Hoover TurboPOWER - Manual

Press cord into cord clip on back ofhandle. Pull cord tight and wrap cordaround hooks (A2). 5 1-10 1 - 1 1 1 - 1 2 1 - 1 3 1 - 1 4 F A2 E Storing hose & tools Store hose on holder by first positioninghose in front section of clip. Continue wrapping hose under lowerhook (E). Snap hose end fully i...

6 1. Hand grip2. Solution trigger: press to release clean solution. 3. Hose4. Hose holder: wrap hose around holder and top hose hook (6) for storage. 5. Hose hook6. Cord hooks: wrap cord around hooks for storage. The top hook can be rotated right or left for quick and easy cord release. 7. Powered h...

7 The deep cleaner may also be lifted by placing a hand under the upper cleansolution tank handle as shown. 2-5 2-6 2-7 2-8 Automatic “shut off” When the re c o v e ry tank (lower tank) is fullthe automatic shutoff mechanism will shuto ff the deep cleaner suction (suction will be noticeably reduced)...

8 D C 2-11 2-12 2-13 2-14 2-15 2-16 Pour detergent into tank. Fill tank tofill line (B) (1 gallon) with hot tapwater. To assure proper performance, use only HOOVER cleaning detergent. B If rubber ring (C) on cap has becomedislodged, reposition it with uneven side against ledge (D) as shown. Replace ...

9 3-1 3-2 3. How to clean Before you begincleaning a. Vacuum thoroughly - For carpet, use a HOOVER vacuum cleaner with anagitator for best results. Vacuum uphol -stery with a vacuum cleaner with clean-ing tool attachments. Use a crevice toolto reach into tufts and folds. Do not use the ‘SteamVac’ de...

Cleaning bare floors Using the tools 3-6 3-7 How to attach bare floor attachment (available at additional cost if notincluded with your cleaner) Disconnect deep cleaner from electri-cal outlet. To prevent possible leaking, removeclean solution tank (Fig. 2-8) and recov-ery tank (Fig. 2-15) before po...

9. Lift tool, and position it against riser.Pull tool slowly over carpet without pressing trigger (dry stroke). It is best to alternate wet and dry strokesas described above. End with more drystrokes to aid in faster drying of carpet. 10. Overlap strokes by 1/2 inch to helpprevent streaking. To avoi...

13 3-13 3-14 Cleaning upholstery Read “Before you begin cleaning”instructions on page 9. Be sure to check the cleaning code onyour upholster y. Use your deep cleaner only on upholstery marked “W” or“W/S”. 1. Place handle in upright position. Agitator brushes will not rotate whilehandle is in upright...

S t o r a g e Before storing: • Empty solution tank and rinse thoroughly with clean water. • Replace empty solution tank and turn deep cleaner ON. Squeeze trigger and push deep cleaner for-ward and back several times to expel any solution remaining in thedeep cleaner’s system. (Do not usedeep cleane...