Haier AS102AMARA- User Manual

3 0 Wiring for Indoor and Outdoor Units 1. Wiring Method for Ring TerminalThe wiring method is as the drawing below for the ring terminal:Remove the connection screw and put the screw through the ring onthe connection wire terminal, then connect it to the terminal blocks,then screw it tightly. 2.Wir...

Name of Parts Introduction to Display and Function:1. Mode Mode selected is displayed 2. Air Volume Indicating the air speed, when automatic is set, the air speed changes according to the temperature difference between the indoor temperature and set temperature. 3. Healthy Operation Indicating healt...

2 8 Installation of Outdoor Unit 4.Piping Connection for Indoor Unit:Insert the auxiliary hoses(liquid hose and gas hose)and the unit connection wires through the wallhole from outdoor side,and connect the pipes and wires as per the method of piping connection, orinsert the auxiliary hoses(liquid ho...

Cold Air Prevention Defrost Notes When heating is started, the fan in the indoor unit willnot be started immediately to prevent cold air being blewout. During the heating, when the heat exchanger in theoutdoor unit is frosted, the air conditioner will defrostautomatically for a few minutes. During t...

Small Hints:Remove the batteries in case the unit won't be in use for a long period.The remote controller will be self-checked after loading the new batteries by displayingall the symbols and resume working very soon. 8 Operation Health Operation 1. After turning on the air conditioner, set to the d...

To enable the air conditioner to work well, please install it as required by this manual. When moving the air conditioner, please don't scratch the shell. The max. length of the connection pipe is 15 meters, and the max. height difference between the indoor unit and outdoor unit is 7 meters for AS12...

I n s u l a t i n g M a t e r i a l N o n - a d h e s i v e Ta p e P i p i n g L a y o u t L e f t R i g h t B a c k R i g h t D o w n I n s u l a t i n g M a t e r i a l P i p i n g C o v e r P i p e C l i p D r a i n H o s e Va l v e C o v e r C o n n e c t i o n Wi r e I n s u l a t i n g M a t e...

No Display Stop at . At the state of Super Mode Operation ,when cooling, the temperature will be 4 lower than the temperature set, and the fan will automatically run at high speed for 15 minutes, then return tothe previously set state;when heating, the temperature will be 6 higher than the temperatu...

Air does not blow or the fan speed cannot bechanged during the dehumidifying mode. Water or steam generates from the outdoor unitduring heating. During heating, the fan in the indoor unit stillworks even after the unit operation stops. There would be sooting around the outlet and asound Si Si would ...

Notes for Safety The power supply plug must have the earth lineto ensure that the air conditioner may be grounded effectively through the power supplysocket. Non-grounding or incomplete grounding would result in electric shock. Clean the dust filter periodically:Blockage of the dust filter would red...

1 8 Maintenance after Season of Use Maintenance before Season of Use Turn on the machine and let it operate for half a day under the status of sending air ina sunny day so as to make the inside of theair conditioner fully dry. Clean the dust filter, the indoor unit, and outdoorunit, then cover it. C...

1. Open the inlet grill as drawing: 2. Remove the dust filter and slightly push the filter upward then pull downward. 3. Install the air filter by inserting it into left and right frames with the white side upward. 4. Install back dust filter Left filter and right filter are different in shape, so n...