Hobart FD3-300 - Manual

Item # _____________________________________
Quantity ___________________________________

C.S.I. Section 11400

F-8560 – FD3-150 FD3-200 FD3-300 Foodwaste Disposers

Page 1 of 4

FD3-150 FD3-200 FD3-300

FOODWASTE DISPOSERS

701 S Ridge Avenue, Troy, OH 45374

1-888-4HOBART • www.hobartcorp.com

FD3-150

FD3-200

FD3-300 FOODW

ASTE DISPOSERS

R

MOTOR SHAFT SEAL:

Face-type seal consists

of sintered bronze mating ring and spring loaded
carbon ring insert in chemical resistant neoprene
bellows. Mating surfaces are protected from grit or
fibers by being recessed into flywheel. Should any
moisture pass this seal, a flinger and drain tube
are provided to insure immediate removal. In
addition, a lip-type oil seal (located beneath the
bearings) is an “added protection” water seal.

DRAIN CONNECTOR:

The removable outlet

flange is tapped for 2” pipe connection.

DUAL DIRECTIONAL GRINDING:

Hobart

Disposers operate in either direction of flywheel
rotation. Direction of rotation can be controlled by
the operator (to increase life and efficiency of
grinding elements – back flywheel free of a “jam”)
when installed with Control Groups 2 or 3.

WEIGHT:

Shipping – Approx. 95 lbs. (does not

include accessory group or controls).

MEDIUM SIZE

FAST, ECONOMICAL

In a profitable foodservice operation, there’s no
space, time or budget allowance for inefficient
food waste handling. Here are the medium sized
disposers that can end food waste storage,
removal and clean-up – fast, economically.

SPECIFICATIONS

Listed by Underwriters Laboratories Inc. and meets requirements of
A.S.S.E.Standard No. 1009 (50 Hz. Electrical Specifications not U L
Listed).

MOTORS:

Continuous duty rating, equipped with

manual reset thermal overload inherent protection.
Permanently lubricated ball bearings for upper and
lower shaft support.

HOUSINGS:

Heavy aluminum grind and discharge

housings. Four bolts fasten the motor unit to the
grind chamber, permit easy removal.

LEGS:

Tubular stainless steel with bullet feet to

support housing. Adjustable to 3 inches in either
direction.

MOUNTING:

All Hobart Disposers fasten to 7" I.D.

(throat opening) cones. A vinyl isolating ring
eliminates metal-to-metal contact at the cone
mounting, reduces vibration and noise
transmission.

STATIONARY SHREDDER RING:

Abrasion

resistant, Ni-Hard, 2

1

⁄

4

" high, 4 machine ground

primary action breaker bars, 42 secondary action
grinding teeth.

FLYWHEEL:

Offset breaker blade, mounted at

center, speeds grinding, prevents objects from
“riding” at center. Two hardened stainless steel
cutter blocks (fastened to flywheel with nylon
locking screws) are replaceable, can be indexed
for new cutting edges. Corrosion resistant
Ni-Resist flywheel is 7

3

⁄

16

” diameter, slots undercut

the shredder ring to assure that particles are cut to
proper size before passing to the drain line.