Haier HWM150-0623S- Manual

Page 2 - Contents

Contents Safety precautions Installation and adjustment Preparation before washing The musts in washing Usage of the detergent Washing sequence Disposal after washing Packing list *Specification Names of the parts Trouble-Shooting *Answer to question

Page 3 - Meaning and description of the symbols; Warning sign; Names of the parts

Meaning and description of the symbols Warning sign Forbidding sign Contents marked with that symbol are related to the safety of the product and the personal safety of the users. Please operate in strict conformity to the contents, otherwise it may cause damage of the machine or injure the personal...

Page 4 - Safety precautions

Safety precautions Please insert the power cord into special receptacle with rated vol-tage.Be sure to use single-phase three pins receptacle.The earthing terminal of the receptacle must be earthed reliably.If possible,please adopt electric leakage protector. When the machine is normallyusing, pleas...

Page 6 - Installation and adjustment; Install the lint filter; The drainage shall be smooth with the drain hose.; Do not tramp or press the drain hose.

P u t t h e u n d e r s i d e o f t h e l i n t f i l t e r i n t o o v e r f l o w f i l t e rt h e n p u s h t h e u p s i d e i n t o o v e r f l o w f i l t e r A f t e r i n s t a l l a t i o n , p l e a s e r e f e r t h a t t h e l i n t f i l t e r i n s t a l l e d t o t h e r i g h t s t a...

Page 7 - To dismantle the water inlet pipe,; How to change the direction of the drain hoses; Extend the drain hose from the side of spin tub; Install the water inlet hose Select the water level

Insert the water inlet hose into the water-fillingentrance on the control panel To dismantle the water inlet pipe, just push the control handle as indicated in thefigure and pull it out How to change the direction of the drain hoses Figure 1 indicates the ex factory installationposition of the drain...

Page 8 - Preparation before washing; Pay attention to followings before washing the laundries

Preparation before washing1.Connect the water inlet hose.2.Confirm that the washing machine is earthed reliably . Then insert the power plug into the receptacle. Do not connect the earth terminal to the gas pipe and tap water pipe.3.Put down the drain hose . 4.Slanting or uneven ground may result in...

Page 9 - The musts in washing; How to use the whitener; How to use the washing powder; Usage of the detergent

The capacity of washing and spinning of the machine refer to the largest weight of the standard laundries under dry condition that can be washed or spined in one time. Laundries quantity in one washing cycle shall be lower than the rated capacity. The thickness ,size , type of the cloth will influ-e...

Page 10 - Washing sequence; Wash

1 Fill selection (1) Set fill selection to Wash side . Figure 1 (2 )Adjust water level rod to a position as needed. 2 Fill water and add solved powder detergent until water reaches a suitable level. Figure 2 It begin to wash to dispense detergent uniformly. 3 Put in the wash load, and supplement wat...

Page 11 - Midway spinning

1 2 Set the fill selector handle on spin side and fill water for about 1 min. Close the spin tub outer cover and spin for about 1 - 2 min. In case water flows out from wash tub side due to too much inflow, please turn down the water tap a bit. INLET SELECTOR Midway spinning Push Push Proper Proper O...

Page 13 - Spinning

1. Put the laundries into the spin tub evenly and smoothly. 2. Press the gland in the tub properly. Close the inner and outer cover of the spin tub. 3. Spin Select suitable spin time according to the laundries, and do spinning. During spinning, if there's abnormal sound, it is generally owing to sla...

Page 14 - Cleaning the overflow filter; Cleaning the lint filter; Disposal after washing; Take off the overflow filter.

Page 4 After using, please clean the lint and foreign materials of the lint filter and overflow filter in time. Otherwise it may influence your using the machine.Please first pull off the power plug from the receptacle before cleaning. Cleaning the overflow filter The lint filter must be used during...

Page 16 - Trouble-shooting Answer to question; When the remained water is frozen

Trouble-shooting Answer to question When the remained water is frozen 2~3L Below 50 Prevent the freezing (be sure to discharge the water completely after using)After complete draining, set the "DRAIN SELECTOR" at "OFF" . If it is set at "DRAIN", it will be rather difficult fo...

Page 17 - Trouble-shooting Answer to question; Phenomena The reason; There may be some

Trouble-shooting Answer to question (If there's breakdown, please pull off the power plug before checking) The following phenomena are not breakdowns sometimes. Please confirm again before sending it to repair. If there are real breakdowns, please come to the special maintenance department or after-...

Page 18 - Packing list; Twin-tub washing machine; Specification

Water inlet hose Gland Packing list Twin-tub washing machine Name Quantity User's manual One piece One piece One piece One set Specification Rated washing/spinning capacity(kg) Water level Water quantity about (L) Maximum/99 Medium/79 Minimum/59 12.0/7.0 Injection pressure(MPa) 0.02~0.2 16

Table of Contents:

Other Manuals for Haier HWM150-0623S

Summary

Other Haier Models