Heat Controller EKTC15-1G - Manual

PACKAGED TERMINAL A/C SErviCE Manual Heat Controller 11 extenDeD performance Data EXTENDED COOLING PERFORMANCE OUTDOOR DRY BULB TEMP. (DEGREES F AT 40% R.H.) 75 85 95 105 110 INDOOR WET BULB TEMP. (DEGREES F AT 80 F D.B.) 72 67 62 72 67 62 72 67 62 72 67 62 72 67 62 EKTC07 BTUh 9055 8709 8062 8624 8...

Heat Controller SErviCE Manual Packaged Terminal A/C 12 extenDeD performance Data continUeD EXTENDED HEATING PERFORMANCE OUTDOOR DRY BULB TEMP. (DEGREES F) 37 42 47 52 57 EKTH07 BTUh 5250 5540 6300 6899 7620 WATTS 509 518 540 549 580 AMPS 2.4 2.5 2.5 2.6 2.7 EKTH09 BTUh 6004 6399 8100 8647 9244 WATT...

PACKAGED TERMINAL A/C SErviCE Manual Heat Controller 13 Controller Functions and Operating Methods The relationship between Centigrade and Fahrenheit is: Tcentigrade=Tfahrenheit*1.8+3.2 a. Temperature Parameter n Indoor setting temperature (Tpeset) n Indoor ambient temperature (Tamb) B. System Basic...

Heat Controller SErviCE Manual Packaged Terminal A/C 14 Controller Function and Operating Method continued 7. Open circuit and short circuit of temperature sensor If the temperature sensor has an open circuit, it will send an error signal. The error signal is displayed (see table below). If malfunct...

PACKAGED TERMINAL A/C SErviCE Manual Heat Controller 15 D. Special Functions and Features The PTAC unit is designed to be operated by the unit’s main control panel, however, factory installed connections are included to allow the PTAC to operate via remote thermostat or energy management input (fron...

PACKAGED TERMINAL A/C SErviCE Manual Heat Controller 17 Wall Thermostat Connections A standard low voltage wall thermostat can be wed with the PTAC unit’s factory installed terminal. Multiple PTACs can even be connected together on a single wall thermostat.

Heat Controller SErviCE Manual Packaged Terminal A/C 18 Typical Wiring Diagram

PACKAGED TERMINAL A/C SErviCE Manual Heat Controller 21 DiP SWiTCHES Auxiliary dip switch controls are located behind front panel, through an opening below the control panel. Dip switches are accessible without opening the control box. Unit must be powered OFF to effectively change their status. Fac...

Heat Controller SErviCE Manual Packaged Terminal A/C 22 f. protective features 1. Frost Protection Mode (heat pump): When the compressor is running under wired controller’s heating signal. If T outer tube ≤ 28°F (-2°C) is detected for 1 min- ute successively, the compressor and outdoor fan will stop...

PACKAGED TERMINAL A/C SErviCE Manual Heat Controller 23 Electric Circuit Diagram Packaged Terminal Air Conditioner Packaged Terminal Air Conditioner 55555 If the above electric circuit diagram has changed, please refer to it provided on the body Electric Circuit Diagram This electrical diagram is su...

Heat Controller SErviCE Manual Packaged Terminal A/C 24 POWEr COnnECTiOn OPTiOnS Appropriate power cord accessory kit is determined by the voltage, and amperage of the branch circuit. The unit does not come with a power cord (or hard wire kit) . An accessory power cord kit must be ordered to connect...

PACKAGED TERMINAL A/C SErviCE Manual Heat Controller 25 Preventative maintenance is essential to proper unit operation, efficiency and longevity. To ensure equipment operates properly, it must be properlymaintained. Equipment operation should be checked and verified several times during each year. D...

Heat Controller SErviCE Manual Packaged Terminal A/C 26 Window Type Series Window Type Series COOLING HEATING 11200/11600 10000/10300 1180/1220 1130/1160 1484 1669 6.93 8.19 Fan Type-Piece Diam eter-Length in. (m m ) φ7.72X 3.24 Evaporator Pipe Diam eter in. (m m ) φ0.25 Row-Fin Gap in. (mm) 3-0.55 ...