Hoover HF7 160E - Manual

Remove the machine from the packaging - close to where it will finally be positioned - and proceed as follows: On the back of the machine 1) Remove the central screw A and side screws B and pull out the transit bracket C along with the red locator. 2) Tilt the machine forward and remove the polystyr...

Note: we recommend you keep the transit bracket andscrews to protect the machine for future transit.The Manufacturers will not be responsible for anydamage to the machine caused by not following theinstructions relating to releasing the transit protection.The user is responsible for all installation...

If the inlet hose’s connection point is changed, check that the 3/4” threaded ferruleon the inlet hose is firmly attached to the electrovalve connector. Water supply requirements Connect the machine to the drainage system used by household sinks. 8 THIS MACHINE MUST BE CONNECTED INACCORDANCE WITH TH...

Testing the installation Refer to the programme guide for details of how to select programmes. 1. Turn on the water supply and check for leaks from fill hoses. 2. Switch on the electricity supply. 3. Select a spin programme and then press the START/PAUSE button to start the machine.Allow the program...

To ensure the drum is thoroughly clean after testing and storage, selectprogramme 1 and run the machine for a complete cycle using only washdetergent and water. If the machine is not to be used immediately, switch off the mains power supplyand remove the plug from the power socket. We also recommend...

11 Useful washing advice Tips on using your appliance in the most environmentally-friendly and economicalway Loading your washing machine To make further reductions of energy, water and detergent consumption, werecommend that you put a full load into your machine. Energy savings of up to50% can be a...

Description of Controls All the controls on your product’s control panel are listed as follows. The buttonfunction is selected when the button neon is lit. Carefully read the relevantdescriptions detailed below: START/PAUSESTART After selecting the programme press the START/PAUSE button once to star...

– the third, labelled “ ” is for special additives, fabric softeners, fragrances,starch, brighteners etc. The machine is programmed to automatically take up additives during the finalrinse stage for all wash cycles. 14 Note: only put special additives, fabric softeners,fragrances, starch, brightener...

Detergents, washing aids and amounts touse Choice of detergent General purpose detergents – Powder detergents, for a thorough wash, with bleaching agents, are particularly suitable for use in hot wash programmes (60°C and over), for heavily soiled andstained laundry. – Liquid detergents, are particu...

Before pouring in the detergent check that there are no foreign bodies in thedetergent drawer. Dosage details are usually shown on the detergent packaging. Follow thoseinstructions! Dosages Only use detergents which are suitable for use in a washing machine.You will obtain the best results from your...

17 Programme selector The washing machine has different programme groups according to type of wash,temperature, spin speeds and duration for handling the various types of fabric andtheir level of soiling (see wash programme guide). 1. COTTONS The programmes are designed for maximum washing and rinsi...

Sorting the laundry – It is recommended you wash only items which are washable with water anddetergent and not dry-clean items. – If you need to wash rugs, bedspreads or other heavy items, it is best not tospin them. – Sort the laundry according to fabric type, degree of soiling and washtemperature:...

Putting detergent in machine D) Open the drawer, choose the detergent and put in the correct amount, accordingto the manufacturer’s instructions and thedetergent advice section within thismanual.Add any other laundry aids (see page 15).Close the drawer again.Liquid detergents that are to be placeddi...

23 PROGRAMME FABRIC TYPE PROGRAMME FOR LOAD WATER DETERGENT TEMP °C I II Whites Colourfast fabrics Intensive - heavily 7 90° * * Cotton, linen, hemp soiled Whites & Cotton, colourfast Normal soiling 7 60° * * * +P Prewash mixed fibres Coloureds Cotton, mixed fabrics Normal-Light soiling 7 60° * ...

25 Cleaning and routine maintenance Do not use alcohol-based scourers and /or thinners on the outside of yourwashing machine, just a wipe with a damp cloth will suffice. The washingmachine needs very little maintenance:– Cleaning the drawer compartments. – Cleaning the filter. Cleaning the drawer Cl...

27 Trouble shooting What might be the cause of...Defects you can remedy yourself Before calling GIAS Service for technical advice please run through the followingchecklist. A charge will be made if the machine is found to be working or has beeninstalled incorrectly or used incorrectly. If the proble...

Power failure If there is a power failure the wash cycle will be interrupted, the wash programmeand functions will be suspended.When the power is restored, the wash programme and functions will re-start fromthe same point and complete the programme.The load can be removed from the machine during a p...

Technical data • Max. load of dry laundry 7kg • Water pressure (0.5-8 bar) 0.05-0.8 MPa • Spin speed 1600 rpm Measurements • Width 50cm • Depth 54cm • Height 85cm 30 NB: For specifications regarding electrical data, see the data plate on the front ofthe washing machine (door area). You will also nee...

Customer Service The appliance is covered by a certificate of guarantee which allows you free useof the Hoover Technical Support Service (termed GIAS tel: 08705 400 600),except for the price of the call, for a period of one year from the date of purchase.Remember to send off the guarantee certificat...

For service and repairs please call our national number: Hoover Technical - Tel: 08705 400 600Support Service [ Eire 018301 666 ] Always use genuine Hoover spares, available direct from GIAS Service: Hoover Spares Service Tel: 01204 556111 Hoovercare To maintain your Hoover product in peak condition...