HANNspree 19 Inch Screen TFT LCD Monitor - Manual

6 SPECIAL NOTES ON LCD MONITORS The following symptoms are normal with LCD monitor and do not indicate a problem. Due to the nature of the fluorescent light, the screen may flicker during initial use. Turnoff the Power Switch and then turn it on again to make sure the flicker disappears.You may find...

7 PREFACE Thank you for purchasing a Hannspree Liquid Crystal Display Monitor (LCD Monitor). Please carefully read this manual in its entirety before setting up, using or operatingyour Monitor. To ensure the safe and correct installation and operations of the Monitor,it is important that the safety ...

BEFORE YOU OPERATE THE MONITOR FEATURES 19” screen TFT Color LCD MonitorCrisp, Clear DisplayRecommended Resolutions:19" Wide (16:10)1440 X 900 EPA ENERGY STAR ® Ergonomic DesignSpace Saving, Compact Case Design CHECKING THE CONTENTS OF THE PACKAGE The product package should include the following...

POWER POWER SOURCE: 1. Make sure that the power cord is the correct type required in your area.2. This LCD monitor has an Internal universal power supply that allows operation in either 100/120V AC or 220/240V AC voltage area (No user adjustment is required.) 3. Plug one end of the AC-power cord int...

ADJUSTING THE VIEWING ANGLE For optimal viewing it is recommended to look at the full face of the monitor, then adjustthe monitor’s angle to your own preference.Hold the stand so you do not topple the monitor when you change the monitor’s angle.You are able to adjust the monitor’s angle at 20 altern...

OPERATING INSTRUCTIONS GENERAL INSTRUCTIONS Press the power button to turn the monitor on or off. The other control buttons are located atfront panel of the monitor (See Figure 4). By changing these settings, the picture can beadjusted to your personal preferences. The power cord should be connected...

FRONT PANEL CONTROL Power Button: Press this button to switch the monitor on and off. Power Indicator (LED): Green — Power On mode.Orange — Power saving mode MENU / ENTER: 1. Activate the OSD menu or adjust the function settings and confirmation.2. Exit OSD menu when in volume OSD status. VOL - / VO...

HOW TO ADJUST A SETTING OSD Diagram OSD Description Brightness adjustment: Select the ψ Brightness ω option on the ψ Main Menu ω . Press enter and adjust the level. Contrast adjustment: Select the ψ Contrast ω option on the ψ Main Menu ω . Press enter and adjust the level. How to adjust screen posit...

TECHNICAL SUPPORT (FAQ) Q & A FOR GENERAL DEFECTS PROBLEM & QUESTION POSSIBLE SOLUTION Power LED is not on *Check the power cord. No Plug & Play or screenimage is stretch or seemsout of proportion *Check if the PC system is Plug & Play compatible.*Check if the Video Card is Plug &...

ERROR MESSAGE & POSSIBLE SOLUTION CABLE NOT CONNECTED : 1. Check whether the signal-cable is properly connected. If the connector is loose, tighten the connector screws. 2. Check the signal-cable’s connection pins for damage. INPUT NOT SUPPORT : Your computer has been set to an unsuitable displa...

APPENDIX SPECIFICATIONS İ 36W İ 1W * The above specification is subject to actual panel specification and is subject to changewithout prior notice. Note :Maximum Resolution is dependant on the support of your computer system and video card.Please see http://www.hannspree.com for more information. 21...

CONNECTOR PIN ASSIGNMENT 15 - Pin Color Display Signal Cable: 1 5 6 10 11 15 PIN NO. DESCRIPTION PIN NO. DESCRIPTION 1. Red 9. +5V 2. Green 10. Cable Detection 3. Blue 11. Ground 4. Ground 12. DDC-Serial Data 5. Ground 13. H-Sync 6. R-Ground 14. V-Sync 7. G-Ground 15. DDC-Serial Clock 8. B-Ground 24...