Page 3 - Index
Index 1 Safety information Installation Getting to know your dishwasher How to fill the rinse aid and the detergent dispenser Not suitable for the dishwasher Arranging crockery, glasses, etc. in the dishwasher Programme overview Washing dishes How to keep your dishwasher in shape Care and maintenanc...
Page 4 - Safety information; During installation; During normal use
Safety information 2 Site the dishwasher and connect it up in accordance with the installation instructions. The dishwasher must not be connected to the electricity supply while installation is being carried out. Ensure that the domestic wiring is properly earthed. The mains electricity supply must ...
Page 5 - When disposing of old appliances; Dangerous voltag; If a fault occurs
3 When disposing of old appliances Appliances which are no longer being used must be made inoperable by cutting the power supply cord and removing the door lock. Take the appliance to a designated waste disposal center. Dangerous voltag e Children could get locked in the appliance (risk of suffocati...
Page 6 - Installation; Levelling the appliance; Cold water connection
fig.B1 4 Installation Levelling the appliance Once the appliance is positioned, adjust the feet (screwing them in or out) to adjust the dishwasher, making it level. In any case, the appliance should not be inclined more than 2˚. If the appliance is level, it will help ensure proper performance. Posi...
Page 7 - Electrical Connection
fig.B2 5 The connecting piece for syphon trap (U-bend) must be solidly fastened to the wall to prevent the drain hose from moving and allowing water to spill outside the drain. Electrical Connection After making sure that the voltage and frequency values for the current in the home correspond to tho...
Page 8 - Getting to know your dishwasher; Dishwasher interior
6 Getting to know your dishwasher Close-up view (control panel) Dishwasher interior Detergent and Rinse Aid Dispenser e f g Bottom Spray Arm Washing Filter Upper Rack a b c d Top Spray Arm Silverware Basket Lower Rack a d e f g b c EFG Low Rinse Aid Indicator Light Heat Indicator Light Knob For Sele...
Page 9 - Rinse aid; ow to fill the rinse aid and the detergent dispenser; Detergent; oading the detergent
7 When the low rinse aid indicator lights, you must load rinse aid. Rinse aid This product makes dishes sparkle and helps them to dry without spotting. The dispenser is located onthe inside panel of the door . Loading the rinse aid Regardless of the type of detergent dispenser installed on your appl...
Page 10 - Not suitable for the dishwashe; What you should not put into the dishwasher; Possible causes; uggested remedy; Damage to glassware and other dishes
8 Not suitable for the dishwashe r What you should not put into the dishwasher C utlery and tableware manufactured in whole or part from wood.They become faded and unsightly in appearance.Furthermore,the adhesives that are used are not suitable for the temperature that occur inside the dishwasher.De...
Page 11 - How to use the lower rack
9 Arranging crockery, glasses, etc. in the dishwasher Before placing the dishes in the dishwasher, remove larger food particles to prevent the filter from becoming clogged, which re- sults in reduced performance. If the pots and pans have baked-on food that is extremely hard to remove, we recommend ...
Page 12 - How to use the upper rack
10 The upper rack is designed to hold more delicate and lighter dishware, such as glasses, cups and saucers, plates, small bowls and shallow pans (as long as they are not too dirty). How to use the upper rack Shelf Lean tall glasses and those with long stems against the shelf- not against other item...
Page 13 - Programme overvie
Programme overvie w W ash programme Description of cycle Pre-wash with hot water.Extended wash at 70°C.Rinses with cold water.Rinse with hot water.Drying. Prewash use cold water.Extended wash at 50°C.Rinse with cold water.Rinse with hot water.Drying. Hot rinse at 65°C. Drying. Short wash at 40°C. Co...
Page 14 - Washing dishes; Programme selection; urning on the Appliance
12 Washing dishes Programme selection The most appropriate programme can be identified by comparing the type of crockery, cutlery, etc., as well as the amount and condition of food remains, with the details contained in the wash cycle table. Earn savings If only a small number of dishes have been lo...
Page 16 - How to keep your dishwasher in shape
How to keep your dishwasher in shape After Every Wash After every wash, turn off the water supply (not necessary for models with “Aquastop” ) to the appliance and leave the door slightly ajar so that moisture and odors are not trapped inside. Remove the plug Before cleaning or performing maintenance...
Page 17 - Care and maintenance; Overall condition of appliance
Care and maintenance Regular inspection and maintenance of your appliance helps to prevent problems from occurring.This saves time and aggravation.You should therefore carefully inspect the inside of your dishwasher from time to time. Overall condition of appliance C heck that no grease or scale has...
Page 18 - esolving minor problems yourself; Appliance does not start up; ault finding
1 6 R esolving minor problems yourself E xperience has shown that you can resolve most problems that rise during normal daily usage yourself, without having to call out a service engineer.Not only does this save costs,but it also means that the appliance is available for use again that much sooner. ...
Page 19 - provide them with the following information:
17 If you take all these checks and the dishwasher still does not function or your dish- washer have any other error display, you can power the dishwasher OFF, and wait a few minutes. You can power the dishwasher on, try it again , if the dishwasher still does not function and/or the problem persist...
Page 21 - Technical data; Maximum current intensity
Technical data 19 12 standard place settings Width Depth Height Capacity Mains water pressure Power supply Total absorbed power 60 cm 0.03-1.0MPa 220-240V~ 50Hz 1950W Maximum current intensity 13A 60 cm 85 cm
Page 22 - mportant information; Notes on waste disposal; eneral information
20 Information on comparability tests implemented in compliance with AS/NZS 2007 Appliance loaded in accordance with standard specifications.Example of loaded dishwasher: See fig. 1 and 2.Capacity: 12 place settingsComparability programme: NORMAL washRinse-aid setting: 5Detergent: 25+5g fig.1 fig.2 ...
Page 23 - Diagram
Diagram Door switch Rotary switch Thermal cut-out Spy rinse switch Heating relay Temperature sensor Heating element Wiring box 220V -240V ~ 50Hz Filter Water level switch Drain pump Dispenser valve Overflow switch Inlet water valve W ashing pump PCB S1 S3 S5 1 2 S4 S7 S6 Reset S2 12 Thermal cut-out ...
