Hoover Wet/Dry Vac- Manual

Page 2 - Thank you for selecting a

2 Important Safeguards! When using an electrical appliance, always follow basic precautions, including the following: READ ALL INSTRUCTIONS BEFORE USING THIS APPLIANCE. Warning: To reduce the risk of fire, electric shock, or injury: • Do not expose to rain; store indoors only.• Connect to a properly...

Page 3 - In Canada, the use of a

3 Grounding Instructions This appliance must be grounded.If it should malfunction orbreakdown, grounding provides apath of least resistance forelectrical current to reduce the riskof electric shock. This appliance isequipped with a cord having anequipment-grounding conductor(C) and grounding plug (A...

Page 4 - Carton contents; assembled to cleaner lid; H. Small foam filter; inner tank; Insert inner tank

4 A A A B B B B A Carton contents Remove parts from tank and identifythe following: A. Outer tankB. Inner tankC. Cleaner lid and portable blowerD. Caster supports (4)E. Casters (4)F. Caster support screws (4)G. Reusable cartridge filter - assembled to cleaner lid H. Small foam filter - assembled to ...

Page 5 - Attach cleaner lid; For convenience in attaching; Attach tool rack; loop cord over

5 Attach cleaner lid Rotate lid latches (E) outward. Withwet/dry selector (F) toward drainside of tank align ribs (G) on front oftank with slots (H) on either side ofhose inlets; place lid on tank. Rotate latches inward to lock lid inplace. Note: For convenience in attaching and removing the lid, fi...

Page 6 - Adapter; properly; Single tank operation; properly grounded outlet

6 Extension cordinstructions Use an outdoor, grounding type,SJT extension cord of 16 gauge (upto 35 feet) or 14 gauge (any length).The extension cord must employ a 3-prong grounding type plug and a3-pole receptacle that accepts themachine plug. Adapter (Included with some models) To use smaller diam...

Page 7 - Removing blower; use blower handle; properly grounded; and turn blower on; Wear ear protection; if using the; Do not; use blower in wet or rainy; Storage; Rinse inside of tank; Wipe inside

7 Drywall dust For best results when picking up drywall dust, slide wet/dry selector (A)to expose “WET/TANK INLET” (B)and make sure no water or moistureis in the tank (outer tank). Keep inner tank in position. Insert hose into “WET TANK INLET”and attach desired tool to hose end. Portable blower The ...

Page 8 - Wipe inside of tank dry.; Filters; Filters are available; at your Hoover; Foam filter; Vigorous scrubbing or; Lubrication; If not very full, the inner tank; do

8 After wet pick-up Unscrew drain cap (A) from bottomof outer tank. Empty contents into asuitable drain. As the liquid level decreases, it maybe necessary to tip cleaner to allowremaining liquid to drain out. Rinse inside of tank thoroughlywith clean water particularly ifspills or other substances o...

Page 9 - Problem: Loss of air suction; Service; Hoover Factory; Possible Solution

9 Problem: Loss of air suction • Possible Cause• Possible Solution • Obstruction in hose, wand or tool.• Clear obstruction. • Clogged cartridge or foam filter.• Clean filter as described in “Maintenance” section. • Hole/split in hose.• Inspect and replace hose. • Automatic shut-off engaged.• See “Au...

Page 10 - HOOVER and are registered trademarks; Litho USA; THE HOOVER COMPANY, NORTH CANTON, OHIO 44720; HOOVER y son marcas registradas

HOOVER and are registered trademarks THE HOOVER COMPANY, NORTH CANTON, OHIO 44720 3-98 S6760 Litho USA 56514-020 ® ® ® HOOVER et sont des marques déposées THE HOOVER COMPANY, NORTH CANTON, OHIO 44720 HOOVER y son marcas registradas THE HOOVER COMPANY, NORTH CANTON, OHIO

Table of Contents:

Other Manuals for Hoover Wet/Dry Vac

Summary

Other Hoover Models