Page 2 - CONTENTS; Keep this booklet safe for future reference.
2 CONTENTS Safety adviceSetting up, installationWater softener unitLoading the saltAdjusting the upper basketLoading the dishesInformation for test laboratoriesLoading the detergentTypes of detergentLoading the rinse aidCleaning the filtersSome practical hintsRoutine cleaning and maintenanceDescript...
Page 3 - SAFETY INSTRUCTIONS; Installation; Knives and other utensils with sharp; Daily use
SAFETY INSTRUCTIONS There are certain basic safety ruleswhich are valid for any domesticappliance. Installation ■ Make sure that the plug fitted to themachine is compatible with the powersupply socket. If it is not, get a suitablyqualified person to fit the correct type,and to make sure that the cab...
Page 4 - INSTALLATION; Electrical connection; CUT IT OFF AND DESTROY IT!; Disposal; Connect to the terminal in the plug
INSTALLATION (Technical notes) ■ After unpacking, adjust the height of thedishwasher. For the dishwasher to workcorrectly it must be level. Adjust the feetso that the machine does not tilt by morethan 2 degrees. ■ If it you need to move the machine afterremoving the packaging, do not try to liftit b...
Page 5 - Water connection; and the inlet hose “A”, remembering
5 Water connection IMPORTANTThe appliance must be connected tothe water mains using new hose-sets.The old hose-sets should not be reused. ■ The inlet and drain hoses can be directedto left or right. IMPORTANTThe dishwasher can be connected toeither cold or hot water, as long as itis no hotter than 6...
Page 6 - Connecting the outlet hose
6 Connecting the outlet hose ■ The outlet hose should disharge into astandpipe, making sure that there are nokinks (fig. 4). ■ The standpipe must be at least 40 cmabove floor level and it must have aninternal diameter of at least 4 cm. ■ It is advisable to fit an anti-odour air trap(fig. 4X) . ■ If ...
Page 8 - WATER SOFTENER UNIT; Regulating the water softener; YES
8 * The water softener unit is set in the factory at level 3, as this is suitable forthe majority of users. According to the degree of hardness ofyour water, regulate the softener unit in thefollowing way: IMPORTANTThe dishwasher must be ALWAYSoff before start this procedure. 1. Hold down the "P...
Page 9 - LOADING THE SALT; IMPORTANT; Salt loading indicator
9 LOADING THE SALT ■ On the bottom of the machine there is acontainer for the salt for regeneratingthe softener. ■ It is important to use only a salt that isspecifically designed for dishwasher.Other types of salt contain small quantitiesof insoluble particles which over a longperiod of time may aff...
Page 10 - Turn the front stops “A” outwards
10 ADJUSTMENT OF THE UPPERBASKET If 27 cm to 31 cm plates are normally used,load them onto the lower basket after theupper basket has been placed in its upperposition and proceed as detailed below: 1. Turn the front stops “A” outwards; 2. Take out the basket and remount it in the upper position; 3. ...
Page 11 - LOADING DISHES; Using the upper basket
11 LOADING DISHES Using the upper basket ■ The upper basket is provided withmobile racks hooked to the sides of thebasket, which can be regulated into twopositions: upright and lowered. ■ In the lowered position the racks may beused for such items as: tea and coffeecups, kitchen knives and ladles. A...
Page 12 - Using the lower basket; A G
12 Upper basket (fig. 3) A = glasses B = saucers C = cups D = small bowl E = medium bowl F = large bowl G = serving spoons Using the lower basket ■ Saucepans, oven dishes, tureens, saladbowls, lids, serving dishes, dinnerplates, soup plates and ladles can beloaded on the lower basket. ■ Place the cu...
Page 13 - INFORMATION FOR THE TEST LABORATORIES
13 Cutlery basket (fig. 6) The cutlery basket is made with twodetachable parts which will enable variousloading options. The two parts can be detached by slidingthe left section away from the right section. The top of cutlery basket can be removed,for enable various loading options. INFORMATION FOR ...
Page 14 - LOADING THE DETERGENT; The detergent
14 LOADING THE DETERGENT The detergent IMPORTANTIt is essential to use a detergentthat is specifically designed fordishwashers either in powder, liquidor tablet form. “FINISH” gives very good results and canbe easily obtained. Unsuitable detergents (like those forwashing up by hand) do not contain t...
Page 15 - TYPES OF DETERGENT; Detergent tablets; Concentrated detergents
15 TYPES OF DETERGENT Detergent tablets Detergent tablets of different manufacturers dissolve at different speeds, for this reason, during short programmes, some detergent tablets may be not fully effective, because they are not completely dissolved. If these products are used, is recommended to cho...
