Page 2 - Table of Contents
Table of Contents 1 1. Warranty and Service .................................................... 3 2. Preface ......................................................................... 4 3. Description of Warning Symbols ..................................... 5 4. Safety Notices .........................
Page 4 - Warranty and Service
3 The instructions on this manual are for the model(s) listed on the front cover. Before you start reading, check your product number by looking at the rear of your TV. Thank you for purchasing our Liquid Crystal Display Television (LCD TV). With this product, you will be able to enjoy superior audi...
Page 5 - Copyright; Preface
4 This manual is designed to assist users in setting up and using the LCD TV. Information in this document has been carefully checked for accuracy; however, no guarantee is given to the correctness of the contents. The information in this document is subject to change without notice. Copyright © Cop...
Page 6 - Electric Power Notice; Warning; Description of Warning Symbols
5 Electric Power Notice Electric power may cause personal injury and mechanical damage if it is misused. Although safety has been taken into consideration during the design and production of this product, electric shock or fire can result when the product is misused. To prevent potential danger, fol...
Page 7 - Power Supply Safety Notes; To avoid electric shocks, do not use an extended power cord or; Installation Safety Notes; Antenna; Safety Notices
6 Power Supply Safety Notes 1. To avoid electric shocks, do not use an extended power cord or an outlet that does not match this product's plug or leaves the plug exposed. 2. This product has a 3-pin grounded plug. The third pin connects to ground; do not remove it. 3. If the power cord or plug is d...
Page 9 - Optimal Viewing Distance
Page 10 - Important Safety Instructions; Do not block any ventilation openings. Install
9 Important Safety Instructions 1. Read these instructions.2. Keep these instructions.3. Heed all warnings.4. Follow all instructions. 5. Do not use this apparatus near water. 6. Clean only with a dry cloth. 7. Do not block any ventilation openings. Install in accordance with the manufacturer ’s ins...
Page 12 - Personal Safety
11 Personal Safety To avoid overloading the power supply, do not plug too many electrical devices into an outlet or extension cable. Dangerous high-voltage electric power compo-nents are located inside the TV. To avoid electric shock, do not disassemble the casing. Do not place or drop metals, small...
Page 13 - Installation
12 Installation To avoid damage to power circuits, do not place the TV in locations where there is excessive steam or dust. Do not place the TV on a bed, sofa, carpet, or in a sealed cabinet to avoid blocking the product's vents. Install the outdoor antenna far from power trans-mission lines to avoi...
Page 15 - FCC Compliance Statement; that to which the receiver is connected; : A shielded-type power cord is required in order to meet FCC; Regulatory Information
14 FCC Compliance Statement 1 This device complies with part 15 of the FCC Rules. Operation is sub-ject to the following two conditions: (1) This device may not cause harm-ful interference, and (2) this device must accept any interference received, including interference that may cause undesired ope...
Page 17 - Features; Introducing the TV
16 Thank you for purchasing this Liquid Crystal Display TV. Your LCD TV is designed to be safe, versatile, and easy to use. The design of the product is based on snail, which makes it a fun addition to any room.You can watch broadcast or cable television channels, and easily connect a VCR, VCD or DV...
Page 18 - Checking Package Contents
17 Make sure the following components are included in the box. Contact your vendor immediately if anything is missing or damaged. TV Wire Material Package GWA18 30 0V 80 C VW -1 E 7 7 8 7 4 Power Cord Power Adapter 4-IN-1 Cable RCA Jack x 3 S Jack x 1 Warranty and Service Warranty an d service manua...
Page 19 - Front View; Description; VOL –; Getting to Know Your TV
18 Front View Description Function 1 Signal sensor/ Power LED Receives signals from the remote control. 2 Adjust volume Press VOL+ to increase the volume. Press VOL – to decrease the volume. 3 Select channel Changes the channel. Press CH Z to increase the channel number. Press CH Y to decrease the c...
Page 20 - Input and Output Por ts
19 Input and Output Por ts Description Function 1 Headphone line out Connects to headphones or other audio device. 2 Left and right audio in (AV1) Connects to VCR/VCD/DVD player CVBS RCA left and right audio cables (white and red). 3 Video in (AV1) Connects to VCR/VCD/DVD player CVBS RCA video cable...
Page 21 - Connecting to an Antenna/Cable TV; Connect one end of the VHF/UHF (Antenna) or CATV cable to ANT; Getting Started
20 Connecting to an Antenna/Cable TV 1. Connect one end of the VHF/UHF (Antenna) or CATV cable to ANT Jack (VHF/UHF IN Jack) on the back of the TV. 2. Connect the other end of the VHF/UHF (Antenna) or CATV cable to the Antenna socket or CATV cable. NoteIf you cannot receive channels after connecting...
