Harbor Breeze 41177 - User Manual

CEILING FAN

WALL CONTROL

ITEM #0745364

MODEL #41177

Wall Control

Qty. 1

Decor

Plate

Qty. 1

Standard

Plate

Qty. 1

Push-on

Connector

Qty. 2

Battery

Qty. 1

Receiver

Qty. 1

F

E

D

C

B

A

Serial Number

Purchase Date

ATTACH YOUR RECEIPT HERE

Harbor Breeze

®

is a registered trademark of LF, LLC.

All rights reserved.

Questions?

Call our customer service department

at 1-800-643-0067, 8 a.m. - 6 p.m., EST, Monday -

Thursday, 8 a.m. - 5 p.m., EST, Friday.

PREPARATION

SAFETY INFORMATION

HARDWARE CONTENTS

PACKAGE CONTENTS

Wire Connector

Qty. 3

Plate Screw

Qty. 2

AA

BB

Read instructions completely before installing the remote.

WARNING:

If the color of the household supply wires is different than what is referred to in the instructions below, a

professional electrician should determine proper wiring.

CAUTION:

•

Do not install in damp locations. For indoor use only.

•

Do not use with fans that have integrated remote controls.

•

Be sure the outlet box is properly grounded or that a green or bare (ground) wire is present.

•

This unit is intended to control a ceiling fan with electrical source of AC 110/120V, 60Hz.

•

To reduce the risk of fire or electric shock, do NOT use a full-range dimmer switch to control the fan speed.

•

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of

the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential

installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in

accordance with the instructions, may cause harmful interference to radio communications.

However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause

harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the

user is encouraged to try to correct the interference by one or more of the following measures: Reorient or relocate the

receiving antenna. --Increase the separation between the equipment and receiver. --Connect the equipment into an

outlet on a circuit different from that to which the receiver is connected. --Consult the dealer or an experienced radio/

TV technician for help. Any changes or modifications not expressly approved by the grantee of this device could void the

user’s authority to operate the equipment. FCC ID: KUJCE 10409

Tools required for assembly (not encluded): Electrical Tape and Phillips Screwdriver

XXXXXX