Haier HWM130-0713S- Manual

Page 2 - Contents

Contents Names of the parts - - - - - - - - - - - - - - - - - 1Safety precautions - - - - - - - - - - - - - - - - - 2Installation and adjustment - - - - - - - - - - - 4Preparation before washing - - - - - - - - - - 6The musts in washing - - - - - - - - - - - - - - - 7Usage of the detergent - - - - -...

Page 3 - Meaning and description of the symbols; Warning sign; Names of the parts

1 Meaning and description of the symbols Warning sign Forbidding sign Contents marked with that symbol are related to the safety of the product and the personal safety of the users. Please operate in strictconformity to the contents, otherwise it may cause damage of the machine or injure thepersonal...

Page 4 - Safety precautions

Safety precautions Please insert the power cord into special receptacle with rated vol-tage. Be sure to use single-phase three pins receptacle. The earthing terminal of the receptacle must be earthed reliably. If possible, please adopt electric leakage protector. When the machine is normallyusing, p...

Page 6 - Installation and adjustment; Usage of the drain hose; The drainage shall be smooth with the drain hose.; Voltage change; the safeguard bag to expose the connectors.; Above all the steps must be done by the special serviceman.; Loosen the fastening screw and take off the back cover.

Installation and adjustment Please install and adjust the machine according to the requirement ofthe manual. It is very important to your security and correct operating the machine. 4 Usage of the drain hose If the extra hose is too long, cut it eitherat point A or B. B A > 30mm <1.5m The drai...

Page 7 - How to change the direction of the drain hoses; Extend the drain hose from the side of spin tub; Install the lint filter

Water inlet hose Water inlet Maximum Max Minimum Min Medium Med Water level indicator 5 How to change the direction of the drain hoses Install the water inlet hose; Select the water level Insert the water inlet hose into the water-fillingentrance on the control pane directly.(pull itout to dismantle...

Page 8 - Preparation before washing; Pay attention to followings before washing the laundries

Preparation before washing 6 Preparation before washing1.Connect the water inlet hose.2.Confirm that the washing machine is earthed reliably . Then insert the power plug into the receptacle. Do not connect the earth terminal to the gas pipe and tap water pipe.3.Put down the drain hose . 4.Slanting o...

Page 9 - The musts in washing; How to use the whitener; How to use the washing powder; Usage of the detergent

The musts in washing 7 The capacity of washing and spinning of the machine refer to the largest weight of thestandard laundries under dry condition that can be washed or spinned in one time. Laundriesquantity in one washing cycle shall be lowerthan the rated capacity. The thickness ,size , type of t...

Page 10 - Washing sequence; Wash

Washing sequence 8 Figure 4 Figure 1 Spin timer Wash timer (To set to below 2 minute, first set to 6 minute then turn it back. it can increase the service life of the timer). (To set to below 1 minute, first set to 2 minute then turn it back. it can increase the service life of the timer). Wash Figu...

Page 11 - Midway spinning

WASH SPIN Midway spinning Push Push Proper Proper Outer cover of The spin tub Inner cover of The spin tub The laundries are slanting Gland No gland (1) Open the outer cover of the spin tub.(2) Set the water-filling selector control rod at the "SPIN" side. Fill water for about 1 minute. If th...

Page 12 - Rinsing

Rinse with stored water Rinse with water-filling 1. Put the laundries into the wash tub. Select suitable current according to the laundries. 2. Fill water to preset water level. 3. Rinse Adjust the wash timer to 2-3 minutes to do rinsing. When the laundries quantity is a few , please use "Standa...

Page 13 - Spinning

1. Put the laundries into the spin tub evenly and smoothly. 2. Press the gland in the tub properly. Close the inner and outer cover of the spin tub. 3. Spin Select suitable spin time according to the laundries, and do spinning. During spinning, if there's abnormal sound, it is generally owing to sla...

Page 14 - Take off the overflow filter.; Cleaning the overflow filter; Cleaning the lint filter; Disposal after washing; Press the elastic piece at upper end of lint filter to; Elastic fixing

After using, please clean the lint and foreign materials of the lint filter and overflow filter in time. Otherwise it may influence your using the machine.Please first pull off the power plug from the receptacle before cleaning. 1 Take off the overflow filter. As indicated in the figure, nip the ela...

Page 16 - When the remained water is frozen; If the laundries fall to the outer side of the spin tub; Trouble-shooting Answer to question

When the remained water is frozen If the laundries fall to the outer side of the spin tub,please take them out immediately. If the laundries fall to the outer side of the spin tub Prevent the freezing (be sure to discharge the water completely after using)After complete draining, set the "DRAIN ...

Page 17 - Phenomena The reason

Trouble-shooting Answer to question (If there's breakdown, please pull off the power plug before checking) The following phenomena are not breakdowns sometimes. Please confirm again before sending it to repair. If there are real breakdowns, please come to the special maintenance department or after-...

Page 18 - Packing list; Twin-tub washing machine; Specification; Made in China

Water inlet hose Gland Packing list Twin-tub washing machine Name Quantity User's manual One piece One piece One piece One set 16 Specification Rated washing capacity kg Injection pressure(MPa) Rated spinning capacity kg 10.0 6.0 0.02~0.2 Rated washing power(W) Rated spinning power(W) 2 7 0 / 3 4 0 ...

Table of Contents:

Other Manuals for Haier HWM130-0713S

Summary

Other Haier Models