Page 22 - Connecting to AV Devices; Connecting to a VCR, VCD or DVD Player; B R W Y
21 Connecting to AV Devices Connect external devices such as VCD/DVD players or VCRs to the TV using the AV1 and AV2 ports on the back of the TV. Connecting to a VCR, VCD or DVD Player The illustration presented here shows how to connect your TV to a VCR, VCD or DVD player. Actual connections vary a...
Page 23 - Connecting to a Video Camera; coded cable to the appropriate connector on your device.; connector
22 Connecting to a Video Camera The illustration presented here shows how to connect your TV to a camcorder or other type of digital camera. Actual connections vary according to the make and model of the device. NoteThe cables are color-coded (black, red, white, yellow). Connect each color- coded ca...
Page 24 - Connecting Exter nal Speakers and Headphones; Notes
23 Connecting Exter nal Speakers and Headphones Headphones or external speakers may be used to listen to the TV instead of the built-in speakers. Connect your headphones to the speaker/headphone line out port as illustrated. Notes • External speakers or headphones are not included with the product. ...
Page 25 - Connecting the Power Adapter; Connect the power cord to the power adapter as illustrated.; Refer to the “Power Supply Safety Notes” on page 6.; AC power adapter
24 Connecting the Power Adapter 1. Connect the power cord to the power adapter as illustrated. 2. Plug the power adapter connector into the DC-IN on the rear panel of the TV. 3. Insert the three-pronged plug at the other end of the power cord into a power outlet. Refer to the “Power Supply Safety No...
Page 26 - Using the Remote Control; Using the TV
25 Using the Remote Control For best results, use the remote control within a distance of 5 meters from the front of the TV’s signal sensor. Do not exceed an angle of 30 degrees when pointing at the signal sensor. Refer to the following illustration. 3m 5m 3m 45 45 30 45 45 30 Using the TV 10
Page 27 - Tur ning the TV On and Off; POWER; POWER; Selecting Channels; CH UP; and; CH DOWN; on; Power button; Channel
26 Tur ning the TV On and Off 1. Press the POWER button; the power indicator LED turns off, indicating the power has been turned on. 2. Press the POWER button again; the power indicator LED shows red, indicating the TV is in standby (off) mode. Selecting Channels Press CH UP and CH DOWN on the contr...
Page 28 - Switching Source Signals; function is only available for AV2.; Adjusting the Volume; button; MUTE; Current source setting; Volume up
27 Switching Source Signals Press the SOURCE button on the remote control or the TV button on the control panel to select the incoming source signal. The current source setting CH xx appears on the top left corner of the screen; TV or AV appears on the bottom right corner of the screen. Note: The TV...
Page 29 - OSD Setting Menus; Settings
28 The On-Screen Display (OSD) menu system provides a quick and simple method to adjust your TV’s settings. This chapter describes how to change each of the available settings. The OSD can be used with either the remote control or the front con-trol panel. The following sections explain how to adjus...
Page 32 - MENU
31 Video Setting Press the MENU button to enter the OSD Main Menu screen. 1. Press the CH UP button or CH DOWN button to select Video Setting. 2. Press MENU to enter the Video Setting menu. Video Setting Hue G B R G R
Page 33 - Hue
32 Hue 1. Press the CH UP button or CH DOWN button to select Hue. 2. Press MENU to enter the Hue sub- menu. 3. Press the CH UP button to increase green and decrease red. 4. Press the CH DOWN button to decrease green and increase red. 5. Press MENU to confirm the setting and return to the Video Setti...
Page 34 - Saturation
33 Saturation 1. Press the CH UP button or CH DOWN button to select Saturation. 2. Press MENU to enter the Saturation submenu. 3. Press the CH UP button to increase the saturation. 4. Press the CH DOWN button to decrease the saturation. 5. Press MENU to confirm the setting and return to the Video Se...
Page 35 - Sharpness
34 Sharpness 1. Press the CH UP button or CH DOWN button to select Sharpness. 2. Press MENU to enter the SHARP- NESS submenu. 3. Press the CH UP button to increase the sharpness. 4. Press the CH DOWN button to decrease the sharpness. 5. Press MENU to confirm the setting and return to the Video Setti...
Page 36 - Press
35 Color Temperature 1. Press the CH UP button or CH DOWN button to select Color Temp. 2. Press MENU to enter the Color Tem- perature submenu. There are three default color temperatures to choose from. Standard Color Press the CH UP button or CH DOWN button to select Standard, then press MENU . Warm...
Page 38 - BASS
37 Treble 1. Press the CH UP button or CH DOWN button to select Treble. 2. Press MENU to enter the treble sub- menu. 3. Press the CH UP button to increase the treble. 4. Press the CH DOWN button to decrease the treble. 5. Press MENU to confirm the setting and return to the Audio Setting menu. TRE TR...
