Haier QAS740RM1SS - Installation Manual

BEFORE YOU BEGIN

Read these instructions completely and carefully.

•

IMPORTANT

— Save these

instructions for local inspector’s use.

•

IMPORTANT

— Observe all

governing codes and ordinances.

•

Note to Installer

– Be sure to leave these

instructions with consumer.

•

Note to consumer

– Keep these

instructions for future reference.

• Skill level – Installation of this appliance

requires a qualified installer or electrician.

• Proper installation is the responsibility of the

installer.

• Product failure due to improper installation is

not covered under warranty.

Installation Instructions
Compact Electric Ranges

MATERIALS YOU MAY NEED

TOOLS YOU WILL NEED

(UL Listed 40 AMP)

4-Wire Cord 4’ long OR

3-Wire Cord 4’ long

Squeeze Connector

(For Conduit

Installations Only)

Drill with 1/8” Bit
Safety Glasses
Adjustable Wrench
Level

Tin Snips
Tape Measure
Pliers
1/4” Nut Driver

Questions? Call GE Appliances at 1.800.GE.CARES (1.800.432.2737) or visit
GEAppliances.com. In Canada, call 1.800.561.3344 or visit GEAppliances.ca.

DIMENSIONS AND

CLEARANCES

Provide adequate clearances between the

range and adjacent combustible surfaces.

These dimensions must be met for safe use of

your range.
Installation of a listed microwave oven or

cooking appliance over the cooktop shall

conform to the installation instructions packed

with that appliance.

NOTE:

Use a 4’ power cord to prevent

interference with the storage drawer. Power cords
4

1

»

2

’ to 6’ long may have to be dressed to allow for

proper drawer closing.

MINIMUM DIMENSIONS BETWEEN COOKTOP,
WALLS AND ABOVE THE COOKTOP:

A.

Make sure the wall covering, countertop,
flooring and cabinets around the range can
withstand the heat (up to 200°F) generated by
the range.

B.

Allow 30” minimum clearance between surface
units and bottom of unprotected wood or metal
cabinet, or allow a 24” minimum when bottom
of wood or metal cabinet is protected by no
less than 1/4” thick flame retardant millboard
covered with not less than No 28 MSG sheet
metal, (.015”), .015” thick stainless steel, .024”
aluminum or .020” copper.

C.

This appliance has been approved for 0”
spacing to adjacent surfaces above the
cooktop. However, a 2” minimum spacing to
surfaces less than 15” above the cooktop and
adjacent cabinet is recommended to reduce
exposure to steam, grease splatter and heat.

To reduce the risk of burns or fire when reaching over hot surface elements, cabinet storage
space above the cooktop should be avoided. If cabinet storage space is to be provided above the
cooktop, the risk can be reduced by installing a range hood that projects at least 5” beyond the
front of the cabinets. Cabinets installed above the cooktop must be no deeper than 13”.

25 7/8" w/o handle

28 1/8" w/ handle

4 3/4” or 1/4"

36” +/- 1/2”

45 5/8”

24”

0” Min.

to cabinets

below

cooktop

30”

Min.

24”

13”

8”

24”

4”

19 3/8”

24”

2 5/16”

Side Wall

See

Note C

See Note C

(both sides)

Electrical

supply

36”

FOR YOUR SAFETY:

WARNING

Before beginning

the installation, switch power off at
service panel and lock the service
disconnecting means to prevent power
from being switched on accidentally.
When the service disconnecting
means cannot be locked, securely
fasten a prominent warning device,
such as a tag, to the service panel.

If you did not receive an anti-tip bracket with your
purchase, call 1.800.626.8774 to receive one at
no cost. (In Canada, call 1.800.561.3344.) For
installation instructions of the bracket,
visit:

GEAppliances.com

.

(In Canada,

GEAppliances.ca

.)

Anti-Tip Bracket

Kit Included

• A child or adult can tip the range and be killed.
• Verify the anti-tip bracket has been properly
installed and engaged.
• Ensure the anti-tip bracket is re-engaged when
the range is moved.
• Do not operate the range without the anti-tip bracket
in place and engaged.
• Failure to do so can result in death or serious burns
to children or adults.

Tip-Over Hazard

WARNING