Haier HWM60-15P- Manual

Overflow filter Lint filter <10cm 4 Installation and adjustment Please install and adjust the machine according to the requirement ofthe manual. It is very important to your security and correct operating the machine. Install the lint filter After opening the package,please take out the lint filt...

5 Extend the drain hose from the rear side How to change the direction of the drain hoses Figure 1 indicates the leave factory installationposition of the drain hose. Put soft items on the ground. Lean the machine down gently with the front surface facing the ground. Take off the drain hose from the...

6 Preparation before washing1.Connect the water inlet hose.2.Confirm that the washing machine is earthed reliably . Then insert the power plug into the receptacle. Do not connect the earth terminal to the gas pipe and tap water pipe.3.Put down the drain hose . 4.Slanting or uneven ground may result ...

7 The capacity of washing and spinning of the machine refer to the largest weight of thestandard laundries under dry condition that can be washed or spinned in one time. Laundriesquantity in one washing cycle shall be lowerthan the rated capacity. The thickness ,size , type of the cloth will influ-e...

8 Washing sequence Wash Spin timer Wash timer Wash selector Buzzer Water-filling entrance (To set to below 2 minute, first set to 6 minute then turn it back. it can increase the service life of the timer). (Standard current, strong current) (The buzzer will ring when the washing finishes) (to set to...

9 Midway spinning Push Push Proper Proper Outer cover of The spin tub Inner cover of The spin tub The laundries are slanting Gland No gland (1) Open the outer cover of the spin tub.(2) Set the water-filling selector control rod at the "SPIN" side. Fill water for about 1 minute. If the water ...

Rinse with stored water Rinse with water-filling 1. Put the laundries into the wash tub. Select suitable current according to the laundries. 2. Fill water to preset water level. 3. Rinse Adjust the wash timer to 2-3 minutes to do rinsing. When the laundries quantity is below 2.4kg, please use "S...

1. Put the laundries into the spin tub evenly and smoothly. 2. Press the gland in the tub properly. Close the inner and outer cover of the spin tub. 3. Spin Select suitable spin time according to the laundries, and do spinning. During spinning, if there's abnormal sound, it is generally owing to sla...

12 After using, please clean the lint and foreign materials of the lint filter and overflow filter in time. Otherwise it may influence your using the machine.Please first pull off the power plug from the receptacle before cleaning. 1 Take off the overflow filter. As indicated in the figure, nip the ...

14 When the remained water is frozen Prevent the freezing (be sure to discharge the water completely after using) After complete draining, set the "WASH SELECTOR" at "STRONG" or "STANDARD". If it is set at "DRAIN", it will be rather difficult for the frozen water to m...

15 (If there's breakdown, please pull off the power plug before checking) The following phenomena are not breakdowns sometimes. Please confirm again before sending it to repair. If there are real breakdowns, please come to the special maintenance department or after-sale service department of our co...

16 Water inlet hose Gland Lint filter Packing list Twin-tub washing machine Name Quantity User's manual One piece One piece One piece One piece One set Water level/Water quantity (about) Maximum/43L Medium/36L Minimum/30L Injection pressure(MPa ) 0.02 0.2 Specification Water-filling jointer One piec...