Page 2 - Notice
Notice Copyright © 2004 by Hewlett-Packard. All rights reserved. No part of this publication may be reproduced, transmitted, transcribed, stored in a retrieval system or translated into any language or computer language, in any form or by any means, electronic, mechanical, magnetic, optical, chemica...
Page 3 - Table of Contents; User’s Guide
Table of Contents 3 Table of Contents User’s Guide Introduction . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 5 Safety Instructions . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .5 Shipping Contents . . ....
Page 5 - INTRODUCTION; Warning; Save this user’s guide; : The information contained in this manual will assist you in
Introduction 5 User’s Guide INTRODUCTION Warning TO PREVENT SHOCK, DO NOT OPEN THE CABINET. NO USER –SER-VICEABLE PARTS INSIDE. REFER SERVICING TO QUALIFIED SERVICE PERSONNEL. PLEASE READ THIS USER’S GUIDE BEFORE YOU OPER-ATE YOUR PROJECTOR. SAVE THIS USER’S GUIDE FOR FUTURE REF-ERENCE . Safety Inst...
Page 6 - Shipping Contents
Introduction 6 User’s Guide Shipping Contents The projector is shipped with the cables required for connection to standard PC or laptop computers. Carefully unpack and verify that you have all the items shown below. If any of these items are missing, please contact personnel at the place of purchase...
Page 7 - Projector Description; Projector
Introduction 7 User’s Guide Projector Description Projector External control panel (see next page) Audio/ Video connector Projection lens Audio jack Front adjuster USB mouse connector IR remote sensor S-Video jack Ventilation grill RS 232 control port Speaker Rear adjuster feet Focus and zoom adjust...
Page 8 - External Control Panel
Introduction 8 User’s Guide External Control Panel Power Turns the projector on or off. Auto Sync Automatically determines the best picture settings for current received signals. < > ^ v Menu Menu displays the menu system and closes the menu system. < and > navigate among menus and chang...
Page 9 - Adjuster
Introduction 9 User’s Guide Adjuster The projector is equipped with 2 quick-release adjuster feet. Push the buttons to adjust its tilt angle. 1. Lift the projector up and press the adjuster button to release the adjuster. 2. The adjuster will drop into position and be locked. Projector Features The ...
Page 10 - Remote Control Description; Remote Control Effective Range
Introduction 10 User’s Guide Remote Control Description Remote Control Effective Range The remote sensors are located on the front and the back of the projector. It can function in a range of 30 degrees horizontally and 30 degrees vertically relative to a line that is a right angle to the remote sen...
Page 11 - Replacing the Battery; Caution
Introduction 11 User’s Guide Replacing the Battery Caution Avoid excessive heat and humidity. There may be danger of an explosion if batteries are incorrectly replaced. Replace only with the same or equivalent type recommended by the manufacturer. Dispose of used batteries accord-ing to the manufact...
Page 12 - INSTALLATION; Screen Size; Projection Distance
Installation 12 User’s Guide INSTALLATION Screen Size Place the projector at the required distance from the screen according to the desired picture size (see the table below). • VP6120, VP6121 (XGA) screen size chart Projection Distance Distance from screen Diagonal measurement Distance from screen ...
Page 13 - Connecting to Various Equipment; HDTV Equipment
Installation 13 User’s Guide • VP6110, VP6111 (SVGA) screen size chart Connecting to Various Equipment The internal speaker is good for a small audience. If you have a larger audience, you may want to connect the audio source directly to a separate sound system instead of the projector. HDTV Equipme...
Page 14 - Computer
Installation 14 User’s Guide Connecting to Various Equipment It only takes a few seconds to connect your projector to your desktop or notebook computer, VCR, or other systems. However, a Mac adapter is needed for connection to Macintosh computers. 1. Computer The USB cable is not needed unless you h...
Page 16 - OPERATION; Start Up; POWER
Operation 16 User’s Guide OPERATION Start Up 1. Plug the power cord into the projector and into a wall socket. 2. Turn on the main power switch. 3. Press and hold POWER to start the unit. The back-lit POWER key flashes blue and stays blue when the power is turned on. (When the power is turned off, t...
Page 17 - Digital Keystone Correction; either the top or bottom. To correct this, press KEYSTONE; Auto Adjustment
Operation 17 User’s Guide Digital Keystone Correction Keystoning refers to the situation where the projected image is noticeably wider at either the top or bottom. To correct this, press KEYSTONE / (hot key) on the control panel of the projector or on the remote control, and then adjust the sliding ...
Page 18 - Source Selection; Menu
Operation 18 User’s Guide Source Selection When several input sources are available, press the SOURCE key to make a selection from the remote control or from the menu system. Video and Audio Adjustments -- the Menu System 1. On the projector or remote control, press the Menu button. 2. Press < or...
Page 19 - Quick Tab; FUNCTION; Selects picture source.; Keystone; Corrects slanted edges of the image.; Picture; Adjusts picture for type of input.; Aspect ratio; Selects proportions of the image.
Operation 19 User’s Guide Quick Tab FUNCTION DESCRIPTION Source Selects picture source. *The operation of this function depends on the Source Scan setting. Keystone Corrects slanted edges of the image. Picture mode Adjusts picture for type of input. Auto-sync Synchronizes with input signal. Aspect r...
Page 20 - Adjust Tab
Operation 20 User’s Guide Adjust Tab FUNCTION DESCRIPTION Brightness Brightens or darkens the image. Contrast Sets difference between light and dark areas. Frequency Adjusts timing relative to input signal. *This function is available only when the input source is PC . Tracking Adjusts synchronizati...
