Haier HWM80-113S- User Manual

Overflow filter Lint filter If the extra hose is too long, cut it eitherat point A or B. <10cm B A > 30mm <1.5m 4 Installation and adjustment Please install and adjust the machine according to the requirement ofthe manual. It is very important to your security and correct operating the mach...

5 How to change the direction of the drain hoses Figure 1 indicates the ex factory installationposition of the drain hose. Extend the drain hose from the side of spin tub. Take off the drain hose from the hanging holeof the cabinet. Pull the drain hose fixing hook outwards gently to take out the dra...

Install the water inlet hose; Select the water level Select water level according to thequantity of the laundries. Set the water level adjusting lever to needed line. Insert the water inlet hose into the water-fillingentrance on the control pane directly.(pull itout to dismantle it) Water inlet hose...

7 Preparation before washing1.Connect the water inlet hose.2.Confirm that the washing machine is earthed reliably . Then insert the power plug into the receptacle. Do not connect the earth terminal to the gas pipe and tap water pipe.3.Put down the drain hose . 4.Slanting or uneven ground may result ...

8 The capacity of washing and spinning of the machine refer to the largest weight of thestandard laundries under dry condition that can be washed or spinned in one time. Laundriesquantity in one washing cycle shall be lowerthan the rated capacity. The thickness ,size , type of the cloth will influ-e...

Figure 5 DRAIN STRONG STANDARD WASH SELECTOR 9 Washing sequence Wash Figure 4 OFF WASH TIMER Figure 3 DRAIN STRONG STANDARD WASH SELECTOR 1.Water-filling selector (1) Set the water-filling selector at the "WASH" side. (Figure 1) (2) Set the water level adjusting lever to needed line. 2. Fill...

10 Midway spinning Push Push Proper Proper Outer cover of The spin tub Inner cover of The spin tub The laundries are slanting Gland No gland (1) Open the outer cover of the spin tub.(2) Set the water-filling selector control rod at the "SPIN" side. Fill water for about 1 minute. If the water...

11 Rinse with stored water Rinse with water-filling 1. Put the laundries into the wash tub. Select suitable current according to the laundries. 2. Fill water to preset water level. 3. Rinse Adjust the wash timer to 2-3 minutes to do rinsing. When the laundries quantity is below 2.4kg, please use ...

12 1. Put the laundries into the spin tub evenly and smoothly. 2. Press the gland in the tub properly. Close the inner and outer cover of the spin tub. 3. Spin Select suitable spin time according to the laundries, and do spinning. During spinning, if there's abnormal sound, it is generally owing to ...

13 After using, please clean the lint and foreign materials of the lint filter and overflow filter in time. Otherwise it may influence your using the machine.Please first pull off the power plug from the receptacle before cleaning. 1 Take off the overflow filter. As indicated in the figure, nip the ...

15 Trouble-shooting Answers to question When the remained water is frozen If the laundries fall to the outer side of the spin tub,please take them out immediately. 1.DismantleAs indicated in the figure, push the point marked with " " to pull the spin tub frame to oblique upwards to dismantle...

16 Trouble-shooting Answers to question (If there's breakdown, please pull off the power plug before checking) The following phenomena are not breakdowns sometimes. Please confirm again before sending it to repair. If there are real breakdowns, please come to the special maintenance department or af...

Water inlet hose Water-filling jointer Gland Lint filter Packing list Twin-tub washing machine Name Quantity User's manual One piece One piece One piece One piece One piece One set Specification 17 Water level/Water quantity (about) Maximum/55L Medium/46L Minimum/36L Injection pressure(MPa ) 0.02 0....