Page 2 - Cautions
Before disposing an old air conditioner thatgoes out of use, please make sure it's inop-erative and safe. Unplug the air conditionerin order to avoid the risk of child entrapment. It must be noticed that air conditioner systemcontains refrigerants, which require speciali-zed waste disposal. The valu...
Page 4 - Safety Instruction; WARNING; CAUTION
Cautions STRICTENFORCEMENT Safety Instruction Installation WARNING Please read the following Safety Instructions carefully prior to use. The instructions are classified into two levels, WARNING and CAUTION according tothe seriousness of possible risks and damages as follows. Compliance to theinstruc...
Page 6 - Parts and Functions
1 2 3 4 Indoor unit Outdoor unit Parts and Functions 5 OUTLET CONNECTING PIPING AND ELECTRICAL WIRING INLET DRAIN HOSE Actual inlet grille may vary from the one shown in the manual according tothe product purchased Display board Inlet Anion generator Vertical flap (Use remote controller toadjust up ...
Page 9 - Operation; HEALTH operation
Operation Remote controller 8 STERILIZE 2.Health anion function Air conditioner starts health anion function operation. For twice press, disappears,the operation stops. BRIEF INTRODUCTION TO HEALTH ANION FUCTION The anion generator in the air conditioner can generate a lot ofanion effectively balanc...
Page 10 - Auto Operation
Auto Operation Operation Remote controller 9 STERILIZE About Auto OperationUnder the mode of auto operation, air conditioner willautomatically select Cool or Dry operation accordingto room temperature and setting temperature. 5.Unit stop Press ON/OFF button, the unit stops. 1. Unit start Press ON/OF...
Page 11 - Cool Operation
Cool Operation Remote controller 2.Select operation mode Press FAN button. For each press, fan speed changes asfollows: Press MODE button. For each press, operation modechanges as follows: Remote controller: Remote controller: Then Select COOL operation Press TEMP. button Every time the button is pr...
Page 12 - Dry Operation
2.Select operation mode Press FAN button. For each press, fan speed changes asfollows: Press MODE button. For each press, operation modechanges as follows: Remote controller: Remote controller: Then Select DRY operation Press TEMP. button Every time the button is pressed, temp.settingincrease 1 o C,...
Page 13 - Fan Operation
Fan Operation 2.Select operation mode Press FAN button. For each press, fan speed changes asfollows: Press MODE button. For each press, operation modechanges as follows: Remote controller: Remote controller: Then Select FAN operation 3.Fan speed selection 4.Unit stop About FAN operation In FAN opera...
Page 14 - Air Flow Direction Adjustment
2.Up and down air flow direction Vertical flap Pos.1 Pos.1 Pos.2 Pos.3 Pos.4 Pos.6 Pos.1 Pos.2 Pos.3 Pos.4 Pos.5 Pos.6 Pos.2 Pos.3 Pos.4 Pos.5 Pos.6 (Auto swing) For each press of button, air flow direction on remote controller displaysas follows according to different operation modes: remote contro...
Page 15 - Sleep Operation
If the wind speed is high or middle beforesetting for the sleep, set for lowing the windspeed after sleeping.If it is low wind, no change. 4.Set the wind speed change when sleeping Before going to bed, you can simply press theSLEEP button and unit will operate in SLEEPmode and bring you a sound slee...
Page 16 - Timer On/Off Operation
Remote Controller Timer On/Off Operation Operation Hints: After replacing batteries or a power failure happens, time setting should be reset. Remote controller possesses memory function, when use TIMER mode next time, just press SET button after mode selecting if time setting is the same as previous...
Page 17 - Timer On-Off Operation
Remote Controller Timer On-Off Operation Operation Just press TIMER button several times until TIMERmode disappears.According to the Time setting sequence of TIMER ONor TIMER OFF, either Start-Stop or Stop-Start can beachieved. Set clock correctly before starting TIMER operation.1. After unit starts...
Page 18 - Emergency and Test Operation; Removal of the restriction of emergency or test operation
Operation 19 When the remote controller is manipulated, it gets the system back to the normal operation mode. Emergency and Test Operation When machine is running in emergency, the set value of temperature and windspeed couldn't be altered; meanwhile, it can't operate for dehumidifying or undertimin...
Page 19 - For Smart Use of The Air Conditioner; Use the timer effectively; Maintenance; OFF
For Smart Use of The Air Conditioner Setting of proper roomtemperature Close doors and windowsduring operation If the unit is not to be usedfor a long time, turn off thepower supply main switch. Use the timer effectively Use the louvers effectively Do not block the air inletor outlet Maintenance Pro...
Page 20 - Air Filter cleaning; Open the inlet grille by pulling it upward.; Indoor Body
For Smart Use of The Air Conditioner WARNING Air Filter cleaning Open the inlet grille by pulling it upward. Remove the filter. Clean the filter. Attach the filter. Close the inlet grille. Push up the filter's center tab slightly until it is releasedfrom the stopper, and remove the filter downward. ...
Page 21 - Replacement of Air Purifying Filter
Maintenance Replacement of Air Purifying Filter 1.Open the lnlet Grille 2.Detach the standard air filter 3.Detach old Air Purifying Filter Detach old Air Purifying Filter 4.Attach old Air Purifying Filter 5.Attach the standard air filter (Necessary installation) 6.Close the Inlet Grille Close the Gr...
Page 22 - Put off the power supply cord.
To Keep Your Air conditioner in Good Conditionafter Season. Operate in cooling mode for 2-3 hours. Put off the power supply cord. Take out the batteries from thewireless remote controller. Cleaning the body. To prevent breeding mold or bad smell, be sure tooperate at the designated temperature or 30...
Page 23 - Before Setting in High season; Cleaning the standard air filter.
Before Setting in High season Cleaning the standard air filter. Connecting the earthing cable. Do not block the air inlet or outlet. Plug-in Caution Caution After brush away dust at the plug, insert theplug of the power supply cord into the outletcompletely.In case of suing exclusive circuitbreaker,...
Page 24 - Before asking for service, check the following first.; Trouble shooting
Is the air filter dirty? Normally it should becleaned every 15 days.Are there any obstacles before inlet and outlet?Is temperature set correctly?Are there some doors or windows left open?Is there any direct sunlight through thewindow during the cooling operation?(Usecurtain)Are there too much heat s...
