/N 214477 03 03/04 OUTILS REQUIS POUR CETTE SECTION FÜR DIESEN BAUABSCHNITT BENÖTIGTES WERKZEUG HERRAMIENTAS REQUERIDAS PARA ESTA SECCIÓN VISSERIE UTILISÉE DANS CETTE SECTION (pas à l'échelle) IN DIESEM BAUABSCHNITT BENUTZTE BEFESTIGUNGSTEILE (die Abbildungen entsprechen nicht der tatsächlichen ...
Page 53 - SÉPARATEURS
03/04 P/N 214477 03 53 SECTION E : INSTALLATION DU PROTECTEUR AVANT BAUABSCHNITT E: FRONTABDECKUNG ANBRINGEN SECCIÓN E: INSTALE LA CUBIERTA FRONTAL 1. Installez le protecteur avant (38) en alignant les séparateurs le long des contrefiches de réservoir. Insérez uneattache (39) dans les deux séparateu...
Page 55 - SECTION G : POSE DE L'ÉTIQUETTE DE HAUTEUR ET DE DÉPLACEMENT
03/04 P/N 214477 03 55 2 2 1 3 TO ADJUST BACKBOARD: 1. While holding handle, remove pin. 2. Move elevator up or down to desired height. 3. Replace pin full length to lock system at desired height. 201252 2/99 1 2 4 3 MOVING SYSTEM 1. Adjust basketball backboard height to lowest position. 2. While ho...