Page 2 - Contents
Contents Cautions ............................................................................................. Introduction to Spare Parts................................................................... Parts And Functions.............................................................................
Page 3 - Cautions; Disposal of the old air conditioner; Safety Instructions and Warnings; Installation shall be done by professional
Cautions 1 Disposal of the old air conditioner Before disposing an old air conditionerthat goes out of use, please make sure it'si n o p e r a t i v e a n d s a f e . U n p l u g t h e a i rconditioner in order to avoid the risk ofchild entrapment. It must be noticed that air conditionersystem conta...
Page 4 - Do not allow children to play with the air
2 All electrical repairs must be carried outby qualified electricians. Inadequate repairsmay result in a major source of danger forthe user of the air conditoiner. Do not damage any parts of the airc o n d i t i o n e r t h a t c a r r y r e f r i g e r a n t b ypiercing or perforating the air condi...
Page 5 - Safety cautions
3 WARNING! Carefully read the following information in order to operate the airconditioner correctly. Below are listed three kinds of Safety Cautions and Suggestions. WARNING! CAUTION! Incorrect operations may result in injuries or machine damages; in some cases maycause serious consequences. Incorr...
Page 6 - Otherwise will be shocked.
4 CAUTIONS! Conditioner should not be used for any other purpose other than airconditioning. Don't use air-conditioner for any other specialpurposes, e.g. the preservation and protectionof food, animals, plants,pecision apparatus as wellas work of art, otherwisethe qualities of thesestuffs may be da...
Page 7 - Introduction to Spare Parts; Drain Hose
Introduction to Spare Parts 5 Drain Hose Swing fender Refrigerant pipeCable lineEarthing line Air filter Outlet Suction grill (located in the suction grill) In cooling operation,to discharge thewater from inside theroom. Discharge unit (built in) (located in the outlet)
Page 8 - Operation; Buttons and display of the wire controller.; Parts and Functions
Operation Buttons and display of the wire controller. Cautions:On cooling only unit, heatingmode is not available. Note:The above information is the explanation ofthe displayed information therefore varieswith those displayed in actual operation. 6 CLOCK Used to set correct time. TIMER Used to selec...
Page 9 - OPERATING LAMP; Remote control
7 Buttons and display of the wire controller. Clock set When unit is started for the first time, clock should be adjusted as follows:Press CLOCK button, "AM"or "PM" flashes. Operation OPERATING LAMP DRY COOL AUTO FAN SPEED SLEEP TIMER ON TIMER OFF CLOCK TEMP. FAN OPERATION HEAT Remot...
Page 10 - Fan operation; Enjoy yourself by just a gentle press.; The air conditioner has the function of POWER
Operation 8 Fan operation Enjoy yourself by just a gentle press. (1) Unit start (2) Select operation mode (3) Fan Press ON/OFF button, unit starts.Previous operation status appears on display.(Not Timer setting)Power indicator lights up. Press MODE button. For each press, operationmode changes as fo...
Page 11 - Recommendations; AUTO
Operation AUTO RUN, COOL,HEAT and DRY operation Use COOL in summer.Use HEAT in winter.Use DRY in spring,autumn and in damp climate. (1) Unit start (2) Select operation mode (3) Select temp. setting Press ON/OFF button, unit starts.Previous operation status appears on display(Not Timer setting). Powe...
Page 12 - TIMER operation; Hints; Set Clock correctly before starting Timer operation.; To cancel TIMER mode
10 TIMER operation Hints Set Clock correctly before starting Timer operation. You can let unit start or stop automatically at following time: Before you wake up in themorning, or get back from outside or after you fall asleep at night. Operation mode will be displayed on LCD.Power indicator lights u...
Page 14 - In cooling, dehumidifying mode; Comfortable Sleep
Operation about 6 hrs 1 hr 1 hr 12 At night, before going to bed youcan press down the SLEEP buttonon the controller and the air-conditioner will run by thecomfortable sleeping mode tomake you sleep more comfortable. In cooling, dehumidifying mode In heating mode SETTING T SLEEP RUN BEGINS SLEEP RUN...
Page 15 - failure compensation.; Mark; Inverter; Fixed Frequency
Operation 13 Power Failure Compensation (to be applied for a necessary situation) After the power failure compensation is set, if power failure suddenly occurs while the air conditioner is working, it will resume the previous working state when the power is supplied again. Setting Method: When the w...
Page 16 - Maintenance; NOTE
14 3. Dismantle air filter CAUTION! 4. Clean 6. Close inlet grill 7. Press the filter signal return key on the controller. (A) Remove dust with vacuum filter. 5. Install air filter (1) Put filter into protruding parts at the top of the inlet grill. (2) Connect the two pothooks with inlet grill See 2...
Page 17 - Take of inlet grill; Install inlet grill; [Dismantle and install swing; Install swing plate
Maintenance 15 3. Take of inlet grill 4. Clean CAUTION! NOTE When the filter too much dust To spray the special detergent for vent fan or utensils. 5. Install inlet grill 6. Install air filter 7. Close inlet grill [Clean outlet and shell] see 3 see "Clean air filter" see 1 CAUTION! Don't use...
Page 18 - Seasonal Reserve
16 NOTE The inner part of indoor unit must be cleaned. Consult dealer, because clean must be done by technician. In cooling operation, discharging system discharge water in room. 2. 1. Seasonal Reserve Operate the unit with FAN mode on a fair day for about halfa day to dry the inside of the unit wel...
