Haier HWD-D1200TXVE - Manual

Caution: protective gloves should be warn • Remove all the packing materials (including the foam base) to prevent vibration during use, as show in Fig. 1. On opening, water drops may be visible on the appliance. This is a normal phenomenon. • Check that the appliance is also supplied with the follow...

8 G. start/pause button When the washing machine is connected to the power socket and a programme is selected, touch this button to start operation. Touch this button again during operation to pause the programme. The display screen will flash and the machine will be paused. Press the button again a...

9 Programme selection guide NOTE: “O” indicates that softener can be added if need; “ ★ ” indicates that detergent must be added; “X” indicates that detergent must not added; “*” indicates cold water. 1) The wash temperature indicates the maximum temperature.2) The wash temperature refers to the max...

10 Preparing for a cycle Detergent selection Only special low foam detergent should be used in automatic drum washing machines. For blended or wool fabrics, special detergent should be used. Dry cleaning solvent should not be used. Caution: do not use too much detergent. laundry treatment • Sort out...

12 3. selecting washing programme To get the best wash, an appropriate washing programme should be selected according to the type of laundry. 4. Washing temperature settings Set the washing temperature as required, otherwise set at position * when a cold wash is acceptable. 5. Function selection but...

1. Control panel lock function: To prevent children from accidentally changing the settings, the control panel can be locked by pressing the “Temperature” and “Delay” buttons at the same time. After the panel is locked, the sign “LOCK” and the remaining wash time will be displayed on the LED alterna...

14 1. Turn off the water tap and pull out electricity plug after each wash. Open the porthole to prevent formation of moisture and odours. If the washing machine is left idle for a long period, drain the water in the machine and replace the drain hose. 2. Unplug the machine during cleaning and maint...

16 Trouble shooting In the unlikely event of difficulties with your appliance please follow the trouble shooting guide below. If the problem persists, contact an approved service engineer. If an error code is displayed, please refer to the error code guide below. problem possible cause how to correc...

1 7 M odel / Item HW D -D 1 0 0 0 T X VE/M E HW D -D 1 2 0 0 T X VE/M E Power Source 2 2 0 -2 4 0 V/ 5 0 Hz 2 2 0 -2 4 0 V/ 5 0 Hz Working C urrent ( M ax ) ( A) 1 0 1 0 Tap Water Pressure ( M Pa) 0 . 0 3 P 1 0 . 0 3 P 1 Washing Power ( W ) 2 0 0 2 0 0 Spinning Power ( W ) 3 5 0 4 5 0 M ax Load ( kg...