Haier HWM70-928NZP- User Manual

6 Installation and adjustment Please install and adjust the machine according to the requirement of the manual. It isvery important to your security and correct operating the machine. 1. Open the top lid of the washing machine. 2. Put the inner cover component on the outer tub cover, aiming the inne...

7 The drainage shall be smooth with the drain hose. Usage of the drain hose <10cm 1. The height of the drain hose shall be less than 10cm, or the drainage will not be smooth, and cost such long time that the machine may stop at mid way. 3. If the drain hose is too long, cut it at mid point. To ma...

8 How to change the direction of the drain hose 1. Please lean the washing maching gently down on soft items,such as towel, cloth, blanket, etc.(as indicated in Figure 1) 2. Dismantle the bottom plate.(as indicated in Figure 2) 3. Nip the end of the drain hose and remove the hook of fixing the drain ...

9 Connection between the water inlet hose jointer and the water faucet Install the water inlet hose Confirm the water faucet Water tap, suitable Outlet end sur face >10mm Water tap, not suitable It is required that the front end shall be longer than 10mm.The outlet end surface of the tap shall be ...

10 Do not take off the water absorption cushion. 1. Please check if the cushion is dropped or damaged before each usage. If it happens please contact our after-sale department immediately.Put the nut of the water inlet hose on the valve 2. jointer. Fasten the nut. Swing it gently to confirm if it’s s...

11 Preparation before washing Preparation before washing Connect the water inlet hose. 1. Confirm that the washing machine is earthed reliably. Then 2. insert the power plug into the receptacle. Do not connect the earth terminal to the gas pipe and tap water pipe. Put down the drain hose. 3. Slanting...

12 Put in the laundries The capacity of washing and spinning of the machine refer to the largest weight ● of the standard laundries under dry condition that can be washed or spinned in one time. One time washing quantity shall be lower than the rated capacity.The thickness, size, type of the cloth w...

13 Use the operation buttons Description of the function of the buttons 1 1 K J Off Flashing: indicate the running program On: indicate the program about to run,or indicate the selected mode The function is intended for children safety and preventing the washing program from ● accidental changes by ...

15 It displays program detected. ● It displays remained reser ve time (hour). ● It displays abnormal symbol in abnormal situation. ● Press the button to select the reser ve time (2h-24h). ● Press the button can display the reser ve state. ● K LCD screen J “DELAY” button Steps of using the operation ...

16 Before washing, please fold up the laundry as needed, then put the laundry into the inner tub, ● flat and neat.These fabrics are not washable: ● 1. Fabrics that deform when soaked in water;2. Fabrics that shrink, discolor or go through other exterior changes when soaked in water;3. Fabrics that lo...

17 Disposal after washing After using, please clean the lint and foreign materials of the lint filter etc. in time. ● Other wise it may influence your using the machine.Please first pull off the power plug from the receptacle before cleaning. ● Clean the detergent box and set it on the control panel se...

18 Trouble-shooting answer to question Common phenomena Phenomena The reason How to settle The digitron displays E0. The top lid is opened during ● reser ve procedure. Close the top lid. ► The drainage cannot work, or is too slow. The digitron displays E1. Is the drain hose put down? ● Is the drain ...

19 Name Quantity Storage position User’s manual One Inside the document bag Components of the water inlet hose One Inside the accessory bag Bottom plate One Between the upper cushion of the washing machine package and the upper seal of the package carton Tapping screw One Inside the accessory bag In...