Hansgrohe 14801XX1 - Manual
Hansgrohe 14801XX1 – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
Table of Contents:
- Page 2 – HighArc Bar Faucets
- Page 3 – Do not allow either hose to twist.
- Page 5 – Allegro E Bar Faucet; Technical Specification; Recommended water pressure; Installation Considerations; water line may damage the ceramic cartridge.; English
- Page 6 – Turn on the water and check all connections for leaks.
- Page 7 – Données techniques; Pression d’eau recommandée; À prendre en considération pour l’installation; Robinet de bar HighArc; Français
- Page 8 – Assurez-vous qu’aucun des tuyaux
- Page 10 – Allegro E Robinet de Bar
- Page 11 – Ouvrez l’eau. Vérifiez l’étanchéité de tous les
- Page 12 – Replacement Parts
- Page 13 – Cleaning Recommendation for Hansgrohe Products; Recommandations pour le nettoyage des produits Hansgrohe
- Page 14 – Limited Lifetime Consumer Warranty
Bar Faucets
Installation Instructions / Warranty
Allegro E
14801XX1
HighArc
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
Summary
English Technical Specification Recommended water pressure 14.7 - 7.5 PSI Recommended hot water temp. 10° - 140° F* Hole size in mounting surface 1-1/” Max. mounting surface thickness 3/8” Max. flow rate . GPM *Please know and follow all applicable local codes when setting the temperature on the wat...
3 Installation Push the spout into place on the faucet. Tighten the spout set screw. Install the hot and cold supply lines to the stops with 3/8” compression fittings (included). Use two wrenches, as shown, to prevent the supply hoses from twisting. Place the faucet and sealing washer on the mount- ...
5 Allegro E Bar Faucet 14801XX1 Technical Specification Recommended water pressure 14.7 - 7.5 PSI Recommended hot water temp. 10° - 140° F* Hole size in mounting surface 1-1/” Max. mounting surface thickness 3/8” Max. flow rate . GPM *Please know and follow all applicable local codes when setting th...