Haier QDP555SBN0TS - Installation Manual

Haier QDP555SBN0TS

Haier QDP555SBN0TS – Installation Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.

1 Page 1
2 Page 2
3 Page 3
4 Page 4
5 Page 5
6 Page 6
7 Page 7
8 Page 8
9 Page 9
10 Page 10
11 Page 11
12 Page 12
13 Page 13
14 Page 14
15 Page 15
16 Page 16
17 Page 17
18 Page 18
19 Page 19
20 Page 20
21 Page 21
22 Page 22
23 Page 23
24 Page 24
25 Page 25
26 Page 26
27 Page 27
28 Page 28
29 Page 29
30 Page 30
31 Page 31
32 Page 32
33 Page 33
34 Page 34
35 Page 35
36 Page 36
37 Page 37
38 Page 38
39 Page 39
40 Page 40
41 Page 41
42 Page 42
43 Page 43
44 Page 44
45 Page 45
46 Page 46
47 Page 47
48 Page 48
Page: / 48

Table of Contents:

  • Page 2 – For New Installations Only:; MATERIALS YOU WILL NEED:; Materials For New Installations Only:; Installation Preparation
  • Page 3 – PREPARE DISHWASHER ENCLOSURE; DRAIN REQUIREMENTS; DETERMINE DRAIN METHOD; If the answer to either question is YES, Method 1; CABINET PREPARATION; IMPORTANT; Always be sure disposer drain plug has been removed; Figure B; WARNING; Method 2 – “High Drain Loop” with Waste Tee or Disposer
  • Page 4 – Cabinet Preparation & Wire Routing; PREPARE ELECTRICAL WIRING; ELECTRICAL REQUIREMENTS; This appliance must have:; Grounding Instructions–Permanent Connection; For models equipped with power cord:
  • Page 5 – Water Line Connection; • If using a flexible braided supply hose, label; Turn page to begin dishwasher; PREPARE HOT WATER LINE; CAUTION
  • Page 6 – STEP 1 PREPARATION; Locate the items in the installation package:; Dishwasher Installation; STEP 3 REMOVE WOOD BASE,
  • Page 7 – Tip: Prevent unnecessary service call charges for; Position utility lines so they do not interfere with; Figure M; To
  • Page 8 – INSTALL TRIM PIECES; In this step you will need the trim pieces set aside in Step 1.; SLIDE DISHWASHER; IMPORTANT –; Do not push against; Top View
  • Page 9 – or; PUSH DISHWASHER INTO; INSTALL MOUNTING
  • Page 10 – PUSH DISHWASHER; Open and close the dishwasher door to be sure it; Tip: Prevent unnecessary service charges for; Check dishwasher alignment prior to opening; If your model has a rear leveling system,; LEVEL DISHWASHER
  • Page 11 – Brackets Wood Countertop; Figure X; Figure Y
  • Page 12 – Remove; CONNECT DRAIN LINE; Figure Z; IMPORTANT: Do not cut corrugated; portion of hose
  • Page 13 – CONNECT POWER SUPPLY; If a power cord with plug is already installed; Figure AD; PRETEST CHECKLIST; Review this list after installing your dishwasher to
  • Page 14 – DISHWASHER WET TEST; Start; POSITION SOUND; attachment screw holes.
  • Page 15 – LITERATURE; Tip: Reduce sound from under the dishwasher.; Figure AJ; Attachment; CHECK THE FOLLOWING
  • Page 17 – POUR VOTRE SÉCURITÉ; AVERTISSEMENT; ATTENTION; Instructions
  • Page 18 – MATÉRIAUX NÉCESSAIRES:; Pour une nouvelle installation:; PIÈCES FOURNIES DANS; Préparation pour l’installation
  • Page 19 – EXIGENCES RELATIVES AU; CHOIX DE LA MÉTHODE DE VIDANGE; Si vous répondez OUI à l’une ou l’autre de ces; PRÉPARATION DES ARMOIRES; Méthode n° 1 – Coupure anti-refoulement avec raccord en; Pour réduire les risques de choc électrique, d’incendie
  • Page 20 – Préparation des armoires et cheminement des fils; PRÉPARATION DU CÂBLAGE; Dans le cas des modèles dotés d’un cordon
  • Page 21 – PRÉPARATION DE; Tournez la page pour commencer; N’enlevez pas la base de bois avant d’être prêt à
