Haier AC142XCERA- User Manual

Safety Precautions WARNING If the power supply cord of this air conditioner is damaged, it must be replaced by the manufacturer or its authorized service personnel only. Use copper wire only. All the cables shall have got the Local authentication certificate. the power supply connects from the outdo...

4 Name of Parts For the wired control type unit, the unit state should be checked by the the wired controller, instead of the remote receiver; and if you set the TIMER function, the TIMER LED on the remote receiver will not be on. 1 Operating Control Panel (Fig.2) 2 Emergency switch 3 Remote Control...

Cleaning and Care CAUTION Before cleaning the air conditioner ,be sure to turn it off and disconnectthe Power Supply Cord.Be sure the Intake Grill is installed securely.When removing and replacing the air filters, be sure not to touch the heatexchanger, as personal injury may result. Cleaning the Ai...

Operation and Performance *Heating Performance *Microcomputer-controlled Automatic Defrosting Heat-pump air conditioners heat your entire room by recirculating air throughout the room, with the result that some time may be required after first starting the air conditioner until the room is heated. T...

Installation WARNING ! CAUTION ! Please ask the dealer or specialist to install, never try by the users themselves. After the installation please be sure of the following conditions. Incorrect installation may cause water leaking, shock and fire hazard. Please call dealer to install the air-conditio...

8 Installation Procedures SELECTING THE MOUNTING POSITION (1)Do not install where there is the danger of com- bustible gas leakage. (2) Do not install near heat sources. (3) If children under 10 years old may approach the unit, take preventive measures so that they cannot reach the unit. Install at ...

Installation Procedures Open the intake grill and remove the three or four or six screws.(Fig. 1) Remark:The main unit can be wired before the indoor unit is installed. Select the most appropriate installation order. A. FLOOR CONSOLE TYPE 1. DRILLING FOR PIPING Select piping and drain directions.(Fi...

Installation Procedures Select whether the drain hose will be connectedto the left or right side.(Fig.3) Insert the drainhose into the drain pan, then secure the drainhose with a nylon fastener. (Fig.6) 2. INSTALLING DRAIN HOSE (Fig. 6) Wrap the insulation (drain hose) around the drainhose connectio...

12 Installation Procedures Select whether the drain hose will be connected tothe left or right side.(Fig.3)Insert the drain hose into the drain pan, then securethe drain hose with a nylon fastener.(Fig.6)Wrap the insulation (drain hose)around the drainhose connection.(Fig.7)Be sure to arrange the dr...

Installation Procedures HOW TO CONNECT WIRING TO THE TERMINALS A. For solid core wiring (or F-cable)(Fig.24A) (1) Cut the wire with a wire cutter or wire-cutting pliers, then strip the insulation to about 25mm of the exposed solid wire. (2) Using a screwdriver, remove the terminal screw(s) on the te...

15 Installation Procedures ELECTRICAL WIRING 1. INDOOR UNIT SIDE (1) Remove the electric component box. (2) Pull out the electric component box. (3) Remove the electric component box cover. Remove the three tapping screws. (1) Remove the cord clamp. (2) Process the end of the connection cords to the...

Installation Procedures ELECTRICAL WIRING (1) The power source capacity must be the sum of the room air conditioner current and the current of other electrical appliances. When the current contracted capacity is insufficient, change the contracted capacity. (2) When the voltage is too low and the ai...

Followings are not problems Sound of water flowing isnot a problem. Sound of cracking is heard. Smell are generated. During operation, white fog or steamcomes out from the indoor unit. No outlet air or fan speed can't be changedin dry mode. In cooling operation, unit switches toblowing operation. Wo...