Hoover LS- Manual

5 1-10 1-11 1-12 1-13 1-14 1-15 1-17 Slide rack down into place. Insert screwat (D) and tighten with a Phillips screw-driver. D F E Storing hose & tools Store hose on holder by first positioninghose in front section of holder. Continue wrapping hose under lowerhook (E). Snap hose end fully into ...

6 1. Hand grip2. Solution trigger: press to release clean solution. 3. Cord clip: place cord in clip to keep it out of the way when using cleaner 4. Hose5. Hose holder: wrap hose around holder and hooks (6) for storage. 6. Hose hooks7. Cord hooks: wrap cord around hooks for storage. The top hook can...

7 Brush Speed OFF HI LO 2-5 2-6 2-7 2-8 2-9 2-10 The deep cleaner may also be lifted byplacing a hand under the upper cleansolution tank handle as shown. Automatic “shut off” When the recovery tank (lower tank) is fullthe automatic shutoff mechanism will shutoff the deep cleaner suction (suction wil...

8 2-11 2-12 Rotate tank cap counterclockwise and liftup to remove cap. Turn cap (A) upside down to serve as ameasuring cup. 5 OUNCES/150 ml A D C 2-13 2-14 2-15 2-16 Using cap, measure detergent followingthe chart below. For carpet, carpeted stairs and uphol-stery: Fill cap to fill line (5 ounces) w...

9 2-18 Raise handle to carrying position(straight up) to unlock tank from base of deep cleaner. Lift tank from deep clean-er and carry it to a sink or drain. To remove tank lid, lower handle com-pletely toward back of tank and lift offlid. Empty the tank and reposition the lid. 3-1 For full suction,...

10 Some models have a nozzle clean-outtool for removing debris or if a non-car- peted floor is not available. To use thetool: Disconnect deep cleaner from electrical outlet. Slide tool into nozzle and remove debris as shown.To clean the outside of the machine,wipe off dirt with a cloth dampened inwa...

11 Using the tools 4. Return deep cleaner to upright posi-tion. Lower handle and replace recoverytank. 5. Raise handle to upright position andreposition clean solution tank. To clean floor Read Before you begin cleaninginstructions on page 9. Do not use the SteamVac deep clean-er on hardwood floors....

3-14 9. Lift tool, and position it against riser.Pull tool slowly over carpet without pressing trigger (dry stroke). It is best to alternate wet and drystrokes as described above. End withmore dry strokes to aid in faster dryingof carpet. 10. Overlap strokes by 1/2 inch to helpprevent streaking. To ...

13 3-15 3-16 Read “Before you begin cleaning”Instructions on page 9. Be sure to check the cleaning code onyour upholstery. Use your HOOVER ‘SteamVac’ deep cleaner only onupholstery marked “W” or “W/S”. 1. Place handle in upright position. Agitator brushes will not rotate whilehandle Is In upright po...

5. If you have aproblem 14 If a minor problem occurs, it usually canbe solved quite easily when the cause isfound by using the check list below. Possible cause Possible solution • Not firmly plugged in• Plug unit in firmly • No voltage In wall plug• Check fuse or breaker • Blown fuse/tripped breaker...