Honeywell TH8110U - Manual
Honeywell TH8110U – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
Table of Contents:
- Page 2 – TH8110U TOUCH SCREEN PROGRAMMABLE THERMOSTATS; Installing Wallplate; CAUTION; IMPORTANT
- Page 3 – heat and cool system with single transformer
- Page 4 – Fig. 10. Typical hookup of cool only system; Powering the Thermostat; Wiring 24 Vac Common
- Page 5 – Mounting the Thermostat; Setting Calendar and Time; Locate and remove the tab labeled; Fig. 15. Setting calendar and time after initial; Using the Thermostat
- Page 6 – OPERATION; System and Fan Settings; SYSTEM Settings; INSTALLER SETUP; Installer Setup Menus
- Page 7 – Exiting Installer Setup; Press Done key to exit Installer Setup screen.
- Page 11 – SYSTEM CHECKOUT; Installer System Test; ADVANCED FEATURES; Outdoor or Indoor Temperature Sensor
® U.S. Registered Trademark
Copyright © 2004 Honeywell International Inc. •
• All Rights Reserved
INSTALLATION INSTRUCTIONS
69-1700
TH8110U Touch Screen
Programmable Thermostats
APPLICATION
The TH8110U Universal Programmable Thermostats provide electronic control of 24 Vac heating and cooling systems
or 750 mV heating system. See Table 1 for a general description.
RECYCLE NOTICE
If this control is replacing a control that contains
mercury in a sealed tube, do not place your old
control in the trash. Dispose of properly.
Contact your local waste management authority
for instructions regarding recycling and the
proper disposal of the old control.
INSTALLATION
When Installing this Product...
1.
Read these instructions carefully. Failure to follow
the instructions can damage the product or cause
a hazardous condition.
2.
Check the ratings given in the instructions to make
sure the product is suitable for your application.
3.
Installer must be a trained, experienced service
technician.
4.
After completing installation, use these instructions
to check out the product operation.
Selecting Location
Install the thermostat about 5 ft. (1.5m) above the floor in
an area with good air circulation at average temperature.
See Fig. 1.
Fig. 1. Selecting thermostat location.
Do not install the thermostat where it can be affected by:
— Drafts or dead spots behind doors and in corners.
— Hot or cold air from ducts.
— Radiant heat from sun or appliances.
— Concealed pipes and chimneys.
— Unheated (uncooled) areas such as an outside wall
behind the thermostat.
Table 1. TH811 Thermostats Description.
Model
Power
Method
Changeover
System Selection
Fan Selection
Comments
TH8110U
Batteries or
common wire
Automatic or
manual
selectable
Heat-Off-Cool-Auto
On-Auto-Circ
System and Fan
selection vary based on
system type
5 FEET
[1.5 METERS]
YES
NO
NO
NO
M19925
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
Summary
TH8110U TOUCH SCREEN PROGRAMMABLE THERMOSTATS 69-1700 2 Installing Wallplate CAUTION Electrical Hazard.Can cause electrical shock or equipment damage. Disconnect power before wiring. The thermostat can be mounted horizontally on the wall or on a 4 in. x 2 in. (101.6 mm x 50.8 mm) wiring box. 1. Posi...
TH8110U TOUCH SCREEN PROGRAMMABLE THERMOSTATS 3 69-1700 Fig. 5. Typical hookup of conventional single-stage heat and cool system with single transformer (1H/1C conventional). Fig. 6. Typical hookup of conventional single-stage heat and cool system with two transformers (1H/1C conventional). Fig. 7. ...
TH8110U TOUCH SCREEN PROGRAMMABLE THERMOSTATS 69-1700 4 Fig. 9. Typical hookup of heat only Series 20 system. Fig. 10. Typical hookup of cool only system (1C conventional). Fig. 11. Typical hookup of single-stage heat pump with no auxiliary/backup heat (1H/1C heat pump). Powering the Thermostat Ther...
