Hoover U6049- User Manual

Page 2 - in the spaces provided above and retain in a safe place.; INDEX

in and ret&n! The HOOVER vacuum cleaner you have just purchased is a combination cleaner. The cleaner may be used on carpet and rugs, and it is also for use with attachments. This cleaner is equipped with the automatic ‘Power Drive’ feature. Your cleaner is a model . . . . . . . . . . . . . . . ...

Page 3 - ENERGY SAVING TIPS

l Read all instructions. l Warning: Electric shock could occur if used outdoors or on surfaces. l Close supervision is necessary when any appliance is used by or near dren. Do not allow vacuum cleaner to be used as a toy or to run ed at any time. l Keep hands, feet, loose clothing, and hair away fro...

Page 4 - Operate only at voltage specified on bottom of cleaner.

Warning: Electric shock could occur if used outdoors or on wet surfaces. Operate only at voltage specified on bottom of cleaner.

Page 5 - Note: Be certain dial indicator points to desired; Three position handle; low

FIG. 1 This deluxe cleaner provides you with an automatic ‘Power Drive’ feature. It propels the cleaner forward and backward at a variable rate of speed controlledentirely by (you) the operator. To move forward Push the handle grip forward. Notice that the clean- er moves in a forward direction with...

Page 7 - Crevice tool; HOW TO USE; Handle must be in the Storage Position when

1. Vinyl hose Hose has vinyl jacket for long, trouble-free life. The light flexible hose has a vinyl tab, so it can be hung on the cleaner. Asuction regulator is located on the hose grip. 2. Extension wand Use to give length when cleaning stairs or above the floor, hard to reachareas. 3. Upholstery ...

Page 8 - Disconnect cord from electrical outlet before at-; THE BAG

b. To wand Add a tool to the end of the wand by fitting the button projection on the tool into the opening on the wand. You will hear the plastic spring latch snap and lock into place. To release, press down on the spring and remove. 4. Remove hose for floor use When you are finished using the attac...

Page 11 - When to replace belts; TO REPLACE BELTS

i There are two belts on your cleaner. The belts drive the agitator and the power drive pulley and are important for the efficient operation of your cleaner. Because of this, when buying new belts, you should always insist on genuine HOOVER belts. Some other belts on the market, not manufac-tured un...

Page 12 - TO REPLACE BRUSHES

Replace agitator and latch it in tion. (Fig. 4). Make sure that large belt is in center of pulley, and free of agitator mount- ings and latch. Turn agitator by hand to be sure that belt is in proper posi- tion. (Fig. 5). Replace bottom plate. (Fig. 6). Make sure that clips enter into the recesses on...

Page 14 - TO REPLACE BULB

THE HEADLIGHT (Some models only) The headlight, located at the bottom of thefront bag cover, operates when the cleaner isturned on. The headlight bulb illuminates both the headlight and the full bag indicator. TO REPLACE BULB 1. Remove cord from electrical outlet. 2. Open rear bag cover. 3. Remove t...

Page 15 - USER; CHECK LIST; This

USER CHECK LIST This appliance was inspected thoroughly and was in good operating condition when it was shipped from the factory. If a minor problem develops, it usuallycan be remedied quite easily when the cause is identified. Accordingly, this check list is provided for your convenience. Problem P...

Page 16 - VCMA; TO AVOID ELECTRIC SHOCK

VCMA VACUUM MANUFACTURERS ASSOCIATION (HOOVER -AN ASSOCIATION MEMBER) Service To The Consumer Since 19 13 This information has been compiled by the Vacuum Cleaner Manufacturers Associ- ation from Governmental and Private Sources concerned with product safety. These basic guidelines are for your prot...

Table of Contents:

Other Manuals for Hoover U6049

Summary

Other Hoover Models