  • Page 22 – Installation du lave-vaisselle
  • Page 23 – Placez la conduite d’eau et le câble électrique de manière à ce; INSTALLATION DU COUDE; Enlevez les deux
  • Page 24 – INSERTION AUX TROIS; IMPORTANT – Ne poussez pas sur le panneau
  • Page 25 – si le dessous du comptoir est en bois ou un; si
  • Page 26 – Si votre modèle est doté d’un système de nivellement; INSTLLATION DU; Conseil: Pour éviter des frais de réparation inutiles; MISE DE NIVEAU DU
  • Page 27 – Supports
  • Page 28 – RACCORDEMENT DU; Figure AA
  • Page 29 – BRANCHEMENT DE; Si un cordon d’alimentation pourvu d’une fiche est; LISTE DE CONTRÔLE; Passez en revue cette liste après l’installation de
  • Page 30 – VAISSELLE AVEC
  • Page 31 – RÉINSTALLATION DU; Conseil: Pour atténuer le bruit provenant du dessous; DOCUMENTATION
  • Page 33 – ALTO; PARA SU SEGURIDAD; – Asegúrese de entregar; ADVERTENCIA; PRECAUCIÓN; Lavavajillas Incorporado
  • Page 34 – HERRAMIENTAS NECESARIAS:; • Linterna; Sólo para Instalaciones Nuevas:; MATERIALES NECESARIAS:; Materiales Necesarios para Instalaciones Nuevas:; PIEZAS SUMINISTRADAS EN; gabinetes laterales; Preparación de la Instalación
  • Page 35 – REQUISITOS PARA EL DESAGÜE; DETERMINE EL MÉTODO DE DESAGÜE; Si la respuesta a cualquiera de estas preguntas; PREPARACIÓN DEL GABINETE; Método 1 – Brecha de aire con T de desechos o; Consejo: Evite costos innecesarios de llamadas al; PREPARE EL AMURADO DEL; El area de; Gabinetes; Lavavajillas
  • Page 37 – ible; Conexión de la Línea de Agua; Dé vuelta la página para iniciar la
  • Page 38 – • Con el lavavajillas en; Consejo: Asegúrese de que la puerta se abra y se; Instalación del Lavavajillas; • Tornillos
  • Page 39 – tornillos del; Zócalo; Consejo: Evite llamadas innecesarias al servicio
  • Page 40 – IMPORTANTE –
  • Page 41 – Instale los soportes de montaje en la parte superior; si el lado inferior de la mesada es de madera o de un; IMPORTANTE; si la mesada es de granito o de un material; Montaje superior; Montaje lateral
  • Page 42 – deslizante del estante; Figura U; NIVELE EL LAVAVAJILLAS; del gabinete
  • Page 43 – Mesada con superficie sólida; Soportes
  • Page 44 – Método 1 – Brecha de aire con T de desechos o el; CONECTE LA LÍNEA DE; de; Cutting Line; Línea de corte; No corte la parte
  • Page 45 – CONECTE EL SUMINISTRO; Si un cable de corriente con un enchufe ya está; LISTA DE CONTROL DE; Revise esta lista luego de instalar el lavavajillas, a fin
  • Page 46 – PRUEBA DE MOJADO; POSICIONE LA PIEZA DE
  • Page 47 – REEMPLACE EL ZÓCALO; Consejo: Reduzca el sonido debajo del lavavajillas.; TEXTOS; sin
Loading the manual

READ CAREFULLY

KEEP THESE INSTRUCTIONS

CHECK THE FOLLOWING

r

Tub trim does not interfere with the door

r

Dishwasher is square and level at both the top and bottom of the cabinet opening,

with no twisting or distortion of the tub or door

r

All 4 legs of the dishwasher are firmly in contact with the floor

r

Drain hose is not pinched between the dishwasher and adjacent cabinets or walls

r

Tub trim is fully seated on the tub flange

WARNING

CAUTION

FOR YOUR SAFETY

Read and observe all WARNINGS and CAUTIONS

shown throughout these instructions.
IMPORTANT –

Observe all governing codes and

ordinances.
•

Note to Installer

– Be sure to leave these instructions

for the consumer’s and local inspector’s use.