Page 21 - Audio Tab; Changes loudness of audio; Treble; Changes loudness of higher frequencies.; Bass; Changes loudness of lower frequencies.
Operation 21 User’s Guide Audio Tab FUNCTION DESCRIPTION Mute Stops audio output. Volume Changes loudness of audio Treble Changes loudness of higher frequencies. Bass Changes loudness of lower frequencies.
Page 22 - Setup Tab
Operation 22 User’s Guide Setup Tab FUNCTION DESCRIPTION Language Selects language for menus. Use < / > key to select the desired lan- guage. Position Adjusts the image to match the projector placement. Source scan Sets whether projector searches for input signal. OSD position Selects position...
Page 23 - PIP Tab; Brightens or darkens the image.
Operation 23 User’s Guide PIP Tab These functions are available only when the input source is PC and a video or S-video source is also connected. FUNCTION DESCRIPTION Source Selects an input source for the picture-in-picture. Size Selects the size of the pic-ture-in-picture. Use < / > key to s...
Page 24 - Shutdown
Operation 24 User’s Guide Shutdown 1. Press and hold POWER and a warning message will appear. To turn off the projector, press POWER again. 2. The fan will continue to run for approximately two minutes. 3. Turn off the main power switch. 4. Disconnect the power cord from the wall socket. Caution Ple...
Page 25 - MAINTENANCE; Lamp Information; Lamp LED Indicator; Lamp LED is off; Lamp is operating normally.; Lamp LED is on
Maintenance 25 User’s Guide MAINTENANCE Lamp Information Lamp LED Indicator Lamp Replacement When the Lamp Indicator lights up red or a message appears suggesting the time of lamp replacement, please install a new lamp or consult your dealer. An old lamp could cause a malfunction in the projector an...
Page 26 - Do not turn on the
Maintenance 26 User’s Guide 1. Turn off the projector. Disconnect thepower cord from the outlet and theprojector. 2. Loosen the screw and remove thelamp cover. If the lamp is hot, avoidburns by waiting 45 minutes until thelamp has cooled. 3. Loosen the 3 screws. (It is stronglyrecommended that you u...
Page 27 - Temperature Warning Indicator; Status
Maintenance 27 User’s Guide Temperature Warning Indicator Accessories You can buy HP accessories for your projector, such as the following:• Carrying case • Premium remote control (plus USB cable) • Ceiling mount • 60-inch mobile screen • Replacement lamp module • Video and power cables Status Descr...
Page 28 - TROUBLESHOOTING; Common Problems & Solutions
Troubleshooting 28 User’s Guide TROUBLESHOOTING Common Problems & Solutions PROBLEMS TRY THESE SOLUTIONS NO POWER • Make sure the power cord is inserted fully into the power cord socket. • Make sure the power cord is inserted fully into the power outlet. • Toggle the power switch to the position...
Page 29 - Status Messages; Projector is searching for input.
Troubleshooting 29 User’s Guide Status Messages On-Screen Messages Description SEARCHING Projector is searching for input. ACQUIRING SIGNAL Projector has identified the input signal and is running the auto image adjustment function. OUT OF RANGE Input signal frequency exceeds the projector’s range. ...
Page 30 - SPECIFICATIONS; Projector Specifications; Technical Specifications; Note: All specifications are subject to change without notice.; Electrical; Mechanical; Output
Specifications 30 User’s Guide SPECIFICATIONS Projector Specifications Technical Specifications Note: All specifications are subject to change without notice. General Model name VP6120, VP6121 (XGA) VP6110, VP6111 (SVGA) Optical Display system 1-CHIP DMD Lens F/Number F/2.6 Lamp 200W ~ 250W lamp Ele...
Page 31 - Timing Chart; Resolution
Specifications 31 User’s Guide Timing Chart Resolution H Sync (kHz) V Sync (Hz) Remark 640x350 31.5 70.1 640x400 37.9 85.1 VESA 720x400 31.5 70.0 720x400 37.9 85.1 VESA 640x480 31.5 60.0 VESA 640x480 37.9 72.8 VESA 640x480 35 66.7 Macintosh 640x480 43.3 85.0 VESA 800x600 35.2 56.3 VESA 800x600 37.9 ...
Page 32 - DIMENSIONS
Dimensions 32 User’s Guide DIMENSIONS Unit: mm 307.5 307.5 242.23242.23 109.46 109.46
Page 33 - REGULATORY AND SAFETY; LED Safety; Connections to Peripheral Devices.; How
Regulatory and Safety 33 User’s Guide REGULATORY AND SAFETY This section presents information that shows how your digital projector complies with regulations in certain regions. Any modifications to your digital projector not expressly approved by Hewlett-Packard could void the authority to operate ...
Page 34 - Canada; This Class B digital apparatus complies with Canadian ICES-003.; Japan
Regulatory and Safety 34 User’s Guide to Identify and Resolve Radio-TV Interference Problems . This booklet is available from the U.S. Government Printing Office, Washington, DC 20402, Stock Number 004-000-00345-4. At the first printing of this manual, the telephone number was (202) 512-1800. Canada...
Page 35 - European Union; NOTE
Regulatory and Safety 35 User’s Guide European Union NOTE : For regulatory identification purposes, your product is assigned a Regulatory Model Number. The Regulatory Model Number for your product is listed in the declaration below. This regulatory number is different from the marketing name and pro...
