HP 8753ES - Manual

HP 8753ES

HP 8753ES – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.

1 Page 1
2 Page 2
3 Page 3
4 Page 4
5 Page 5
6 Page 6
7 Page 7
8 Page 8
9 Page 9
10 Page 10
11 Page 11
12 Page 12
13 Page 13
14 Page 14
15 Page 15
16 Page 16
17 Page 17
18 Page 18
19 Page 19
20 Page 20
21 Page 21
22 Page 22
23 Page 23
24 Page 24
25 Page 25
26 Page 26
27 Page 27
28 Page 28
Page: / 28

Table of Contents:

  • Page 2 – Table of contents
  • Page 3 – Definitions and test conditions; Dynamic range
  • Page 4 – System performance summaries; Configuration; Network analyzer; System dynamic range; GHz to 6 GHz; Reflection uncertainty; Transmission uncertainty; Measurement port characteristics
  • Page 10 – MHz at nominal frequency
  • Page 11 – Test port input characteristics (continued); Maximum; Phase characteristics
  • Page 12 – Test port output characteristics; nominal; Test port input characteristics Option 011; 0 ohms nominal
  • Page 13 – Maximum spurious
  • Page 15 – Magnitude characteristics
  • Page 16 – Measurement; Four display channels available.; Group delay characteristics; selectable; Source control; Set sweep time in seconds, minutes or hours.
  • Page 17 – The IF bandwidth is selectable from 6 kHz to 10 Hz; Display control
  • Page 18 – Automatic
  • Page 19 – Test sequences; This stimulus is also used to measure low-pass devices.; Remote programming
  • Page 20 – General characteristics; dBm minimum
  • Page 21 – Environmental characteristics; General conditions; Measurement throughput summary; Number of Points; Conversion; Options
  • Page 22 – Test set specifications for Option 011
  • Page 23 – Specifications
  • Page 24 – Accessories; Calibration kits
  • Page 25 – Description
  • Page 28 – 5 dB minimum; Dimensions
Loading the manual

specifications

8 7 5 3 E T/ E S

N e t w o r k A n a l y z e r s

HP 8753ET and 8753ES Network Analyzers
30 kHz to 3 or 6 GHz

This document describes the performance
and features of the following products:

HP 8753ES S-parameter vector network analyzer
HP 8753ES Option 011 vector network analyzer without test set
HP 8753ET Transmission/reflection vector network analyzer

For more information about these analyzers, please see the following documents:

HP literature number

HP 8753ET and 8753ES Network Analyzers

Brochure

5968-5159E

HP 8753ET and 8753ES Network Analyzers

Configuration Guide

5968-5158E

"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.

Summary

Page 2 - Table of contents

2 Table of contents Definitions and test conditions . . . . . . . . . . . . . . . . . . . . . . . . . . . . .3System performance summaries . . . . . . . . . . . . . . . . . . . . . . . . . . . .4Specifications and characteristics . . . . . . . . . . . . . . . . . . . . . . . . . . .10Measurement thr...

Page 3 - Definitions and test conditions; Dynamic range

3 Definitions and test conditions Specifications describe the instrument's warrantedperformance after a half-hour warm-up and over thetemperature range of 25 ˚C ± 5 ˚C, unless otherwisestated. Specifications for frequencies above 3 GHz donot apply to instruments with Option 075 (75-ohmimpedance). Su...

Page 4 - System performance summaries; Configuration; Network analyzer; System dynamic range; GHz to 6 GHz; Reflection uncertainty; Transmission uncertainty; Measurement port characteristics

4 System performance summaries HP 8753ES (50-ohm systems) 7-mm test ports Configuration Network analyzer HP 8753ES Standard and Option 006 Calibration kit HP 85031B Test-port cables HP 11857D System dynamic range 30 kHz to 50 kHz 70 dB 1 50 kHz to 300 kHz 90 dB 1 300 kHz to 16 MHz 100 dB 16 MHz to 3...

Other HP Models

All HP Other