Huawei HG532 - Manual

1 Safety Precautions Thank you for purchasing the EchoLife HG532 Home Gateway (hereinafter referred to as the HG532). To use the device properly and safely, read these warnings and precautions carefully and strictly observe them during operation. Unless otherwise specified, the term "device"...

Maintenance z If the device is not used for a long time, power it off, and then remove all the cables connected to it. z If any exception occurs, for example, if the device emits any smoke or unusual sound or smell, stop using the device immediately, power it off, remove all the cables connected to ...

2 Connecting the Cables and Getting Started 2.1 Simple Connection If your telephone line is used for the broadband network access only and do not need to use a telephone, take the following figure as a reference for connecting the cables. 1 2 3 POWER LAN4 LAN3 LAN2 LAN1 USB RESET ADSL 1. Telephone j...

2.2 Connecting One Telephone If your telephone line is used for both the broadband network access and a telephone connection, take the following figure as a reference for connecting the cables. # ### ## ## ## ## 1 3 4 5 PHONE LINE MODEM 2 POWER LAN4 LAN3 LAN2 LAN1 USB RESET ADSL 1. Telephone jack on...

# # # # # # # # # # # # 1 3 4 5 PHONE LINE MODEM 2 POWER LAN4 LAN3 LAN2 LAN1 USB RESET ADSL 1 7 6 5 7 8 1. Telephone jack on the wall 2. Splitter 3. Power adapter 4. Computer 5. Telephone 6. Fax machine 7. Microfilter 8. T connector 2.4 Getting Started Press down the ON/OFF button on the side of the...

3 Setting the Network-Access Parameters The HG532 supports ADSL2+ uplink and High-Speed Packet Access (HSPA) uplink through Huawei HSPA data card. Realizes dynamic mutual backup of voice and data services through the DSL link and HSPA link. 3.1 Configuring the HSPA uplink When the HG532 is working t...

3.2 Configuring the ADSL uplink By configuring the HG532 and your computer, you can choose any of the following methods to surf the Internet: z Accessing the Network Through the Embedded PPP Dial-Up Software on the HG532 z Accessing the Network Through the PPP Dial-Up Software on Your Computer Acces...

If the WPS indicator does not blink, it indicates that the WPS function cannot be enabled. Note that the WPS function can be used only when the wireless network function is enabled and the wireless network security mode of the WLAN is set to WPA-PSK or WPA2-PSK. Setting Up a Wireless Connection Manu...

1. Choose Start > All Programs > Accessories > Communications > Network Connections . 2. In the Network Connections window, right-click Wireless Network Connection to display a shortcut menu, and then select View Available Wireless Networks from the shortcut menu. 3. In the Wireless Netw...

6 FAQs How can I quickly enable or disable the wireless network function? Press and hold the WLAN button for over one second, and then release the button to enable or disable the wireless network function. The WLAN indicator shows whether the wireless network function is enabled. How can I quickly r...

After a broadband terminal is installed, does Internet access degrade call quality or do telephone calls lower the Internet access rate? No. The terminal uses the frequency division multiplexing (FDM) and splitter technologies to separate voice signals from data signals. Although the two types of si...

Indicator Status Description Blinking The HG532 is attempting to set up a wireless connection with a wireless client (such as a PC on which a wireless network adapter is installed) through the WPS function. This state lasts no more than 120s. On A wireless connection is set up between the HG532 and ...