Hoover WindTunnelTM- User Manual

Page 2 - Review this manual before; Important Safeguards!; Save these instructions!

Fill in and retain The model and serial number are located on the back of the handle as shown. For your personal records, please enter the COMPLETE model and serial numberin the spaces provided and retain this information. Your cleaner is model___________________________________ and has serial numbe...

Page 3 - Assembling cleaner; Carton contents; Continued; Index

3 1. Assembling cleaner Carton contents Remove all parts from carton andidentify each item shown. Makesure all parts are located beforedisposing of packing. A. Handle screws (in bag with owner’s manual) B. Hose, cleaning tools and wandsC. Handle D. Cleaner 1-1 A B C D This cleaner was inspected and ...

Page 4 - STEP II Attach hose; STEP III Position tools; Now that your new; STEP I Attach handle

Place smaller diameter end of wand,into bottom of rack. Snap wand intoclip at the top. Repeat with otherwand. STEP II Attach hose 1-5 1-8 1-9 1-6 1-7 Align end of hose with projection (E)over slots (F) in dirt duct on back of handle. Slide hose into (F) and twist hose tolock it into place. Position ...

Page 5 - Cleaner description; Transporting cleaner

14. Brush roll control: slide control to “Carpet” for cleaning with brush roll ON or to “Hard” for cleaning with brush roll OFF. 15.Carpet height control: slide knob to cor rect setting for height of carpet being cleaned. 16.Headlight 17.‘Dirt FINDER’display*18.Embedded Dirt FIND-ERTM sensitivity sw...

Page 7 - Cleaning tools

7 indicator (some models only) When red is in the OFF window, brushroll is STOPPED. When red is in the ON window brush rollis ROTATING. Cleaning lightweight 2 - 1 0 2 - 1 1 2 - 1 2 2 - 1 3 flexible rugs Stand on one end of rug and movecleaner toward other end or edge.B e f o re reaching edge, push d...

Page 8 - Check bag indicator; When to replace; Stair Cleaning

3 - 1 8 2 - 1 9 Changing filter bag Disconnect cleaner from electricaloutlet. H Where to buy Filter bags may be purchased fromAuthorized Hoover Dealers (Depot),Leading Retailers, from Hoover Factor yService Centers, or through The HooverCompany on-line at www.hoover.com. What to buy To assure cleani...

Page 9 - Replacing final filter; What to buy

How to reattach filter door The filter door is designed with a“break-away“ feature which allows it tosnap free if it is pushed open too far.To reattach, align hinges (C) of coverwith slots on sides of filter area. Press door back into place. Check brush roll chan -nels Because your WindTunnel cleane...

Page 10 - Belt replacement; Replacing flat belt; B rush roll re p l a c e m e n t

3 - 1 2 3 - 1 3 3 - 1 1 D C 3 - 9 3 - 1 0 Belt replacement The belts are located under the bottomplate of the cleaner and should bechecked from time to time to be surethey are in good condition. The flat (wide) belt is described below; the other is described under “Brush rollreplacement”. When to re...

Page 11 - Replacing brush roll; Service

Installing brush roll Grasp brush roll and fit it into position byfirst sliding end, opposite the belt, intothe rectangular slot (G) on side of clean-er.Push other side of brush roll (H) intoplace. Belt may fit loosely when proper-ly installed. Reposition flat belt and bottom plate (Figs. 3-12 and 3...

Page 12 - Clearing blockages; Thermal protector; Lubrication

Possible Cause Possible Solution • Incorrect carpet height setting• Move carpet height control to a highersetting Problem: Cleaner won’t run P ro bl e m : Cleaner / tools won’t pick up Possible Cause Possible Solution • Broken or worn belt(s)• Replace belt(s) • Brush roll worn• Replace brush roll • ...

Hoover WindTunnelTM- User Manual

Table of Contents:

Other Manuals for Hoover WindTunnelTM

Summary

Other Hoover Models