Haier AD182AMEAA- User Manual

Page 2 - Table of Contents

1 Table of Contents Malfunction 7-8 Care and Maintenance 9 For Preparation of Heating("Hot Keep") 10 Is The Unit Installed Correctly 11 Installation Manual For Indoor Unit 12-18 Safety Precautions 3-5 Parts and Functions 6 Cautions 2 Trouble Shooting 19-20

Page 3 - Cautions; Disposal of the old air conditioner; Safety Instructions and Warnings

Cautions 2 All electrical repairs must be carried out by qualified electricians. Inadequate repairs may result in a major source of danger for the user of the air conditoiner. Do not damage any parts of the air conditioner that carry refrigerant by piercing or perforating the air conditioner's tubes...

Page 4 - Safety Precautions; CAUTIONS FOR INSTALLATION

Safety Precautions Before starting to use the system, read carefully this"SAFETY PRECAUTIONS" to ensure a proper operation of the system. Safety precautions described here are classified to " WARNING" and " CAUTION". Precautions which are shown in the column of " WANING&#...

Page 5 - CAUTIONS FOR TRANSFER OR REPAIR

4 CAUTION Do not wash the air conditioner with water. Do not install the system where the air outlet reaches directly the flora and fauna. Make sure to use a fuse of proper electric rating. D o n o t o p e r a t e t h e s y s t e m w h i l e t h e air outlet grill is removed. It is strictly prohibit...

Page 6 - The machine is adaptive in following situation; The connecting cable should be:

5 2. If the supply cord is damaged, it must be replaced by the manufacturer or its service agent or a similar qualified person. 3. If the fuse on PC board is broken please change it with the type of T 3.15A /250VAC.4. The wiring method should be in line with the local wiring standard. 1. Applicable ...

Page 7 - Parts and Functions; Air outlet; For series

Parts and Functions 6 Air outlet Air inlet Duct Air outlet Air inlet Duct For series 182, 242, 282 ,362 For series 482

Page 8 - Unit fails to start; It is dangerous. Turn off; Cooling or heating is not sufficient; and contact your sales dealer.; Malfunction

please check the following things about your air conditioner before making a servie call. Unit fails to start ON OFF Is the power source switch adjust cut in? Is city supply power in normal? Power stoppage? Isn't the signal receiving section exposed to the direct sunlight or strong illumination? Isn...

Page 9 - The followings are not malfunction

8 The followings are not malfunction Shuru Shuru When the air conditioner is started, when the compressor starts or stops during operation or when the air conditioner is stopped, it sometimes sounds "shuru shuru" or "gobo gobo". It is the flowing sound of the refrigerant, and it is n...

Page 10 - Care and Maintenance; Points to observe; Cleaning; Care and Cleaning of the unit

9 Care and Maintenance Points to observe Turn off the power supply switch. Do not touch with wet hand. Do not use hot water or volatileliquid. ON OFF Thinner Do not use! Benzine Tooth powder Cleaning CAUTION Do not dry the air filter with fire.Do not run the air conditioner without the air filter. D...

Page 11 - WARMING OPERATION; Heat pump type warming

10 For Preparation of Heating("Hot Keep") "HOT KEEP"is operated in the following cases. When heating is started: In order to prevent blowing out of cool wind, the indoor unit fan stoppedaccording to the room temperature which heating operation is started. Waitfor approx. 2 to 3 minut...

Page 12 - Is The Unit Installed Correctly; For inspection and maintenance; Installation place; The power source for the unit is to be of exclusive use.

11 Is The Unit Installed Correctly For inspection and maintenance When you change your address or the installation place Electric work Confirm the following items for safe and comfortable use of air conditioner. The installation work is to be burden on the sales dealer, and do not conduct it by your...

Page 13 - Installation Manual For Indoor Unit; Safety precautions

12 Installation Manual For Indoor Unit 1. Safety precautions WARNING Please read these "Safety Precautions" first then accurately execute the installation work. Though the precautionary points indicated herein are divided under two headings, and , those points which are related to the strong...

Page 14 - consent on the part of your client user.; Installation space; Combination

13 NOTICE All Wiring of this installation must comply with NATIONAL, STATE AND LOCAL REGULATIONS . These instructions do not cover all variations for every kind of installation circumstance. Should further information bedesired or should particular problems occur, the matter should be referred to yo...

Page 15 - (a) Size of hole at ceiling and position of hanging bolts; Use care of the piping direction when the unit is installed.; (3) Avoid installation and use at those places listed below.; Generated noise may cause malfunctioning of the controller.

14 (4) Preparation for suspending the unit (a) Size of hole at ceiling and position of hanging bolts <Combination with silent panel> 57 A B C (Hanging bolt position) (Ceiling hole size) (Panel dimensions) 137 30 30 (Ceiling ~ panel wrap dimensions) (Ceiling ~ panel wrap dimensions) (Hanging bo...

Page 16 - Improper piping

15 (5) Installation of indoor unit Fix the indoor unit to the hanger bolts.If required, it is possible to suspend the unit to the beam, etc. Directly by use of the bolts without using the hanger bolts. When the dimensions of main unit and ceiling holes does not match, it can be adjusted with the slo...

Page 17 - When constructing drain piping for several units, position the; Drainage Test

16 VP 30 Secure the elevation as high as possible (approx. 100 mm) A downhill grade of 1/100 or more Drain hose Joint for VP 25 (Local procurement) 600 (Maximum local drain up dimension) Right overhead 290~325mm Attached drain hose clamp Drain piping Main unit Drain situation can be checked with tra...

Page 18 - number of spots based on following table.

17 (7) Installation work for air outlet ducts Calculate the draft and external static pressure and select the length, shape and blowout. A Blowout duct 2-spot, 3-spot and 4-spot with 200 type duct are the standard specifications. Determine the number of spots based on following table. Note (1) Shiel...

Page 19 - (1) Selection of size of power supply and interconnecting wires.; L N

18 5. Electric wiring WARNING DANGER OF BODILY INJURY OR DEATH TURN OFF ELECTRIC POWER AT CIRCUIT BREAKER OR POWER SOURCE BEFORE MAKING ANY ELECTRIC CONNECTIONS. GROUND CONNECTIONS MUST BE COMPLETED BEFORE MAKING LINE VOLTAGE CONNECTIONS. (1) Selection of size of power supply and interconnecting wir...

Page 20 - Trouble Shooting; EAA; Communication between indoor and outdoor abnormal; Remarks; shows resumable fault,

19 Trouble Shooting Error display ( For * EAA series ) For remote type, flash times 1 2 3 4 5 6 8 9 10 11 12 13 15 17 18 19 20 Failure description Indoor ambient temp. sensor failure Indoor coil temp. sensor failure Outdoor ambient temp. sensor failure Outdoor coil temp. sensor failure/Compressor di...

Page 22 - HAIER GROUP

HAIER GROUP Qingdao Haier Air Conditioner Electric Co., Ltd. Address: Haier Garden ,Qianwangang Road , Economic Development Zone, Qingdao ,Shandong 266500, P.R.China Web Site: http://www.haier.com

Haier AD182AMEAA- User Manual

Table of Contents:

Summary

Other Haier Models