Goodman GME8 - Manual
Goodman GME8 – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
Table of Contents:
- Page 2 – PRODUCT IDENTIFICATION; SUPPLY; Brand; AIRFLO W
- Page 3 – All models are low NOx models.
- Page 4 – PRODUCT DESIGN; Left; General Operation; WARNING; III
- Page 5 – for servicing; High Altitude Derate; Pressure
- Page 6 – PRODUCT DIMENSIONS; UNI TS; All dimensions are in inches .
- Page 7 – All installas above 7,000 ft. require a pressure switch change.; Part Nu mb er
- Page 8 – A large array of Amana; • All CAPF coils have a CAUF equivalent.; PRO DUCT
- Page 9 – Filters can also be installed elsewhere in; Upflow Filters; Bottom Return; FURNACE INPUT
- Page 11 – FURNACE SPECIFICATIONS; MO DEL
- Page 12 – BLOWER PERFORMANCE SPECIFICATIONS; For most jobs, about 400 CFM per ton when cooling is desirable.; BL OW ER PERFORMANCE; Model
- Page 13 – TEM
- Page 14 – WIRING DIAGRAMS
- Page 16 – SCHEMATICS; TYPICAL SCHEMATIC
C
opyright ©2009-2010 Goodman Manufacturin
g Company, L.P.
RT6621020 Rev. 1
April 2010
GME8
33-3/8" 80% Gas Furnace
Upflow/Horizontal
•
Refer to current Service Manual RS6610004 for installation, operation, and troubleshooting information.
•
All safety information must be followed as provided in the Service Manual.
•
Refer to the appropriate Parts Catalog for part number information.
•
Model numbers listed on page 3.
C
US
®
TECHNICAL MANU
TECHNICAL MANU
TECHNICAL MANU
TECHNICAL MANU
TECHNICAL MANUAL
AL
AL
AL
AL
This manual is to be used by qualified, professionally trained HVAC technicians only.
Goodman does not assume any responsibility for property damage or personal injury due
to improper service procedures or services performed by an unqualified person.
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
Summary
PRODUCT IDENTIFICATION 2 The model and manufacturing number are used for positive identification of component parts used in manufacturing.Please use these numbers when requesting service or parts information. Installation and repair of this unitshould be performed ONLY by in-dividuals meeting the re...
PRODUCT IDENTIFICATION 3 The model and manufacturing number are used for positive identification of component parts used in manufacturing.Please use these numbers when requesting service or parts information. GME80703BXC* GME80905CXC* GME81155CXC* All models are low NOx models. The United States Env...
4 PRODUCT DESIGN NOTE: Gas furnaces with induced draft blowers draw products of combustion through a heat exchanger allowing,in some instances, common venting with natural draftappliances (i.e. water heaters). All installations must bevented in accordance with National Fuel Gas Code NFPA54/ANSI Z223...
