Hitachi EP-A7000 - Manual

E-5 Safety Pr ecautions Place of Use Water Tank, Water Tray and Humidifying Filter WARNING Do not operate the unit without setting any of the water tank, water tray and humidifying fi lter in place. Otherwise, it may cause injury or unit failure. Do not use any detergent (neither kitchen nor laundry...

E-6 Miscellaneous To Prevent Floor Scratches or Wall Stains During Cleaning / Place of Use Safety Precautions (Continued) Securely hold the grip when carrying air purifi er. Damaging or dropping it may cause injury. When you attach or detach the panel and water tank, do it slowly and securely. Other...

E-7 Safety Pr ecautions Cautions on Use Do not install in an unstable or sloped place, or near any obstacles. The unit may fall or drop, resulting in damage or unit failure.If the space between the unit and floor remains humid, the floor may get moldy.Using the unit tilted may cause water leakage. D...

E-8 Preparations for Operation Setting Filter in Purifier (Perform the same procedure when replacing filter. ) Remove the panel. Lay a soft cloth or the like beneath the purifier to protect the floor against scratch. No cleaning effect is obtainable if the filter is installed with plastic bag. It ma...

E-9 Inserting Batteries into Remote Controller Remove the battery compartment cover. Insert batteries and close the cover. Insert the provided two “AAA” R03 batteries with the correct polarities as instructed. Since the batteries are provided when shipped from the factory, their lives may be shorter...

E-10 Using Remote Controller Here we describe how to operate the air purifier using the remote controller. For the operation using the control on the purifier, please refer to page E-14. Starting Operation Remote Controller Air Purifier Indicator Section Securely insert the power plug into AC outlet...

E-11 Using Remote Contr oller Selecting Operation Mode (Basics) 5 operation modes are available for your choice. In every operation mode, the fan will not stop during operation. (In the eco operation mode, the fan may stop. P.E-17 ) In every operation mode, air purifying function will work. Upon eve...

E-12 Air Purify Strong Deodorization Skin Moisturize Humidify Pollen Max(Blinking) Auto Using Remote Controller (Continued) Airflow rate When “Auto” is lit, the following airflow rate is used according to the selected operation mode.The airflow rate indicators from “Silent” to “Max” are not lit. Mod...

E-13 Max(Blinking) Auto Pollen Timer(4hrs) Skin Moisturize Humidify Strong Deodorization Using Remote Contr oller Press button. Press button. Max Operation (Air Purify Mode) This operation is useful when many people smoke or when you want quick cleaning of room air. After Max operation, the status b...

E-14 ) Max(Blinking) Timer(4hrs) Skin Moisturize Clean Humidifying Filter Air Sensor Memory Function / Sensors / Auto Detection Memory Function When you stop the operation and then restart, the purifi er will resume the operation status before shutdown. If you operate the purifi er for approx. 5 sec...

E-15 Using the Contr ol on Purifier Memory Function / Sensors / Auto Detection Humidity Sensor The humidity sensor fi nds the humidity of room air during operation.Humidity level should be taken as a guide only. The indication may differ from hygrometer reading. Humidity will change as temperature c...

E-16 Max(Blinking Humidify Strong Deodorization Auto Pollen Air Purify Skin Moisturize Memory Function / Sensors / Auto Detection (Continued) Adjusting Sensor Sensitivity Setting Sensor sensitivity can be adjusted in 3-step fashion. In each operation mode, The airflow indicator will blink for 5 seco...

E-17 Max(Blinking) Skin Moisturize Humidify Strong Deodorization Auto Pollen Air Purify Useful Feature Dimmer Control If you feel uncomfortable about indicator lightings when you go to sleep, press button on the purifier unit for 3 seconds or longer to dim the indicators. Press button for 3 seconds ...

E-18 When the “Clean Humidifying Filter” Indicator Comes On Cleaning Remove the water tank, and then pull out the water tray. Remove the humidifying filter from the water tray. Clean the humidifying filter, water tray and tray cover. Install the water tray, and then mount the water tank. Plug the po...

E-19 Water Tank (Guide for cleaning: Daily) Change water daily with fresh tap water. Discard remaining water in the tank if any. Pour small quantity of tap water, tighten the cap firmly and shake to wash. (Change water and repeat the steps 2-3 times.) Humidifying Filter (Guide for cleaning: Once a m...

E-20 Water Tray / Tray Cover (Guide for cleaning: Once a month) Wash with water to remove dirt. Remove the tray cover. Wipe off water and assemble. Attach the tray cover to the water tray. Remove the tray cover from the water tray. Replacing Humidifying Filter The humidifying fi lter is a consumable...

E-22 Purifier Body (Guide for cleaning: Once a month) Wipe off dirt on the purifi er case using a soft cloth that is moistened with water and fully wrung. For heavy dirt, use a soft cloth moistened with neutral detergent thinned with water. After removing dirt, use a dry soft cloth to wipe off moist...

E-23 Cleaning Filter Replacement Replacement Interval Filter Replacement The fi lters are consumable parts. The standard life of the dust fi lter is about 8 years and that of the deodorizing fi lter is about 10 years. Testing was conducted according to JEM1467 of the Japan Electric Machine Industry ...

E-24 Replacing the Filter P.E-8 P.E-9 For the fi lters, use the optional EP-A6000-902 (dust fi lter) and EP-A6000-903 (deodorizing fi lter). Remove the water tank, and then pull out the water tray. (This procedure should be done to prevent water leakage.) When you remove the water tank, water may dr...

E-25 Troubleshooting Guide Smoke or smell is not efficiently removed, or there is an odor No remote operation Symptom Solution Before asking for repair check the following once again Securely insert the power plug into AC outlet. No air blows out or power does not turn on Is power plug securely inse...

E-27 T roubleshooting Guide Symptom Cause Following Conditions Are Normal Electric components are energized when power is supplied. This is normal. Snapping noise when plugging power cord into AC outlet Vibration is caused by fan rotation. This is normal. Purifier body vibration during the “Max” ope...

E-28 Model EP-A7000 Power supply AC220-240V 50-60Hz Airflow switching Max High Medium Silent Power consumption (W) 60 22 14 4 Airflow rate (m 3 /min) 7.0 4.5 3.4 1.0 Applicable floor space 50m 2 Humidifying performance (mL/h) Approx. 670 (Max operation) External dimensions 584(H) x 430(W) x 273(D) m...