Haier 0010554405B- User Manual
Haier 0010554405B– User Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
Table of Contents:
- Page 2 – Selection of Installation Place; Outdoor Unit
- Page 3 – the plate to the fixed mounting bar.; piping which is marked on heat insulation materials.; Indoor unit
- Page 4 – Connecting the indoor/outdoor Electric Cable
- Page 5 – Two ways for the installation of indoor part, as illustrated:
- Page 6 – Installation of Outdoor Unit; Outdoor unit
- Page 8 – Insert the flare nut; Power Source Installation; Check Items for Test Run; Flare tooling die
No.0010554405
B
Installation Manual of Room Air Conditioner
No.
Accessory parts
Remote controller
R-03 dry battery
Mounting plate
Drain hose
Steel nail, cement
Screw
Plastic cap
Drain-elbow
Cover
Cushion
Connecting cable
1
1
A
B
C
D
E
F
G
2
3
4
5
6
7
8
9
10
2
1
1
6
4
1
1
4
1
Number
of
articles
Accessory parts
Optional parts for piping
Mark
Parts name
more than 5cm
more than 10cm
more than 60cm
more than 15cm
Non-adhesive tape
The marks from to in the figure are the parts numbers.
The distance between the indoor unit and the floor should
be more than 2m.
more than 10cm
more than 10cm
more than 10cm
Adhesive tape
Saddle(L.S) with screws
Attention must be paid to
the rising up of drain hose
Arrangement of piping directions
Rear left
Rear
right
Left
Below
Right
Connecting electric cable
for indoor and outdoor
Drain hose
Heating insulating material
4X50
4X25
Piping hole cover
Read this manual before installation
1.Driver
2.Hacksaw
3.Hole core drill
4.Spanner(17,19 and 26mm)
5.Torque wrench(17mm,22mm,26mm)
6.Pipe cutter
7.Flaring tool
8.Knife
9.Nipper
12.Reamer
10.Gas leakage detector or
soap-and-water solution
11.Measuring tape
Explain sufficiently the operating means to the user
according to this manual.
A
G
Change for
fresh air box
Change for
fresh air
tube(suit)
Outlet joint
11
12
13
1
1
2
Screw
6
G
F
A
C
D
E
13
12
Note:1.Cooling only units don't have Drain-elbow
Outlet joint
1
2. is only for the models of 18,22.
3.The models ZF don't have fresh function
and accessory parts related with freshing.
Drawing for the installation of indoor and outdoor units
Necessary Tools for Installation
15
14
14
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
Summary
Fixing of outdoor unit Indoor Unit Selection of Installation Place Power Source Selection of pipe Outdoor Unit Fix the unit to concrete or block with bolts( 10mm) and nuts firmly and horizontally. When fitting the unit to wall surface, roof or rooftop, fix a supporter surely with nailsor wires in co...
Indoor unit 1.Fitting of the Mounting Plate and Positioning of the wall Hole 2.Making a Hole on the Wall and Fitting the Piping Hole Cover When the mounting plate is first fixed When the mounting plate is fixed side bar and lintel 1.Carry out, based on the neighboring pillars or lintels, a proper le...
Indoor unit 4.Connecting the indoor/outdoor Electric Cable Fixing the indoor unit body Removing the wiring cover [Other direction piping] Indoor/outdoor electric cable and drain hose must be bound with refrigerant piping by protecting tape. Cut away, with a nipper, the lid for piping according to th...
