Harman P61 - Manual - manualsarea.com

Page 3 - SuITAblE FOr MObIlE hOME INSTAllATIONS.; SAVE THESE INSTRUCTIONS; harman home heating; 52 Mountain House Road; Specifications; Table of Contents

3 Please read this entire manual before you install and use your new room heater. Failure to follow instructions may result in property damage, bodily injury, or even death. SuITAblE FOr MObIlE hOME INSTAllATIONS. SAVE THESE INSTRUCTIONS harman home heating 352 Mountain House Road Halifax, PA 17032 ...

Page 4 - Assembly and Installation

4 unpacking The P61 is bolted to the skid to prevent movement during shipping. To free the stove from the skid you must remove the hold-down bolts in the rear of the pedestal base. removing or Installing rear cover panels To remove the rear cover panels, loosen the screws slightly and slide the cove...

Page 5 - Installation

5 Installing Place the stove on a non-combustible floor or a floor protector providing a minimum .84k value. Floor protection must extend 6 inches to the front, 6 inches to the sides and 1 inch to the rear of the stove. Place the stove away from combustible walls at least as far as shown in figures ...

Page 6 - venting; requirements for Terminating the venting

6 v venting requirements for Terminating the venting wArNINg: Venting terminals must not be recessed into a wall or siding. NOTE: Only pellet vent pipe wall pass-throughs and fire stops should be used when venting through combustible materials. NOTE: Always take into consideration the effect the pre...

Page 7 - vent Pipe; IMPOrTANT NOTICE

7 A combustion blower is used to extract the combustion gases from the firebox. This causes a negative pressure in the firebox and a positive pressure in the venting system as shown in fig. 6. The longer the vent pipe and more elbows used in the system, the greater the flow resistance. Because of th...

Page 11 - #8 Installing through the ceiling vent; M i n i m u m f l u e v e n t; CAuTION

11 #8 Installing through the ceiling vent Through the ceiling vent, follow the vent manufacturers recommendations when using wall and ceiling pass throughs. Fig. 14 (See Page 9 for corner installation clearances) M i n i m u m f l u e v e n t configuration It is recommended that outside air be insta...

Page 12 - Operation; MANuAl STArT uP

12 Operation Starting First Fire Be sure the power cord is plugged into a 120 volt receptacle. This can be verified by the red power light on the control panel. be sure there is no fuel or other combustibles in the ash pan prior to lighting.Fill the hopper with pellets. Fill the burn pot with pellet...

Page 13 - MANuAl IgNITION/OPErATION

13 when to use "Stove Temp Mode" In "Stove Temp Mode" the Stove Temp Dial determines the temperature of the stove. Heat output and fuel consumption will remain constant. This makes it possible to tell how long a hopper full of pellets will last. The distribution blower speed will var...

Page 14 - ESP CONTrOl

14 Feed adjuster Sets the maximum feed ra te Test Runs all motors at full speed for two minutes to check operation. After two minutes the stove will go to minimum burn a n d t h e b l o w e r s w i l l alternate from high to low every two minutes to remind you that you are still in "Test Mode...

Page 15 - It is recommended that the room sensor; room Sensor Installation; room Sensor and rear Shield Installation; NOTE: It is not recommended that the unit be; rear Shields

15 The room sensor is a small temperature sensor on the end of a 60" wire. This sensor is installed much like a standard wall thermostat. Because it is so small, it can be hidden along the trim of a doorway or even up the leg of a coffee table. There is a remote room sensor port on the rear of t...

Page 16 - Maintenance; The draft pressure switch senses the pressure in

16 removing Ashes: When approximately 1 ton of pellets has been burned, it will be necessary to empty the ash pan. Ashes should be placed in a metal container with a tight fitting lid. The closed container of ashes should be placed on a noncombustible floor or on the ground, well away from all combu...

Page 20 - wiring diagram

Page 21 - door Options; Optional Trim

21 door Options The door trim kit includes the door frame, the ash lip trim, and the ash door tile frame. Available in brushed stainless, gold or bright nickel, they add a beautiful accent to your stove. To install, lay the frame face down on a soft surface. Drill the four holes in the door using th...

Page 22 - OPTIONS; Side heat Shields

22 OPTIONS Side heat Shields Side heat shields are available to reduce the clearance to combustible materials. hopper Extension The hopper extension allows you to put more pellet fuel in the hopper and extends the burn time on one load of pellets. The hopper extension adds 60 pounds to the existing ...

Harman P61 - Manual

Table of Contents:

Summary

Other Harman Models