Page 40 - LL
39 Balance 1. Press the CH UP button or CH DOWN button to select Balance. 2. Press MENU to enter the Balance submenu. 3. Press the CH DOWN button to shift the balance to the left speaker. 4. Press the CH UP button to shift the balance to the right speaker. 5. Press MENU to confirm the setting and re...
Page 43 - CH; CH
42 TV/CATV 1. Press the CH UP button or CH DOWN button to select TV/CATV. 2. Press MENU to enter the TV/CATV submenu. Receiving Cable TV Press the CH UP button to select CATV, then press MENU . Receiving Broadcast TV Press the CH DOWN button to select TV, then press MENU . TV Setting TV/CATV TV TV C...
Page 45 - Auto Program
44 Auto Program 1. Press the CH UP button or CH DOWN button to select Auto Program. 2. Press MENU to enter the Auto Pro- gram Setting submenu. 3. Press the CH UP button or CH DOWN button to select ON or OFF and press MENU . The screen shows “Auto Program...” and the channel indicator increments from...
Page 46 - Manual Program
45 Manual Program 1. Press the CH UP button or CH DOWN button to select “Manual Program”. 2. Press MENU to enter the Manual Pro- gram submenu. 3. Press the CH UP button and the CH DOWN button to find the channel you want to add. Press MENU to select the channel. 4. Press MENU to exit, and then acces...
Page 48 - Favorite Channels
47 Favorite Channels 1. Press the CH UP button or CH DOWN button to select Favorites CH. Edit. 2. Press MENU to enter the Favorites CH. Edit submenu. 3. The screen displays the four favorite channels: M1, M2, M3, and M4. 4. Press the CH UP button and the CH DOWN button to select the channel number y...
Page 49 - Miscellaneous Setting
48 Miscellaneous Setting Press the MENU button to enter OSD Main Menu screen. 1. Press the CH UP button or CH DOWN button to select Mis- cellaneous Setting. 2. Press MENU to enter the Mis- cellaneous Setting menu. Main Menu ETC Miscellaneous Miscellaneous
Page 50 - Language; English
49 Language 1. Press the CH UP button or CH DOWN button to select Language. 2. Press MENU to enter the Language submenu. 3. The screen displays the available OSD languages: English and T-Chinese (Traditional Chinese). 4. Press the CH UP button and the CH DOWN button to select a language. The OSD lan...
Page 51 - Sleep Timer; off
50 Sleep Timer The sleep timer turns the TV off automatically after a set period of time. 1. Press the CH UP button or CH DOWN button to select Sleeper. 2. Press MENU to enter the Sleeper submenu. 3. The screen displays the available sleep timer setting: Off, 30, 60, 90, and 120 minutes. 4. Press th...
Page 52 - OSD Display; button is pressed. You can; All
51 OSD Display This setting allows you to set the amount of information that appears on the LCD screen when the DISPLAY button is pressed. You can choose from three settings: Off, Portion, or All. 1. Press the CH UP button or CH DOWN button to select OSD Display. 2. Press MENU to enter the OSD Dis- ...
Page 53 - Time Setting; This section shows you how to change your TV’s clock setting.
52 Time Setting This section shows you how to change your TV’s clock setting. 1. Press the CH UP button or CH DOWN button to select Time Setting. 2. Press MENU to enter the Time Setting submenu. 3. The screen displays the current set- ting. The hour is highlighted in yellow. 4. Press the CH UP butto...
Page 55 - Taking Care of Your TV
54 Turn the power off before you begin cleaning the TV. Use a clean lens cloth to remove dust and finger-prints from the screen. Do not wipe the shell of the TV with alcohol, methanol, gasoline or oil products to avoid the damaging the finish. Wipe the shell with a dry soft cloth and use neutral cle...
Page 56 - Troubleshooting
55 Situation Solutio n No picture and sound. • Connect the power cord properly. • Press the POWER button on the control panel or remote control. • Press the TV button to cycle through connected video sources. • Press CHANNEL UP or CHANNEL DOWN to switch to other TV stations. • Check the TV/CATV OSD ...
Page 58 - Specifications
57 Item Specification s LT01-10A1 LCD Panel Size 9.6-inch TFT Aspect Ratio 4:3 Best Resolution 800 (horizontal) x 600(vertical) Maximum Display Area 146.8 mm (H) x 195.4 mm (W) TV System NTSC Video System AV1: CVBS RCA jackAV2: S-Video or CVBS: 10-pin mini-DIN Audio System (Input) AV1: RCA left &...
Page 59 - Glossary
58 Aspect Ratio The ratio of width to height of a film, image or display screen. Broadcast TV Broadcasting video signals using high-frequency electromagnetic waves to distribute television channels to viewers (standard TV broadcast). CATV Community Antenna Television, the original name for cable TV....
