Goodman GKS9 - Manual
Goodman GKS9 – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
Table of Contents:
- Page 2 – PRODUCT IDENTIFICATION; K: Residential Upflow
- Page 4 – PRODUCT DESIGN; Left; High Altitude Derate; Pressure
- Page 5 – COMPONENT IDENTIFICATION
- Page 6 – performance issues and noise issues.; All dimensions are in inches.
- Page 7 – PRESSURE SWITCH TRIP POINTS AND USAGE CHART
- Page 9 – Coil Matches (for Goodman; A large array of Amana; PRO DUCT
- Page 10 – Filters can also be installed elsewhere in; Upflow Filters; Disposable Minimum Filter Area (in; Based on a 300 ft/min filter face velocity]; Permanent Minimum Filter Area (in; *Minimum filter area dictated by heating airflow requirement.; BOTTOM RETURN
- Page 11 – FURNACE SPECIFICATIONS; MUST; MODEL
- Page 12 – BLOWER PERFORMANCE SPECIFICATIONS; BLOWER PERFORMANCE
- Page 13 – MP
- Page 14 – WIRING DIAGRAMS
C
US
®
Copyright © 2006-2007, 2009 Goodman Manufacturing Company, L.P.
This manual is to be used by qualified, professionally trained HVAC technicians only. Goodman
does not assume any responsibility for property damage or personal injury due to improper
service procedures or services performed by an unqualified person.
•
Refer to Service Manual RS6610004* for installation, operation, and troubleshooting information.
•
All safety information must be followed as provided in the Service Manual.
•
Refer to the appropriate Parts Catalog for part number information.
•
Model numbers listed on page 3.
GKS9
40" 90% Gas Furnaces
®
RT6612017r2
June 2009
TECHNICAL MANU
TECHNICAL MANU
TECHNICAL MANU
TECHNICAL MANU
TECHNICAL MANUAL
AL
AL
AL
AL
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
Summary
PRODUCT IDENTIFICATION 2 Furnace Type S: Single Stage/Multi-Speed The model and manufacturing number are used for positive identification of component parts used in manufacturing. Whenengineering and manufacturing changes take place where interchangeability of components are affected, the manufactur...
4 PRODUCT DESIGN 2. Line voltage wiring can enter through the right or left side of the furnace. Low voltage wiring can enter through theright or left side of furnace. 3. Conversion kits for high altitude natural or propane gas operation are available. See High Altitude Derate chartfor details. 4. I...
5 COMPONENT IDENTIFICATION 1 Gas Valve 2 Gas Line Entrance (Alternate) 3 Combustion Air Intake Connection / “Coupling” 4 Hot Surface Igniter 5 Burners 6 Rollout Limit 7 Flame Sensor 8 Flue Pipe Connection / “Coupling” 9 Flue Pipe (Internal) 10 Primary Limit 11 Pressure Switch 12 Gas Line Entrance 13...