Page 16 - LOADING THE RINSE AID; The rinse aid
16 LOADING THE RINSE AID The rinse aid The rinse aid, which is automaticallyreleased during the last rinsing cycle, helpsthe dishes to dry quickly and preventsspots and stains forming. Filling the rinse aid container The rinse aid container can be found to theleft of the detergent container (fig. A ...
Page 17 - CLEANING THE FILTERS
1 2 3 CLEANING THE FILTERS The filter system (fig.A “4”) consists of: a central container that traps the largerparticles; a flat gauze that continuously filters thewash water; a micro filter, located beneath the gauze,that traps the tiniest particles ensuring aperfect rinse. ■ To achieve excellent r...
Page 18 - PRATICAL HINTS; How to make savings
18 PRATICAL HINTS How to get really good washresults ■ Before placing the dishes in thedishwasher, remove any remainingfood (bones, shells, pieces of meat orvegetables, coffee grounds, skin of fruit,cigarette ash, tooth picks etc. to avoidblocking the filters, water outlet andwashing arm nozzles. ■ ...
Page 19 - WHEN CYCLE IS FINISHED
19 WHEN CYCLE IS FINISHED After every wash it is essential to turn offwater supply and to switch off the machineby pressing the On/Off button to the offposition. If the machine is not going to be used forsome time, it is advisable to follow theserules: 1. do an empty wash with detergent in orderto c...
Page 20 - DESCRIPTION OF THE CONTROL PANEL; with working top
20 EN 50242 place loadCapacity with pans and dishesWater supply pressure FusePower inputSupply voltage 128 personsMin. 0,08 - Max 0,8 MPa(see rating plate)(see rating plate)(see rating plate) DESCRIPTION OF THE CONTROL PANEL TECHNICAL DATA: DIMENSIONS: HeightDepth Width Depth with door open cmcmcmcm...
Page 21 - (Use in conjunction with programme guide); Programme settings
21 PROGRAMME SELECTION AND SPECIAL FUNCTIONS (Use in conjunction with programme guide) IMPORTANTThe dishwasher has two very practicalfunctions:- the "recommended" programme(which is set in the factory and isideal for full-load daily use) for quickand accurate selection; - the memory function...
Page 22 - Changing a running programme; Programme operations; Programme end; Once selected, this option keeps
22 Changing a running programme Proceed as follows to change or cancel arunning program: ■ Hold the "RESET" button down for atleast 5 seconds. The programme indicator lights will flashand some audible signals will sound. ■ The running programme will be cancelledand the indicator light for th...
Page 23 - Fault signals; After checking to make sure the water
23 If a 9 hour delay is set, countdown will bedisplayed by the 6h indicator light after 3hours and the 3h indicator light after 6hours. At the end of the last 3 hours (at the endof countdown) the 3h indicator light willstop flashing and remain on to indicate thewashing phase and the programme willst...
Page 24 - Programme Description; PROGRAMME GUIDE
24 Wash with prewashFor wash programmes with prewash, it is advisable to add a second dose of detergent (max.10 g) directly in the machine. Once a day - for heavily soiled pans and anyother items that have been left all day forwashing. Suitable for heavily soiled items that are to bewashed straight ...
Page 26 - IDENTIFYING MINOR FAULTS
26 IDENTIFYING MINOR FAULTS Should the dishwasher fail to operate, before contacting the Service Centre, makethe following checks: FAULT CAUSE REMEDY 1 - Machine completely dead 2 - Machine does not draw water 3 - Machine does not discharge water 4 - Machine discharges water continuously 5 - Spray a...
Page 28 - Hoovercare; Hoover Spares Service
28 Hoover guarantees all parts of this product for 5 years fromthe date of purchase. During that time Hoover will replace orrepair all defective parts free of charge, except for partssubject to fair wear and tear such as belts. The call out fee andlabour costs are chargeable after the first 12 month...
Page 32 - HOOVER SERVICE; FOR YOUR LOCAL ENGINEER PLEASE CALL OUR NATIONAL NUMBER; EIRE
1 1.09 - 41900067.B EN 08444 995599 HOOVER SERVICE FOR YOUR LOCAL ENGINEER PLEASE CALL OUR NATIONAL NUMBER Areas covered by HOOVER SERVICE DEALERSAlso Channel Islands, Scilly Isles, Orkney, ShetlandsSee local telephone directory Hoover policy is one of continuous development and for this reason we r...
