GE ZSC1201SS Manual - Free PDF Download

Page 2 - Safety Information; CONTENTS; BEFORE YOU BEGIN; IMPORTANT; MODELS AVAILABLE

Safety Information 2 CONTENTS Design Information Models Available ......................................................................2Product Dimensions and Clearances ............................3Tools and Parts Required ....................................................3Parts Supplied ..........

Page 3 - Design Information; PRODUCT DIMENSIONS AND CLEARANCES

Design Information 3 PRODUCT DIMENSIONS AND CLEARANCES NOTE: Appearance will vary by model. 19 1/32” 29 3/4” TOOLS AND PARTS REQUIRED (NOT SUPPLIED ) • #2 Phillips screwdriver • Hand-held drill • High speed drill bit , 3/32 ″ diameter • 3/8 ″ slot-head screwdriver • Level • Saw • 2 x 4 or 2 x 2 lumb...

Page 4 - Installation Preparation; ELECTRICAL REQUIREMENTS; ELECTRICAL LOCATION

Installation Preparation 4 ELECTRICAL REQUIREMENTS Single Advantium 120 Installation: This product requires a 120-volt , 60 Hz, 15-amp circuitand draws 1.8 kilowatts. This product must beconnected to a supply circuit of the proper voltageand frequency. • Wire size must conform to the requirements of...

Page 5 - WITHOUT; an Accessory Storage Drawer; PREPARE THE OPENING

5 Installation Preparation Preparation WITHOUT an Accessory Storage Drawer PREPARE THE OPENING (cont .) Installation over a GE/Monogram Warming Drawer: NOTE: Additional clearances between the cutouts may be required. Check to be sure the oven supportsabove the Warming Drawer location do not obstruct...

Page 9 - WITH

9 Installation Preparation Preparation WITH an Accessory Storage Drawer NOTE: MODEL ZSC1201 CAN ONLY BE INSTALLED WITH AN ACCESSORY STORAGE DRAWER IF INSTALLED ABOVE 36-3/4 ″ . MODEL ZSC1202 CANNOT BE INSTALLED WITH AN ACCESSORY STORAGE DRAWER. SEE INSTALLATION PREPARATION WITHOUT AN ACCESSORY STORA...

Page 12 - Preparation

12 Installation Preparation Cooktop Cooktop 25 ″ 1-1/2 ″ Min. 4 ″ High Toekick 23-1/2 ″ 25-1/4 ″ 21 ″ 36 ″ Countertop Height PREPARE THE OPENING (cont .) Installation beside another GE/MonogramBuilt-in Speedcook Oven: • If you are mounting one Under-the-Counter GE/Monogram oven beside the other, use...

Page 13 - REMOVE THE PACKAGING AND PARTS; Installation Instructions

REMOVE THE PACKAGING AND PARTS 1 13 Installation Instructions • Remove all packing material and tape.• Locate parts package containing mounting screws.• Remove the oven from the carton. Do not lift unit by handle or conduit . Two people are required to liftthis oven. • Open the door and remove any p...

Page 14 - SLIDE THE OVEN INTO THE CUTOUT

Installation Instructions 14 SLIDE THE OVEN INTO THE CUTOUT CAUTION: Two people are required to lift the oven into the opening. Grasp the bottom at front and rear. DO NOT USE THE HANDLE TO LIFTTHE OVEN. DAMAGE WILL OCCUR. • Lift and hold the oven at the front of the opening. Hold the oven at an angl...

Page 15 - INSTALL MOUNTING SCREWS

15 Installation Instructions INSTALL MOUNTING SCREWS • Slide the oven the remaining way into the openingso that the side flanges and control panel areagainst the cabinet frame. Make sure that the ovenis centered in the opening. • Open the door, place a turntable tray in the ovenand make sure that th...

Page 16 - GE Consumer & Industrial Appliances; Assembly Instructions; Advantium; TOOLS REQUIRED; PARTS SUPPLIED

16 GE Consumer & Industrial Appliances Assembly Instructions Advantium ® Built-In Accessory Storage Drawer JX2200, JX2201, ZX2201 NOTE: Appearance will vary by model. BEFORE YOU BEGIN Read these instructions completely and carefully. Readthe Installation Instructions for the Advantium 120V or240...

Page 17 - REMOVE PACKAGING AND PARTS; ASSEMBLY TO ADVANTIUM BUILT-IN SPEEDCOOK OVEN; ASSEMBLING THE OVEN TO DRAWER

UNDER-THE-COUNTER (UTC)MOUNTING BRACKET INSTALLATION NOTE: For UTC models PSB1200, PSB1201 and ZSC1201 only. Open the accessory drawer so you haveaccess to the top bracket . Remove the three screws securing the topbracket . Install the new UTC mounting bracket usingthe screws removed previously. Clo...

Page 19 - Notes