Goodman GHS8 - Manual
Goodman GHS8 – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
Table of Contents:
- Page 2 – PRODUCT IDENTIFICATION; AIRFLOW DIRECTION; Brand; AIRFLOW
- Page 3 – * These models available in Low NOx
- Page 4 – PRODUCT DESIGN; for servicing; High Altitude Derate; Pressure; WARNING; III
- Page 5 – PRODUCT DIMENSIONS; MODEL
- Page 6 – RO LLO UT L IMI T SW IT CHES
- Page 7 – Presssure Sw itches; Part Number; PRI MARY L IMI T; Part Number; AUXI LIARY LIM IT SWI TCHES
- Page 8 – A large array of Amana; Coil Matches (for Goodman; PRO DUCT
- Page 9 – Upflow Filters; BOTTOM RETURN; Disposable Minimum Filter Area (in; Based on a 300 ft/min filter face velocity]; *Minimum filter area dictated by heating airflow requirement.; Permanent Minimum Filter Area (in
- Page 10 – Counterflow Filters; Filters can also be installed elsewhere
- Page 11 – FURNACE SPECIFICATIONS; MOD EL
- Page 13 – BLOWER PERFORMANCE SPECIFICATIONS; BLOW ER P ER FORMAN CE
- Page 14 – B LO WER PERFOR MANC E
- Page 15 – TEMPER
- Page 16 – WIRING DIAGRAMS
GDS8 & GHS8
33-3/8" 80% Gas Furnace Units
•
Refer to Service Manual RS6610004 for installation, operation, and troubleshooting information.
•
All safety information must be followed as provided in the Service Manual.
•
Refer to the appropriate Parts Catalog for part number information.
•
Model numbers listed on page 3.
RT6622011
September 2009
Copyright © 2005-2007 Goodman Manufacturing Company, L.P.
TECHNICAL MANU
TECHNICAL MANU
TECHNICAL MANU
TECHNICAL MANU
TECHNICAL MANUAL
AL
AL
AL
AL
Copyright © 2009 Goodman Manufacturing Company, L.P.
This manual is to be used by qualified, professionally trained HVAC technicians only.
Goodman does not assume any responsibility for property damage or personal injury
due to improper service procedures or services performed by an unqualified
person.
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
Summary
PRODUCT IDENTIFICATION 2 The model and manufacturing number are used for positive identification of component parts used in manufacturing. Pleaseuse these numbers when requesting service or parts information. Installation and repair of this unitshould be performed ONLY by individuals meeting the req...
3 PRODUCT IDENTIFICATION The model and manufacturing number are used for positive identification of component parts used in manufacturing.Please use these numbers when requesting service or parts information. * These models available in Low NOx The United States Environmental Protection Agency (“EPA...
4 PRODUCT DESIGN NFPA 54/ANSI Z223.1 - latest edition. In Canada, the fur-naces must be vented in accordance with the National Stan-dard of Canada, CAN/CSA B149.1 and CAN/CSA B149.2 -latest editions and amendments. NOTE: The vertical height of the Category I venting system must be at least as great ...
