Graco 510 - Manual - manualsarea.com

Page 2 - Warning Symbol; WARNING; Caution Symbol; CAUTION

308438 2 Table of Contents Symbols 2 . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Warnings 3 . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . ...

Page 3 - INJECTION HAZARD; Pressure Relief Procedure; TOXIC FLUID HAZARD

308438 3 WARNING INJECTION HAZARD Spray from the gun, hose leaks or ruptured components can inject fluid into your body and cause anextremely serious injury, including the need for amputation. Splashing fluid in the eyes or on the skincan also cause serious injury. D Fluid injected into the skin mig...

Page 4 - FIRE AND EXPLOSION HAZARD; Ground the System; EQUIPMENT MISUSE HAZARD; Technical Data; RECOIL HAZARD

308438 4 WARNING FIRE AND EXPLOSION HAZARD Improper grounding, poor air ventilation, open flames or sparks can cause a hazardous condition andresult in fire or explosion and serious injury. D Ground the equipment and the object being sprayed. See Ground the System on page 6. D If there is any static...

Page 5 - Notes

Page 6 - Installation/Operation; System Requirements; FIRE OR; How to Use the Gun Trigger Safety

308438 6 Installation/Operation System Requirements WARNING INJECTION HAZARD Keep the wallet-sized warning card,provided with this gun, with the operatorat all times. The card contains important treatment information should an injection injuryoccur. Additional cards are available at no chargefrom Gr...

Page 8 - How to Operate the Gun; How to Adjust the Spray Pattern

308438 8 Installation/Operation How to Operate the Gun WARNING RECOIL HAZARD Due to the very high pressure, a strongrecoil action will occur when you triggerthe gun. If you are unprepared, your hand could be forced back toward your body or youcould lose your balance and fall, resulting in seri-ous i...

Page 9 - Care of the Spray Tip and Tip Guard

308438 9 Installation/Operation Care of the Spray Tip and Tip Guard WARNING INJECTION HAZARD To reduce the risk of injection orsplashing in the eyes or on the skin: D Do not place a hand, body or rag in front of thespray tip when cleaning or checking a cloggedtip. Point the gun toward the ground or ...

Page 10 - How to Flush the Gun

308438 10 Installation/Operation How to Flush the Gun WARNING To reduce the risk of serious injury, includingsplashing fluid in the eyes or on the skin, or staticelectric discharge when flushing: D Be sure the entire system, including flushingpails, are properly grounded. D Remove the tip guard and ...

Page 11 - How to Check the Gun Diffuser Operation

308438 11 Installation/Operation How to Check the Gun Diffuser Operation The Standard Needle and Seat Kit, 237398, has thenumber 090 stamped on the needle and seat. The seat does have a diffuser. The optional Non-diffused Needle and Seat Kit,237260, has the number 125 stamped on the needle and seat....

Page 12 - Service; Repair Notes; Disassembly

308438 12 Service WARNING INJECTION HAZARD To reduce the risk of an injection injury,follow the Pressure Relief Procedure on page 7 before checking or servicing the gun and whenever you are instructed to relievethe pressure. Repair Notes The needle and seat are available only as a kit whichincludes ...

Page 13 - Cleaning

308438 13 Service Fig. 10 1 22 15 03972 6. Loosen the setscrew (15). Pull the fluid housing (22)away from the gun body (1). See Fig. 10. Fig. 11 16 17 03973 7. While supporting the spring guide (16) to preventbending the needle, loosen the setscrews (17).Remove the spring guide (16). See Fig. 11. Fi...

Page 15 - Test the Gun Before Regular Use; Install the tip guard before regular use.

308438 15 Service Fig. 19 24 03971 7. Install the screws (24). See Fig. 19. 29 28 27 18 25 03970 Fig. 20 A B,16 8. Position the trigger (25) on the gun body. Insert thepivot pin (28) into the top hole (A) and secure withthe screw (29) on the other side. Place an e-clip(27) on one end of the trigger ...

Page 16 - Parts; Description

308438 16 Parts Part No. 236995, Series BModel 510 Airless Spray Gun 28 21 29 1 27 27 18 16 17 19 30 2a 2b 2c 2e 2d 22 24 25 8 15 20 03964 Ref.No. Part No. Description Qty. 1 237502 GUN BODY 1 2 237398 NEEDLE AND SEAT KIT includes items 2a–2e (parts not sold separately) stamped with the number 085 [...

Page 18 - Graco Standard Warranty; Graco Information

308438 18 Graco Standard Warranty Graco warrants all equipment manufactured by Graco and bearing its name to be free from defects in material and workmanship on thedate of sale to the original purchaser for use. With the exception of any special, extended, or limited warranty published by Graco,Grac...

Graco 510 - Manual

Table of Contents:

Summary

Other Graco Models