HP 2310EI - Manual

2 Safety and Maintenance Guidelines Important Safety Information A power cord is included with the monitor. If another cord is used, use only a power source andconnection appropriate for this monitor. For information on the correct power cord set to use with themonitor, refer to the "Connecting ...

3 Setting Up the Monitor Unpacking the Monitor 1. Unpack the monitor. Make sure all contents are included. Store the packing box. 2. Turn off the computer and other attached devices. 3. Prepare a flat area to assemble the monitor. You may need a flat, soft, protected area for placingthe monitor scre...

Connecting Monitor Cables CAUTION: Before connecting cables to the monitor, ensure that the computer and monitor are powered off. The video source is determined by the video cable used. The monitor will automatically determinewhich inputs have valid video signals. The inputs can be selected by press...

Connecting the Power Cord 1. Follow all electrical and power warnings WARNING! To reduce the risk of electric shock or damage to your equipment: Do not disable the power cord grounding plug. The grounding plug is an important safetyfeature. Plug the power cord into a grounded (earthed) electrical ou...

Turning on the Monitor 1. Press the power button on the computer to turn it on. 2. Press the power button on the front of the monitor to turn it on. CAUTION: Burn-in image damage may occur on monitors that display the same static image on screen for a prolonged period of time.* To avoid burn-in imag...

2. Adjust the tilt by moving the top edge of the monitor either toward or away from you, withouttouching the screen. Figure 3-7 Tilt Adjustment Adjusting the Swivel The monitor allows a usable range of motion with the swivel feature. Figure 3-8 Swivel Adjustment CAUTION: To avoid breakage or other d...

4 Operating the Monitor CD Software and Utilities The CD that is included with this monitor contains drivers and software that you can install on yourcomputer. Installing Drivers If you determine that you need to update the drivers, you can install the monitor driver INF and ICMfiles from the CD, or...

Icon Main Menu Options Sub-menu Options Description Source Control Selects the video input signal. thefactory default by priority is DisplayPort,DVI, then HDMI. DVI Selects DVI as the video input signal. HDMI (2310e model) Selects HDMI as the video input signal. DisplayPort Selects DisplayPort as th...

A Troubleshooting Solving Common Problems The following table lists possible problems, the possible cause of each problem, and therecommended solutions: Problem Solution Power LED is not on. Make sure the Power button is on, and the power cord is properly connected to a groundedpower outlet and to t...

Problem Solution No Plug and Play. In order for the Plug and Play feature of the monitor to work, you need a computer andgraphic card that are compatible with Plug and Play. Check with your computermanufacturer. Check the monitor's video cable, and make sure that none of the pins are bent. Make sure...

Locating the Rating Label The rating label on the monitor provides the product number and serial number. You may need thesenumbers when contacting HP about your monitor model. The rating label is on the back of the monitor. ENWW Locating the Rating Label 23

B Technical Specifications All specifications represent the typical specifications provided by HP's component manufacturers;actual performance may vary either higher or lower. HP LCD Monitors Table B-1 2310e/2310ei Specifications Specifications Display Type: TFT LCD active matrix Viewable Image Size...

Preset Video Modes The monitor automatically recognizes many preset video input modes that will appear properly sizedand centered on the screen. Table B-2 Factory Preset Video Input Modes Preset Resolution Horizontal Frequency (kHz) Vertical Frequency (Hz) 1 640 x 480 31.469 59.94 2 720 x 400 31.469...

LCD Monitor Quality and Pixel Policy Your LCD Monitor uses high-precision technology, manufactured according to high standards, to helpguarantee trouble-free performance. Nevertheless, the display may have cosmetic imperfections thatappear as small bright or dark spots. This is common to all LCD dis...

C Agency Regulatory Notices Federal Communications Commission Notice This equipment has been tested and found to comply with the limits for a Class B digital device,pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protectionagainst harmful interference in a resid...

Hewlett Packard Company P. O. Box 692000, Mail Stop 530113 Houston, Texas 77269-2000 Or, call 1-800-HP-INVENT (1-800 474-6836) For questions regarding this FCC declaration, contact: Hewlett Packard Company P. O. Box 692000, Mail Stop 510101 Houston, Texas 77269-2000 Or, call (281) 514-3333 To identi...

For non-telecommunications products and for EUharmonized telecommunications products, suchas Bluetooth® within power class below 10mW. For EU non-harmonized telecommunicationsproducts (If applicable, a 4-digit notified bodynumber is inserted between CE and !). Please refer to the regulatory label pr...

and current rating marked on the product. In addition, the cross-sectional area of the wire must be aminimum of 0.75 mm² or 18 AWG, and the length of the cord must be between 6 feet (1.8 m) and 12feet (3.6 m). If you have questions about the type of power cord to use, contact an authorized HPservice...

pressing the power/sleep button, receiving an input signal from an input device, receiving an inputsignal from a network connection with the Wake On LAN (WOL) feature enabled, etc. Additional information on the ENERGY STAR® program, its environmental benefits and the potentialenergy and financial sa...

11363-2006 11363-2006 Turkey EEE Regulation In Conformity with the EEE Regulation EEE Yönetmeli ğ ine Uygundur 32 Appendix C Agency Regulatory Notices ENWW