Haier AC142ACEAA- User Manual

Safety Precautions WARNING! If the power supply cord of this air conditioner is damaged, it must be replaced bythe manufacturer or its authorized service personnel only.Use copper wire only. All the cables shall have got the Local authentication certificate.the power supply connects from the outdoor...

4 Name of Parts Fig.1 Indoor Unit 1 4 6 7 3 Fig.2 POWER OPER TIMER COMP EMER 2 3 9 8 Fig.1 11 10 Note : For the wired control type unit, the unit state should be checked by the the wiredcontroller, instead of the remote receiver; and if you set the TIMER function, theTIMER LED on the remote receiver...

Cleaning and Care CAUTION! Before cleaning the air conditioner ,be sure to turn it off and disconnectthe Power Supply Cord.Be sure the Intake Grill is installed securely.When removing and replacing the air filters, be sure not to touch the heatexchanger, as personal injury may result. Cleaning the A...

Operation and Performance *Heating Performance *Microcomputer-controlled Automatic Defrosting Heat-pump air conditioners heat your entireroom by recirculating air throughout the room,with the result that some time may be requiredafter first starting the air conditioner until theroom is heated. This ...

Installation WARNING ! CAUTION ! Please ask the dealer or specialist to install, never try by the users themselves. After the installation please Incorrect installation may cause water leaking, shock and fire hazard. Please call dealer to install the air-conditioner. Air-conditioner can't be install...

8 Installation Procedures Under ceiling Outdoor unit Indoor unit 2 cmor more Ceiling Indoor unit 30 cmor more Left Right 1.5m Floor console 30 cmor more 30 cmor more 1.5m 1.5m Left Right may be difference SELECTING THE MOUNTING POSITION (1)Do not install where there is the danger of com- bustible ga...

Installation Procedures Open the intake grill and remove the three or four or six screws.(Fig. 1) Remark:The main unit can be wired before the indoor unit is installed. Select the most appropriate installation order. A. FLOOR CONSOLE TYPE 1. DRILLING FOR PIPING Select piping and drain directions.(Fi...

Installation Procedures Select whether the drain hose will be connectedto the left or right side.(Fig.3) Insert the drainhose into the drain pan, then secure the drainhose with a nylon fastener. (Fig.6) 2. INSTALLING DRAIN HOSE (Fig. 6) Wrap the insulation (drain hose) around the drainhose connectio...

Fig. 15 3. INSTALLING BRACKETS Install the brackets with nuts, washers and springwashers.(Fig. 15) Spring washer Special nut Bracket 4. INSTALLING INDOOR UNIT Bracket (Right) Bracket (Left) Installation Procedures Select piping and drain directions.(Fig.11) 1. DRILLING FOR PIPING Fig. 14 Fig. 13 Ins...

12 Installation Procedures Select whether the drain hose will be connected to the left or right side.(Fig.3) Insert the drain hose into the drain pan, then secure the drain hose with a nylon fastener.(Fig.6) Wrap the insulation (drain hose)around the drain hose connection.(Fig.7) Be sure to arrange ...

Installation Procedures HOW TO CONNECT WIRING TO THE TERMINALS A. For solid core wiring (or F-cable)(Fig.24A) (1) Cut the wire with a wire cutter or wire-cutting pliers, then strip the insulation to about 25mm of the exposed solid wire.(2) Using a screwdriver, remove the terminal screw(s) on the ter...

14 Installation Procedures ELECTRICAL REQUIREMENT Electric wire size and fuse capacity: Table 5 ELECTRICAL WIRING 1. INDOOR UNIT SIDE (1) Remove the electric component box. (2) Pull out the electric component box. Fig.28 (3) Remove the electric component box cover. Fig. 29 Base Electric component bo...

Installation Procedures ELECTRICAL WIRING (1) The power source capacity must be the sum of the room air conditioner current and the current of other electrical appliances. When the current contracted capacity is insufficient, change the contracted capacity. (2) When the voltage is too low and the ai...

Followings are not problems Sound of water flowing isnot a problem. Sound of cracking is heard. Smell are generated. During operation, white fog or steamcomes out from the indoor unit. No outlet air or fan speed can't be changedin dry mode. In cooling operation, unit switches toblowing operation. Wo...

Before ask for services, please first check your unit against the following. Air conditioner won't start. Poor cooling or heating Is power supply switchturned on? Power supplyswitch is notset at ON. Is city power supply normal? Is leakage current breakeractivated? This is very dangerous, pleasedisco...