GE PSB2200 Manual — Free PDF Download

Page 2 - Safety Information; CONTENTS; BEFORE YOU BEGIN; IMPORTANT; MODELS AVAILABLE

Safety Information 2 CONTENTS Design Information Models Available ......................................................................2Product Dimensions and Clearances ............................3Tools and Parts Required ....................................................3Parts Supplied ..........

Page 3 - PRODUCT DIMENSIONS AND CLEARANCES

Design Information 3 PRODUCT DIMENSIONS AND CLEARANCES NOTE: Appearance will vary by model. 13” 13/16” 21 1/2” 19 1/32” 29 3/4” TOOLS AND PARTS REQUIRED (NOT SUPPLIED ) #2 Phillips screwdriver Hand held drill High speed drill bit , 3/32 ″ diameter 3/8 ″ slot head screwdriver Level Saw ...

Page 4 - Installation Preparation; ELECTRICAL REQUIREMENTS; WARNING; INSTALL JUNCTION BOX

Installation Preparation 4 ELECTRICAL REQUIREMENTS Single Speedcook Installation Product rating is 120/208 or 120/240 volt , 60 Hz, 30 amps. This product must be connected to a supplycircuit of the proper voltage and frequency andprotected by a time delay fuse or circuit breaker. Power should be sup...

Page 5 - WITHOUT; an Accessory Storage Drawer; PREPARE THE OPENING

5 Installation Preparation Preparation WITHOUT an Accessory Storage Drawer PREPARE THE OPENING (CONT.) Installation over a GE/Monogram Warming Drawer: NOTE: Additional clearances between the cutouts may be required. Check to be sure the oven supportsabove the Warming Drawer location do not obstructt...

Page 7 - WITH

7 Installation Preparation Preparation WITH an Accessory Storage Drawer NOTE: MODEL ZSC2202 CANNOT BE INSTALLED WITH AN ACCESSORY STORAGE DRAWER. SEE INSTALLATION PREPARATIONWITHOUT AN ACCESSORY STORAGE DRAWER FOR THIS MODEL. Installation over a GE/Monogram Warming Drawer: * For existing cutouts, a ...

Page 9 - Installation Instructions; REMOVE THE PACKAGING AND PARTS

9 Installation Instructions • Remove all packing material and tape.• Locate parts package containing mounting screws.• Remove the oven from the carton. Do not lift unit by handle or conduit . Two people are required to liftthis oven. • Open the door and remove any packaging in oven. REMOVE THE PACKA...

Page 11 - INSTALL BOTTOM TRIM; INSTALL MOUNTING SCREWS; FINALIZE INSTALLATION

11 Installation Instructions INSTALL BOTTOM TRIM NOTE: If installing the Advantium 240 Oven with an accessory storage drawer, the bottom trim is notrequired. Proceed to Step 4. • Align bottom trim tabs to slots in the bottom of theoven. • Secure the bottom trim to the bottom of the ovenusing 3 brass...

Page 12 - Assembly Instructions; Advantium; TOOLS REQUIRED; PARTS SUPPLIED

NOTE: Appearance will vary by model. Assembly Instructions Advantium ® 240V Built-In Accessory Storage Drawer JX2200, JX2201, ZX2201 BEFORE YOU BEGIN Read these instructions completely and carefully. Readthe Installation Instructions for the Advantium 240V ovencompletely and carefully for cutout dim...

Page 13 - REMOVE PACKAGING AND PARTS; ASSEMBLY TO ADVANTIUM 240V BUILT-IN SPEEDCOOK OVEN; ASSEMBLING THE OVEN TO DRAWER

REMOVE PACKAGING AND PARTS • Remove the drawer from the carton.• Remove all packing material and tape.• Open the drawer and remove any parts inside.• Locate parts. 1 ASSEMBLY TO ADVANTIUM 240V BUILT-IN SPEEDCOOK OVEN Assembly Instructions Side Supports (2) Screws (2 Sets) ASSEMBLING THE OVEN TO DRAW...