Haier HW80-187S - Manual - manualsarea.com

Page 2 - Contents; × ° Ï ä Ë μ Ã ÷; Packing list

Contents Safety precautions Installation and adjustment Preparation before washing The musts in washing Usage of the detergent Washing sequence Disposal after washing Names of the parts The cover 2 Packing list Trouble-Shooting Answers to question Specification × ° Ï ä Ë µ Ã ÷ Water inlet hose Gland...

Page 3 - ̧ ÷ 2 ¿ Î » Ã û 3 Æ; Meaning and description of the symbols; Names of the parts

¸ ÷ ² ¿ Î » Ã û ³ Æ 1 Meaning and description of the symbols Warning sign Forbidding sign Contents marked with that symbol are related to the safety of the product and the personal safety of the users. Please operate in strict conformity to the contents, otherwise it may cause damage of the machine ...

Page 4 - × ¢ Ò â Ê Â Ï î; Safety precautions

× ¢ Ò â Ê Â Ï î 2 Safety precautions Please insert the power cord into special receptacle with rated vol-tage.Be sure to use single-phase three pins receptacle.The earthing terminal of the receptacle must be earthed reliably.If possible,please adopt electric leakage protector. When the machine is no...

Page 6 - Installation and adjustment; Install the lint filter; The drainage shall be smooth with the drain hose.

Overflow filter Lint filter If the extra hose is too long, cut it either at point A or B. <10cm B A > 30mm <1.5m 4 Installation and adjustment Please install and adjust the machine according to the requirement of the manual. It is very important to your security and correct operating the ma...

Page 8 - Ï ́ Ç ° × 1⁄4 ± ̧; Preparation before washing

Ï ´ Ç ° × ¼ ± ¸ Preparation before washing1.Connect the water inlet hose.2.Confirm that the washing machine is earthed reliably . Then insert the power plug into the receptacle. Do not connect the earth terminal to the gas pipe and tap water pipe.3.Put down the drain hose . 4.Slanting or uneven grou...

Page 9 - Ï ́ μ Ó Î ï μ Ä 2 Î ¿ 1⁄4 Ö Ø Á ¿; Ï ́ μ Ó Ð ë Ö a; The musts in washing; How to use the whitener; Usage of the detergent

Ï ´ µ Ó Î ï µ Ä ² Î ¿ ¼ Ö Ø Á ¿ Ï ´ µ Ó Ð ë Ö ª Ï ´ µ Ó ¼ Á µ Ä Ê ¹ Ó Ã The capacity of washing and spinning of the machine refer to the weight of the standard laundries under dry condition that can be washed or spinned in one time. Laundries quantity in one washing cycle shall be lower than the sta...

Page 10 - Ï ́ μ Ó Ë 3 Ð ò; Washing sequence; Wash

Âé Spin timer Wash timer Wash selector Water-filling entrance (To set to below 2 minute, first set to 5 minute then turn it back. it can increase the service life of the timer). (Strong current, standard current) (to set to below 1 minute, first set to 2 minute then turn it back. it can increase the...

Page 11 - Rinse with water-filling; Rinsing; Midway spinning

Rinse with water-filling Rinsing 1.Put the laundries Put the laundries into the wash tub. Select suitable current according to the laundries. 2.Adjust the water level Set the water level with water level adjusting lever according to the laundries quantity. Then fill suitable water continuously. 3.Ri...

Page 12 - Rinse with stored water; Spinning

Rinse with stored water 1. Put the laundries into the wash tub. Select suitable current according to the laundries. 2. Fill water to preset water level. 3. Rinse Adjust the wash timer to 2-3 minutes to do rinsing. When the laundries quantity is few, please use "Standard" current. If you use ...

Page 13 - Ï ́ o ó ́ ¦ À í; Cleaning the overflow filter; Cleaning the lint filter; Disposal after washing

Ï ´ º ó ´ ¦ À í After using, please clean the lint and eyewinker of the lint filter and overflow filter in time. Otherwise it may influence your using the machine.Please first pull off the power plug from the receptacle before cleaning. Take off the overflow filter. As indicated in the figure, nip t...

Page 14 - Cleaning the

Ï ´ º ó ´ ¦ À í Cleaning the overflow filter 2. Take off the corrugation pipe. Dismantle the upper part of the corrugation pipe inside the overflow filter ( as indicated in Figure 1). 3. Cleaning the overflow filter Clean the lint around the filter and flush with tap water. 4. Install the overflow f...

Page 15 - o ó; protective cover; p r o t e c t i v e c ov e r; Disposal of the complete unit; If the laundries fall to the outer side of the spin tub; Trouble-shooting Answers to question

2 . i ns t a l l t he a f t e r c l ea n i n g , i n st a l l i t as o ri g i n a ss u r e i t re l i a b l e p r o t e c t i v e c ov e r Ï ´ º ó ´ ¦ À í Cleaning the protective cover 1 . c le a n i n g d ir t y u n d e r t he t a k e ou t t he s un d r i e s u si n g t h e p li e r or o th e r w i...

Page 16 - Phenomena; The reason

Trouble-shooting Answers to question (If there's breakdown, please pull off the power plug before checking) The following phenomena are not breakdowns sometimes. Please confirm again before sending it to repair. If there are real breakdowns, please come to the special maintenance department or after...

Haier HW80-187S - Manual

Table of Contents:

Summary

Other Haier Models