Hoover U4361- User Manual

How ON-OFF switch To turn cleaner ON, push switch down. To turn cleaner OFF, push the switch up. Some models are equipped with a two-speed Power switch. When the switch is pushed up asfar as possible, it is in the OFF position. Normal Speed is to be used for regular cleaning of carpet and rugs and w...

Cleaning lightweight flexible rugs Lightweight flexible rugs used on hard surface floors in entrances, bathrooms, etc. should be cleaned by the following method. Stand on one end of the rug andmove the cleaner toward the oth- er end or edge. Before reachingthe other end, push down on the handle. Thi...

Edge cleaning This feature improves the cleaning of carpet edges near baseboards and solid furniture. Dust and lint tend to collect along these edges. The cleaner bottom plate has been designed with a passageway for dirt toenter the nozzle from the side to increase cleaning ability of edges. From th...

The converter must first be as- sembled to the hose by inserting the converter into the hose con- . Push connector and converter to- gether and twist until the projec- tions on the converter fit into the holes on the hose connector. This unit should remain assembled for all future tool use. Using cl...

C. Attach tool After choosing the proper tool for your particular task, attach it to the end of the hose grip. The outer plastic ring on the end of the hose grip has a slot. Turn the ring until that slot aligns with the slot in the hose connec- tor. Insert the tool so that the button on the tool fit...

Maintenance The following sections are concerned with proper maintenance of the cleaner. Familiarize yourself with these home maintenance tasks andkeep this owner’s manual in a convenient place where you can refer to it when needed. Proper use and care of your cleaner will assure continued cleaning ...

The headlight How to replace the headlight Disconnect cleaner from electri- cal outlet. This cleaner uses 12 volt, wedgebase type 912 bulbs. Set adjustment lever for pile height to the “NORMAL” or “HIGH” position. 2. Turn cleaner over and removethe two screws indicated in the il- lustration. Place c...

5. Place belt on pulley.belt nearer cleaner should be inline with projections on bottom of cleaner. Placing the belt in this position enables the agitator torotate in the proper direction. 6. Replace bottom plate, by put- ting metal knobs on plate into wire holders underneath front of cleaner. Pivot...

If you have a problem This appliance was inspected thoroughly and was in good operating con-dition when it was shipped from the factory. If a minor problem devel-ops, it usually can be remedied quite easily when the cause is identified.Accordingly, this check list is provided for your convenience. P...

VCMA VACUUM CLEANER MANUFACTURERS ASSOCIAT I ON (HOOVER AN ASSOCIATION MEMBER) Service To The Consumer Since 1913 This information has been compiled by the Vacuum Cleaner Manufacturers from Government and Private Sources concerned with product safety. These basic guidelines are for your protection a...