Haier A6-707- Manual

Page 2 - Contents; Water inlet hose; Packing list; Twin-tub washing machine

Contents Safety precautions Installation and adjustment Preparation before washing The musts in washing Usage of the detergent Washing sequence Disposal after washing Names of the parts The cover 2 Packing list Trouble-Shooting Answers to question Specification Water inlet hose Gland Lint filter Pac...

Page 3 - Meaning and description of the symbols; Warning sign; Names of the parts

1 Meaning and description of the symbols Warning sign Forbidding sign Contents marked with that symbol are related to the safety of the product and the personal safety of the users. Please operate in strict conformity to the contents, otherwise it may cause damage of the machine or injure the person...

Page 4 - Safety precautions

2 Safety precautions Please insert the power cord into special receptacle with rated vol-tage.Be sure to use single-phase three pins receptacle.The earthing terminal of the receptacle must be earthed reliably.If possible,please adopt electric leakage protector. When the machine is normallyusing, ple...

Page 6 - Installation and adjustment; Install the lint filter; The drainage shall be smooth with the drain hose.; Do not tramp or press the drain hose.

Overflow filter Lint filter If the extra hose is too long, cut it either at point A or B. <10cm B A > 30mm <1.5m 4 Installation and adjustment Please install and adjust the machine according to the requirement of the manual. It is very important to your security and correct operating the ma...

Page 7 - Extend the drain hose from the side of wash tub.

Install the water inlet hose; Select the water level Select water level according to thequantity of the laundries. Set the water level adjusting lever to needed line. Insert the water inlet hose into the water-fillingentrance on the control panel directly.(pull itout to dismantle it) Maximum Max. Mi...

Page 8 - Preparation before washing; Pay attention to followings before washing the laundries

Preparation before washing1.Connect the water inlet hose.2.Confirm that the washing machine is earthed reliably . Then insert the power plug into the receptacle. Do not connect the earth terminal to the gas pipe and tap water pipe.3.Put down the drain hose . 4.Slanting or uneven ground may result in...

Page 9 - The musts in washing; How to use the whitener; Usage of the detergent

The capacity of washing and spinning of the machine refer to the weight of the standard laundries under dry condition that can be washed or spinned in one time. Laundries quantity in one washing cycle shall be lower than the standard capacity. the largest capacity is only the loading capacityof the ...

Page 10 - Wash; Figure 5; Inlet selector

STANDARD STANDARD STRONG STRONG DRAIN DRAIN Washing sequence Wash Figure 5 Figure 4 2. Fill the water and add the dissolved washing powder to make the water level reach the preset position. (Figure 2) Run washing program for some time to stir and dissolve the powder completely. 3.Put in the laundrie...

Page 11 - Midway spinning

Inlet selector Midway spinning Push Push Proper Proper Outer cover of The spin tub Inner cover of The spin tub The laundries are slanting Gland No gland 1. Put the laundries into the spin tub evenly and smoothly. 2.Spin (2) Close the inner and outer cover of the spin tub. (3) Spin for 1-2 minutes. 3...

Page 12 - Rinsing; OVERFILL

10 Rinse with stored water Rinse with water-filing 1. Put the laundries into the wash tub. Select suitable current according to the laundries. 2. Fill water to preset water level. 3. Rinse Adjust the wash timer to 2-3 minutes to do rinsing. When the laundries quantity is few, please use "Soft...

Page 13 - Spinning

1. Put the laundries into the spin tub evenly and smoothly. 2. Press the gland in the tub properly. Close the inner and outer cover of the spin tub. 3. Spin Select suitable spin time according to the laundries, and do spinning. During spinning, if there's abnormal sound, it is generally owing to sla...

Page 14 - Cleaning the overflow filter; Elastic fixing; Cleaning the lint filter; Disposal after washing

After using, please clean the lint and eyewinker of the lint filter and overflow filter in time. Otherwise it may influence your using the machine.Please first pull off the power plug from the receptacle before cleaning. Take off the overflow filter. As indicated in the figure, nip the elastic fixin...

Page 15 - P u s h; Cleaning the; C l e a n i n g m e t h o d :

Cleaning the overflow filter 2. Take off the corrugation pipe. Dismantle the upper part of the corrugation pipe inside the overflow filter ( as indicated in Figure 1). 3. Cleaning the overflow filter Clean the lint around the filter and flush with tap water. 4. Install the overflow filter. (1).Insta...

Page 16 - protective cover; p r o t e c t i v e c ov e r; Wipe the complete unit with soft; Disposal of the complete unit; If the laundries fall to the outer side of the spin tub; Trouble-shooting Answers to question

3 . i ns t a l l t he a f t e r c l ea n i n g , i n st a l l i t as o ri g i n a ss u r e i t re l i a b l e p r o t e c t i v e c ov e r Cleaning the protective cover 2 . c le a n i n g d ir t y u n d e r t he t a k e ou t t he s un d r i e s u si n g t h e p li e r or o th e r w ir y p r o t e c ...

Page 17 - Phenomena; Specification; The reason

Trouble-shooting Answers to question (If there's breakdown, please pull off the power plug before checking) The following phenomena are not breakdowns sometimes. Please confirm again before sending it to repair. If there are real breakdowns, please come to the special maintenance department or after...

Table of Contents:

Other Manuals for Haier A6-707

Summary

Other Haier Models