Haier HCC2230AGS - Installation Manual

Page 2 - Installation Instructions; Advance Preparation

Installation Instructions INSTALLATION AND SERVICE MUST BE PERFORMED BY A QUALIFIED INSTALLER. IMPORTANT: SAVE THESE INSTRUCTIONS FOR LOCAL ELECTRICAL INSPECTOR'S USE. READ AND SAVE THESE INSTRUCTIONS FOR FUTURE REFERENCE. Advance Preparation • For proper operation of a gas appliance, the air necess...

Page 3 - Provide an Adequate Gas and Electrical Supply

• A range hood with minimum 350 CFM that projects at least 5” beyond front of cabinets can reduce risk of burns caused by reaching over heated surface units. Provide an Adequate Gas and Electrical Supply • Installation must comply with local codes. In the absence of local codes, the gas cooktop must...

Page 4 - Tools and Materials Needed; Cutting the Countertop

Tools and Materials Needed MATERIALS YOU WILL NEED: Joint Sealant Pipe Fittings Shut-Off Valve CSA-Approved Flexible ½” or ¾” Gas Line TOOLS YOU WILL NEED: Pencil Phillips-Head Screwdriver Ruler Safety Glasses Saber Saw Pipe Wrench 1/8” Drill Bit & Electric or Hand Drill Cutting the Countertop 1...

Page 6 - Installing the Pressure Regulator

5) Secure cooktop from underneath with the supplied clips and screws (see Figure 12). Installing the Pressure Regulator WARNING: Never reuse old flexible connectors. The use of old flexible connectors can cause gas leakage and personal injury. Always use new flexible connectors when installing a gas...

Page 8 - Electrical Connection

6) After connecting the cooktop to the gas supply, make sure all burners knobs are in the OFF position and check the system for leaks with a manometer. If a manometer is not available, turn on the gas supply and use a liquid leak detector (or soap and water) at all joints and connections to check fo...

Page 9 - Assembling the Burners

Assembling the Burners The electrode of the electronic ignition system is positioned above the surface of the burner base. Do not remove a burner cap or touch the electrode of a burner while another is turned on. Damage or electrical shock may occur. 1. Place burner heads over the burner base. Make ...

Page 10 - LP/Propane Gas Conversion

3. Operation of the electric igniters should be tested after the cooktop and supply line have been carefully checked for leaks and the cooktop has been connected to the electrical power. To check igniters, push and turn a burner valve to the LITE position. All spark igniters will make a series of sp...

Page 16 - Do Not Return This Product To The Store; IMPORTANT; Ne pas Réexpédier ce Produit au Magasin; IMPORTANTE; No regrese este producto a la tienda

IMPORTANT Do Not Return This Product To The Store If you have a problem with this product, please contact the “Haier Customer Satisfaction Center” at 1-877-337-3639. DATED PROOF OF PURCHASE, MODEL #, AND SERIAL # REQUIRED FOR WARRANTY SERVICE IMPORTANT Ne pas Réexpédier ce Produit au Magasin Pour to...

Haier HCC2230AGS - Installation Manual

Table of Contents:

Other Manuals for Haier HCC2230AGS

Summary

Other Haier Models