Hoover Hand-held Vacuum Cleaner - Manual

Page 2 - Fill in and retain; Index

This cleaner was inspected and packaged carefully before being shipped from the If you should happen to need assistance during assembly or operation call l-800-944-9200 for an automated referral of authorized service outlet locations (U.S. only) or l-330-499-9499 to speak with a representative in ou...

Page 3 - Important Safeguards!; Save these instructions!

Important Safeguards! n To reduce the risk of fire, electric shock Warning. or injury: Do not use outdoors or on wet surfaces. Close supervision is necessary when any appliance is used by or near children. Do not allow vacuum cleaner to be used as a toy or to run unattended at any time.Keep hair, lo...

Page 4 - Unpacking

Unpacking Unpack the cleaner from the carton and identify the parts shown. Remove and dispose ofcardboard packing. 1. Bottom plate 2 . Multi-purpose nozzle 3. Front cover switch 5 . Handle6 . Dirt Cup 7. Dirt cup latch button 8 . Nozzle latch This cleaner is intended for household use. Operate clean...

Page 5 - Questions or Concerns?; How to use

Questions or Concerns? The Hoover Company wants to quickly resolve any concerns about your cleaner or questions regarding its use. Look on the list provided with the product for youre local Hoover Factory Service Center or in the Yellow Pages under “Vacuum Cleaners Household” for the nearest Authori...

Page 6 - Brushed edge cleaning; Maintenance; The dirt cup; to empty

How to rotate nozzle CAUTION: MOVING PARTS. TURN CLEANER OFF BEFORE ROTATING NOZZLE. To rotate nozzle either vertically or horizontally, place thumb on latch with finger on front of nozzle. Press latch toward edge of nozzle and rotate. Brushed edge cleaning Brushed edge cleaning isprovided on both s...

Page 8 - Clearing obstructions; Reusable filter; How; to clean

8. Replace filter, matching 9. Slide dirt cup completely onto rounded flap with rounded side of handle making sure latch is secure. dirt cup (opposite side that slidesonto handle). Clearing obstructions Removing larger items from carpet and other surfaces before vacuuming will help prevent obstructi...

Page 11 - Agitator brush; Where to buy

6. Attach belt to motor pulley. Replace bottom plate by firsthooking it to center tab on insideof nozzle. 7. Reposition screws and front cover. 8. Make sure “bridge” across bottom plate opening covers belt. If belt is not covered, agitator is not correctly oriented in nozzle. Agitator brush Disconne...

Page 12 - How to replace

How to replace Disconnect cleaner from electri- cal outlet. 1. Remove bottom plate, agitator and belt following directions for “How to replace belt.” 2. Discard old agitator and end caps. 3. If the end caps should fall off the agitator, they are different from eachother and need to be properly orien...

Page 13 - If you have a problem; Lubrication

If you have a problem This appliance was inspected thoroughly and was in good operating condition when it was shipped from the factory. If a minor problem develops, it usually can be solved quite easily when the cause is identi- fied. Therefore, this check list is provided for your convenience. Prob...

Page 14 - Service

Service To obtain approved HOOVER service and genuine HOOVER parts, locate the nearest Hoover Factory Service Center or Authorized Hoover Warranty Service dealer (depot) by: l checking the Yellow Pages under “Vacuum Cleaners Household” OR- * Checking the list of Factory Service Centers provided with...

Hoover Hand-held Vacuum Cleaner - Manual

Table of Contents:

Summary

Other Hoover Models