Page 19 - The followings are not malfuncition; Trouble Shooting; Water flowing sound is heard
17 The followings are not malfuncition Hua Hua Trouble Shooting Water flowing sound is heard When the air conditoner is started, when thecompressor starts or stops during operationor when the air conditioner is stopped,it som-etimes sounds ì Bi- Bi-î or ì Godo-Godoî . It isthe flowing sound of the r...
Page 20 - Defrosting operation
18 **? ON OFF Trouble Shooting Air does not blow or the fan speed cannot bechanged during drying. In DRY mode, when room temperaturebecomes 2 C higher than temperature setting,unit rill run intermittently at LO speed regardlessof FAN setting During heating,indoor fan is still running evenunit is sto...
Page 21 - When Trouble Happens; Insufficient cooling or heating; Air filter too dirty ?; Insufficient cooling; Too crowed in the room ?
19 When Trouble Happens Insufficient cooling or heating The operation controlleradjusted as required Air filter too dirty ? Horizontal swing louverupward ? (in HEAT mode) Any obstacle exists at the airinlet or outlet? Door or window left opened ? Insufficient cooling Any other heat sources in theroo...
Page 22 - Using Directions; Adjust suitable airflow direction
20 Customer Need-to-know Customer Need-to-know Please install the air conditioner according to the requirements specified in this manual to ensurethe air conditioner work well. Be careful not to scratch the surface of the case during moving the air conditioner. Please keep the installation manual fo...
Page 23 - be sure of the following conditions.; Please call dealer to install the air-conditioner.; Incorrect pipe use may cause water leaking.; Installation; Installation Procedure
21 WARNING ! CAUTION ! Please ask the dealer or specialist to install, never try by the users themselves. After the installation please be sure of the following conditions. Incorrect installation may cause water leaking, shock and fire hazard. Please call dealer to install the air-conditioner. Air-c...
Page 24 - Meanings of Warning and Cautions:; Refer to paper pattern when installing unit.; Cautions for the installation personnel
22 Unit shall be grounded. But grounding shall not be connected to gas pipewater pipe, telephone line. Poor grounding will cause electric shock.Be sure to install a leakage breaker to avoid electric shock.Arrange water drainage according to this Manual. Cover pipe with insulation materials in casede...
Page 25 - Accessory parts
23 A B C D Installation tools Standard accessories 1. Screw driver2. Hacksaw3. Drill with a diameter of 60mm4. Inner hexagon spanner,shifting spanner5. Spanner (14, 17, 19,24,27mm)6. Pipe cutter7. Pipe expander8. Knife9. Pincers10. Leakage detector or soapy water11. Band tape12. Scraper13. Refrigera...
Page 26 - Air outlet
(2) Ceiling height Indoor unit can be installed on ceiling of 2.5-3m in height. (Refer to Foeld setting and Installation Manual ofornament panel.) (3) Install suspending bolt. Check if the installation place is strong enough to hold weight. Take necessary measures in case it is not safe. (Distance b...
Page 27 - PREPARATION FOR THE INSTALLATION; Ceiling
3. PREPARATION FOR THE INSTALLATION (1) Position of ceiling opening between unit and suspending bolt. 3 25 (2) Cut an opening in ceiling for installation if necessary. (when ceiling already exists.) (3) Install a suspending bolt. (Use a M10 bolt) To support the unit weight, anchor bolt shall be used...
Page 28 - INSTALLATION OF INDOOR UNIT; In the case of new ceiling; Insert; Level
26 4. INSTALLATION OF INDOOR UNIT In the case of new ceiling < After installation on the ceiling > (3) Adjust unit to its right position. (Refer to preparation for the installation-(1))(4) Check unit's horizontal level. Watert pump and flating switch is installed inside indoor unit, check four...
Page 29 - Cautions for the drain water lifting pipe
6. INSTALLATION OF WATER DRAINAGE PIPE ( As for outdoor piping, please refer to installation Manual of outdoor unit. ) 5. REFRIGERANT PIPING Outdoor is precharged with refrigerant.Be sure to see the Fig.1, when connecting and removing piping from unit.For the size of the flare nut, please refer to T...
Page 30 - Method of water charging
(2) Check if water drainage is smooth after installation. Charge, through air outlet or inspecting hole, 1200ccd water to see water drainage. After wiring Remove cover of control box, short connect "CHECK" terminal of the indoor unit, which is on the uperpart of indoor unit PCB. Connect 1PH ...
Page 33 - INSTALLATION OF ORNAMENT PANEL; Prepare ornament panel Handling of ornament panel; Bar; Adbesive tape; Slide; Hint; Replace the upper part of wire controller
9. INSTALLATION OF ORNAMENT PANEL 1. Prepare ornament panel Handling of ornament panel Ornament panel shall not be placed face down or against wall, neitheron an uneven object.Don' t bend carelessly the swing flap, or, problem may occur. (1) Remove air inlet grill from ornament panel * Push in the b...
Page 34 - Install ornament panel on indoor unit.; Mounting on high ceiling
32 (1) 3. Install ornament panel on indoor unit. As shown in Fig . 7, match the position of swingflap motor with that of the indoor unit piping hole ,so that ormament panel can be placed on to indoorunit.Installation of ornament panelPlace the holding ring on swing flao motor sideteporarily on hooks...
