Haier DW15-PFE2- Manual

4 Cold water connection Connect the water supply hose to a threaded 3/4 (gas) connector, making sure that it is fastened tightly in place (see fig.A). Some models are fitted with an "Aquastop" water supply hose (see fig.B) in which the small filter is already housed in the threaded end. If t...

5 Drain hose connection Insert the drain hose into a drain pipe with a minimum diameter of 4cm, or let it run into the sink, making sure to avoid bending or crimping it. If necessary, fit a syphon trap (U-bend) with a connecting piece for the drain hose (fig.C). The free end of the hose must be at a...

How to remove the top of your dishwasher Please follow below pictures step by step. 100-150mm 6

Getting to know your dishwasher Close-up view (control panel) Models explanation Model Colour DW15-PFE1 DW15-PFE1ME DW15-PFE1SS DW15-PFE2 DW15-PFE2ME DW15-PFE2SS White Silver Stainless Steel White Silver Stainless Steel You can select dishwasher with big handle or without big handle according to req...

Dishwasher interior Upper Rack Detergent and Rinse Aid Dispenser a b c d e f g h i j k l Top Spray Arm Salt Container Cap Silverware Basket Third Sprayer Bottom Spray Arm Washing Filter Water Inlet Hose Drain Hose Power Supply Cord Lower Rack 8 a e d f g h i j k l b c

Important To prevent the formation of rust, load the salt just before beginning a wash cycle. Salt The hardness of the water varies from place to place. If hard water is used in the dishwasher, deposits will form on the dishes and utensils. The appliance is equipped with a special softener that uses...

Adjusting salt consumption The dishwasher is designed to allow for adjusting the amount of salt consumed based on the hardness of the water used. This is intended to optimize and customize the level of salt consumption so that it remains at a minimum. To adjust salt consumption, proceed as follows: ...

Rinse aid This product makes dishes sparkle and helps them to dry without spotting. The dispenser is located on the inside panel of the door . Important Proper dosage of the rinse aid improves drying. If drops of water remain on the dishes or spotting occurs, the dosage adjus- tor should be turned t...

Not suitable for the dishwasher What you should not put into the dishwasher Cutlery and tableware manufactured in whole or part from wood.They become faded and unsightly in appearance.Furthermore,the adhesives that are used are not suitable for the temperature that occur inside the dishwasher.Delica...

Detergent Detergent specifically intended for use with dishwashers must be used. The dispenser must be refilled before the start of each wash cycle following the instructions provided in the "Programme overview". The detergent dispenser is located on the inside panel of the door. Loading the...

Programme overview Wash programme Type of crokery e.g. china, pots/ pan s, cutiery, glasses, etc Amount of food remains Description of cycle Condi- tion of food remains 1/2 Load Pre-wash with hot water. Extended wash at 70 ° C. Rinses with cold water. Rinse with hot water. Drying. Prewash use cold w...

Washing dishes Programme selection The most appropriate programme can be identified by comparing the type of crockery, cutlery, etc., as well as the amount and condition of food remains, with the details contained in the wash cycle table.The corresponding programme sequence, duration and consumption...

Delayed start programming (for DW15-PFE2**) You can delay the start of a programme in increments of one hour up to 12 hours. Switch dishwasher ON. Immediately press the Delayed Start button “ D ”, the delayed start indicator “ E ” blinks, the delayed start time indicator “ F ” changes to “ ”. Press ...

Cancelling or modifying a cycle A cycle that is underway can be modified if it has only been running for a short time. Otherwise, the detergent may have already been used, and the appliance may have already drained the wash water. If this is the case, the detergent dispenser must be refilled ( see t...

How to keep your dishwasher in shape After Every Wash After every wash, turn off the water supply (not necessary for models with “Aquastop” ) the appliance and leave the door slightly ajar so that moisture and odors are not trapped inside. Remove the plug Before cleaning or performing maintenance, a...

Care and maintenance Dishwasher salt ( for DW15-PFE2**) Check the LOW SALT indicator “ G” .Top up with salt, if required. Regular inspection and maintenance of your appliance helps to prevent problems from occurring.This saves time and aggravation.You should therefore carefully inspect the inside of...

Inspect the nozzles in the spray arms for blocked holes due to remnants of food. If necessary, pull the lower arm “ 12 ” upwards and lift it off. Unscrew the upper spray arm “ 11 ”. Clean both spray arms under running water. Refit the spray arms. Ensure that the lower arm has locked into place and t...

Resolving minor problems yourself Experience has shown that you can resolve most problems that rise during normal daily usage yourself, without having to call out a service engineer.Not only does this save costs,but it also means that the appliance is available for use again that much sooner. The fo...

Technical data 15 standard place settings Width Depth Height Capacity Mains water pressure Power voltage Total absorbed power 60 cm 60 cm 85 cm 0.03-0.6MPa 220-240V~ 50Hz 1950W Maximum current intensity 10A 29

General information Measures must be taken to ensure that built-under and built-in units that are subsequently re-sited as free-standing appliances cannot topple over. This can be achieved by bolting the dishwasher to the wall or fitting it under a continuous work surface which is screwed to the adj...