•

Note to Consumer

– Keep these instructions with

your Owner’s Manual for future reference.

•

Skill Level

– Installation of this dishwasher requires

basic mechanical, electrical and plumbing skills.

Proper

installation is the responsibility of the installer.

Product failure due to improper installation is not

covered under the GE Appliances Warranty. See

Warranty information.

•

Completion Time – 1 to 3 Hours

. New installations

require more time than replacement installations.

IMPORTANT –

The dishwasher MUST be installed to

allow for future removal from the enclosure if service is

required.
Care should be exercised when the appliance is

installed or removed, to reduce the likelihood of

damage to the power supply cord.
If you received a damaged dishwasher, you should

immediately contact your dealer or builder.
Optional Accessories – See the Owner’s Manual for

available custom panel kits.
Your dishwasher is a water heating appliance.

31-4000211

Rev 1

05-19 GEA

BEFORE YOU BEGIN

Read these instructions completely and carefully.

• To reduce the risk of electric shock, fire, or injury to

persons, the installer must ensure that the dishwasher is

completely enclosed at the time of installation.

• FOR PERSONAL SAFETY: Remove house fuse or open

circuit breaker before beginning installation. Do not use

an extension cord or adapter plug with this appliance.

• The improper connection of the equipment grounding

conductor can result in a risk of electric shock. Check

with a qualified electrician or service representative if

you are in doubt that the appliance is properly grounded.

• If house wiring is not 2-wire with ground, a ground

must be provided by the installer. When house wiring

is aluminum, be sure to use UL-Listed anti-oxidant

compound and aluminum-to-copper connectors.

• To reduce the risk of electric shock, fire, or injury to

persons, the installer should check to ensure that wires

are not pinched or damaged, the house wiring is attached

to the junction box bracket through a strain relief, and

all electrical connections made at the time of install (wire

nuts) are contained inside of the junction box cover.

Do not remove wood base until you are ready to install

the dishwasher. The dishwasher will tip over when the

door is opened if base is removed.

While performing installations described in this booklet,

gloves, safety glasses or goggles should be worn.

See your Owner’s Manual for details on how to contact us regarding installation questions

Built-In Dishwashers

Installation

Instructions

"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.

Other Manuals for Haier QDP555SBN0TS

Summary

Page 2 - For New Installations Only:; MATERIALS YOU WILL NEED:; Materials For New Installations Only:; Installation Preparation

PARTS SUPPLIED IN INSTALLATION PACKAGE: • Junction box cover and #10 hex-head screw • Hose clamp • Drain hose (approximately 58” long) • Drain hose hanger • 2 #8-18 hex head screws to secure brackets to washer tub frame • 1 top trim piece (on some models) • 2 side trim pieces • 2 mounting brackets f...

Page 3 - PREPARE DISHWASHER ENCLOSURE; DRAIN REQUIREMENTS; DETERMINE DRAIN METHOD; If the answer to either question is YES, Method 1; CABINET PREPARATION; IMPORTANT; Always be sure disposer drain plug has been removed; Figure B; WARNING; Method 2 – “High Drain Loop” with Waste Tee or Disposer

PREPARE DISHWASHER ENCLOSURE • The rough cabinet opening must be at least 24” deep, 24” wide and approximately 34-1/2” high from floor to underside of the countertop. • The dishwasher must be installed so that drain hose is no more than 12’ in length for proper drainage. • The dishwasher must be ful...

Page 4 - Cabinet Preparation & Wire Routing; PREPARE ELECTRICAL WIRING; ELECTRICAL REQUIREMENTS; This appliance must have:; Grounding Instructions–Permanent Connection; For models equipped with power cord:

Installation Preparation Cabinet Preparation & Wire Routing • The wiring may enter the opening from either side, rear or the floor within the shaded area illustrated above in Figure E and defined in Figure A. • Cut a 1-1/2" maximum diameter hole to admit the electrical cable. Edges of hole s...

Other Haier Models